In this paper, the properties of powder metallurgy produced samples of GO reinforced aluminium composites were examined. Discs of 20 mm diameter and 0.5 mm thickness were made from pure Al powder of 35 µm particle size and with GO reinforcement at different GO wt% (0.05, 0.1 and 0.2). The mixture of Al/GO powders prepared through liquid infiltration were cold compacted and then sintered. The GO reinforced Al matrix composites were characterised using the scanning electron microscope with energy dispersion spectroscopy (SEM/EDX) for investigation of the homogeneous dispersion of GO into the matrix. X-ray diffraction (XRD) analysis for crystallographic phase and micro-Raman spectroscopy was used to identify the phases inside the composite matrix after the sintering process. Micro hardness and the strength values from the produced Al/GO composites were recorded. It is evident from the results obtained that where uniform mixing is achieved, GO reinforced Al composites can be produced with similar hardness values as for those produced from rGO reinforced Al composites.
Estimating the effect of graphene oxide (GO) reinforcement on overall properties of aluminum (Al) matrix composites experimentally is time-consuming and involves high manufacturing costs and sophisticated characterizations. An attempt was made in this paper to predict the mechanical properties of GO/Al composites by using a micromechanical finite element approach. The materials used for prediction included monolayer and multilayer GO layers distributed uniformly on the spherical Al matrix particles. The estimation was done by assuming that a representative volumetric element (RVE) represents the composite structure, and reinforcement and matrix were modeled as continuum. The load transfer between the GO reinforcement and Al was modeled using joint elements that connect the two materials. The numerical results from the finite element model were compared with Voigt model and experimental results from the GO/Al composites produced at optimized process parameters. A good agreement of numerical results with the theoretical models was noted. The load-bearing capacity of the Al matrix increased with the addition of GO layers, however, Young’s modulus of the GO/Al composites decreased with an increase in the number of layers from monolayer to 5 layers. The numerical results presented in this paper have demonstrated the applicability of the current approach for predicting the overall properties of composites.
The production of graphene reinforced aluminum matrix composite through powder metallurgical route requires optimization of process parameters to obtain better performance characteristics. One of the advanced method available for statistical analysis of parameters is Response Surface Methodology (RSM). The statistical analysis was carried out with three parameters, weight percentage of graphene reinforcement Wg (0.05%, 0.1% and 0.2%), stirring time ST(1h, 2h and 3h) and compaction pressure Pc(16T, 17T and 19T) while sintering temperature T kept constant. The performance of the Box Behnken design was analyzed and optimized using Design Expert software for the effective production of composites. From the results obtained from the analysis, the best set of parameters were considered for the future production of composites.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.