No abstract

The syntheses of five homoleptic copper(I) complexes [CuL2][PF6] are described in which L is a 4,4'-di(4-bromophenyl)-6,6'-dialkyl-2,2'-bipyridine ligand (compounds 1-4 with methyl, (n)butyl, (iso)butyl and hexyl substituents, respectively) or 4,4'-di(4-bromophenyl)-6,6'-diphenyl-2,2'-bipyridine (5). The new ligands 2-5 and copper(I) complexes [CuL2][PF6] (L = 1-5) have been fully characterized. The single crystal structures of 2{[Cu(1)2][PF6]}·3Me2CO, [Cu(2)2][PF6], 2{[Cu(3)2][PF6]}·Et2O and [Cu(5)2][PF6]·CH2Cl2 have been determined. The first three structures show similar distorted tetrahedral environments for the Cu(+) ions with angles between the least squares planes of the bpy domains of 85.6, 86.4 and 82.9°, respectively; in contrast, the Cu(+) ion in [Cu(5)2][PF6]·CH2Cl2 is in a flattened coordinate environment due to intra-cation face-to-face π-interactions. The solution absorption spectra of the complexes with ligands 1-4 are virtually identical with an MLCT band with values of λmax = 481-488 nm. In contrast, the absorption spectrum of [Cu(5)2][PF6] shows two broad bands in the visible region. Cyclic voltammetric data show that oxidation of the copper(I) centre occurs at a more positive potential in [Cu(2)2][PF6], [Cu(3)2][PF6] and [Cu(4)2][PF6] than in [Cu(1)2][PF6] or [Cu(5)2][PF6] with the latter being oxidized at the lowest potential. The complexes have been used to prepare dye-sensitized solar cells (DSCs) incorporating heteroleptic dyes of type [Cu(L)(Lanchor)](+) where L is 1-5 and Lanchor is a 6,6'-dimethyl-2,2'-bipyridine functionalized in the 4- and 4'-positions with phosphonic acid groups with (Lanchor = 7) and without (Lanchor = 6) a spacer between the metal-binding and anchoring domains. The presence of the spacer results in enhanced performances of the dyes, and the highest energy conversion efficiencies are observed for the dyes [Cu(3)(7)](+) (η = 2.43% compared to 5.96% for standard dye N719) and [Cu(5)(7)](+) (η = 2.89% compared to 5.96% for N719). Measurements taken periodically over the course of a week indicate that the cells undergo a ripening process (most clearly seen for [Cu(5)(6)](+) and [Cu(5)(7)](+)) before their optimum performances are achieved. IPCE (EQE) data are presented and confirm that, although the photo-to-current conversions are promising (37-49% for λmax≈ 480 nm), the copper(I) dyes do not realize the broad spectral response exhibited by N719.

6-(1-Methylpyrrol-2-yl)-2,2'-bipyridine, 3, and 6-(selenophene-2-yl)-2,2'-bipyridine, 4, have been prepared and characterized in solution and by structural determinations. Copper(I) complexes [CuL(2)][PF(6)] in which L is 2,2'-bipyridine substituted in the 6-position by furyl, thienyl, N-methylpyrrolyl, selenopheneyl, methyl or phenyl, (L = 1-6) have been synthesized. The complexes have been characterized by electrospray mass spectrometry, and solution NMR and UV-VIS spectroscopies. The single crystal structures of [Cu(1)(2)][PF(6)], [Cu(2)(2)][PF(6)], [Cu(3)(2)][PF(6)], [Cu(5)(2)][PF(6)] and [Cu(6)(2)][PF(6)] have been determined. In those compounds containing an aromatic substituent attached to the bpy unit, the substituent is twisted with respect to the latter. In [Cu(3)(2)][PF(6)] and [Cu(5)(2)][PF(6)], this results in intra-cation π-stacking between ligands which is very efficient in [Cu(3)(2)](+) despite the steric requirements of the N-methyl substituents. Face-to-face stacking between the ligands in the [Cu(2)(2)](+) ion is achieved by complementary substituent twisting and elongation of one Cu-N bond, but there is no analogous intra-cation π-stacking in [Cu(1)(2)](+). Ligand exchange reactions between [CuL(2)][PF(6)] (L = 1-6) and TiO(2)-anchored ligands 7-10 (L' = 2,2'-bipyridine-based ligands with CO(2)H or PO(OH)(2) anchoring groups) have been applied to produce 24 surface-anchored heteroleptic copper(i) complexes, the formation of which has been evidenced by using MALDI-TOF mass spectrometry and thin layer solid state diffuse reflectance electronic absorption spectroscopy. The efficiencies of the complexes as dyes in DSCs have been measured, and the best efficiencies are observed for [CuLL'] with L' = 10 which contains phosphonate anchoring groups.

The structures and properties of the homoleptic copper(I) complexes [Cu(1)(2)][PF(6)] and [Cu(2)(2)][PF(6)] (1 = 6,6'-dimethyl-2,2'-bipyridine, 2 = 6,6'-bis{2-[4-(N,N'-diphenylamino)phenyl]ethenyl}-2,2'-bipyridine) are compared, and a strategy of ligand exchange in solution has been used to prepare eight TiO(2) surface-bound heteroleptic complexes incorporating ligands with bpy metal-binding domains and carboxylate or phosphonate anchoring groups. The presence of the extended π-system in 2 significantly improves dye performance, and the most efficient sensitizers are those with phosphonate or phenyl-4-carboxylate anchoring units; a combination of [Cu(2)(2)](+) with the phosphonate anchoring ligand gives a very promising performance (η = 2.35% compared to 7.29% for standard dye N719 under the same conditions). The high-energy bands in the electronic absorption spectrum of [Cu(2)(2)](+) which arise from ligand-based transitions dominate the spectrum, whereas that of [Cu(1)(2)](+) exhibits both MLCT and ligand π* ← π bands. Both [Cu(1)(2)][PF(6)] and [Cu(2)(2)][PF(6)] are redox active; while the former exhibits both copper-centred and ligand-based processes, [Cu(2)(2)][PF(6)] shows only ligand-based reductions. Results of TD-DFT calculations support these experimental data. They predict an electronic absorption spectrum for [Cu(1)(2)](+) with an MLCT band and high-energy ligand-based transitions, and a spectrum for [Cu(2)(2)](+) comprising transitions involving mainly contributions from orbitals with ligand 2 character. We have assessed the effects of the atomic orbital basis set on the calculated absorption spectrum of [Cu(1)(2)](+) and show that a realistic spectrum is obtained by using a 6-311++G** basis set on all atoms, or 6-311++G** on copper and 6-31G* basis set on all other atoms; a smaller basis set on copper leads to unsatisfactory results. Electronic absorption spectra of six heteroleptic complexes have been predicted using TD-DFT calculations, and the transitions making up the dominant bands analysed in terms of the character of the HOMO-LUMO manifold. The calculational data reveal dominant phosphonate ligand character in the LUMO for the dye found to function most efficiently in practice, and also reveal that the orbital character in the HOMOs of the two most efficient dyes is dominated by the non-anchoring ligand 2, suggesting that ligand 2 enhances the performance of the sensitizer by minimizing back-migration of an electron from the semiconductor to the dye.

Ligands containing first and second generation hole-transport triphenylamino-dendrons have been evaluated as ancillary ligands in copper(I) DSCs yielding an optimal efficiency of 3.77% in unmasked cells. The effects of masking the DSCs on measured parameters are discussed.