The electrochemical process of microbial electrosynthesis (MES) is used to drive the metabolism of electroactive microorganisms for the production of valuable chemicals and fuels. MES combines the advantages of electrochemistry, engineering, and microbiology and offers alternative production processes based on renewable raw materials and regenerative energies. In addition to the reactor concept and electrode design, the biocatalysts used have a significant influence on the performance of MES. Thus, pure and mixed cultures can be used as biocatalysts. By using mixed cultures, interactions between organisms, such as the direct interspecies electron transfer (DIET) or syntrophic interactions, influence the performance in terms of productivity and the product range of MES. This review focuses on the comparison of pure and mixed cultures in microbial electrosynthesis. The performance indicators, such as productivities and coulombic efficiencies (CEs), for both procedural methods are discussed. Typical products in MES are methane and acetate, therefore these processes are the focus of this review. In general, most studies used mixed cultures as biocatalyst, as more advanced performance of mixed cultures has been seen for both products. When comparing pure and mixed cultures in equivalent experimental setups a 3-fold higher methane and a nearly 2-fold higher acetate production rate can be achieved in mixed cultures. However, studies of pure culture MES for methane production have shown some improvement through reactor optimization and operational mode reaching similar performance indicators as mixed culture MES. Overall, the review gives an overview of the advantages and disadvantages of using pure or mixed cultures in MES. Key points • Undefined mixed cultures dominate as inoculums for the MES of methane and acetate, which comprise a high potential of improvement • Under similar conditions, mixed cultures outperform pure cultures in MES • Understanding the role of single species in mixed culture MES is essential for future industrial applications

Electromethanogenesis is an interesting next-generation technology to produce methane from CO2 and electricity by using methanogens. Iron-corroding methanogens might be of special interest for that application due to their natural ability for electron uptake. Methanococcus maripaludis Mic1c10 and KA1 were tested in bioelectrochemical systems. Strain Mic1c10 showed a 120% higher current density and an 84% higher methane production rate (16.2 mmol m−2 d−2) than the non-corrosive strain Methanococcus maripaludis S2, which was identified earlier as the best methane producer under the same experimental conditions. Interestingly, strain KA1 also showed a 265% higher current density than strain S2. Deposits at the cathodes were detected and analyzed, which were not described earlier. A comparative genome analysis between the corrosive methanogen and the S2 strain enables new insights into proteins that are involved in enhanced electron transfer.