No abstract

A penny saved is a penny earned: The use of propylene carbonate as the solvent in iridium‐catalyzed hydrogenations of nonfunctionalized olefins allows efficient catalyst recycling through the formation of two‐phase mixtures with nonpolar solvents such as n‐hexane. In the picture, the hydrogenated tetrahydronaphthalene derivative is extracted into the hydrocarbon phase.

Carbon dioxide can be used in various ways as a cheap C1 source. However, the utilization of CO2 requires energy or energy-rich reagents, which leads to further emissions, and therefore, diminishes the CO2-saving potential. Therefore, life cycle assessment (LCA) is required for each process that uses CO2 to provide valid data for CO2 savings. Carbon dioxide can be incorporated into epoxidized fatty acid esters to provide the corresponding carbonates. A robust catalytic process was developed based on simple halide salts in combination with a phase-transfer catalyst. The CO2-saving potential was determined by comparing the carbonates as a plasticizer with an established phthalate-based plasticizer. Although CO2 savings of up to 80 % were achieved, most of the savings arose from indirect effects and not from CO2 utilization. Furthermore, other categories have been analyzed in the LCA. The use of biobased material has a variety of impacts on categories such as eutrophication and marine toxicity. Therefore, the benefits of biobased materials have to be evaluated carefully for each case. Finally, interesting properties as plasticizers were obtained with the carbonates. The volatility and water extraction could be improved relative to the epoxidized system.

Taking Control! The binary catalyst system composed of MoO3 and an organic phoshponium salt [Bu4P]X proved very efficient to produce oleochemical cyclic carbonates from renewables.

No abstract

A new robust palladium/phosphine catalyst system for the selective monoarylation of ammonia with different aryl bromides and chlorides has been developed. The active catalyst is formed in situ from [Pd(OAc)(2)] and air- and moisture-stable phosphines as easy-to-handle pre-catalysts. The productivity of the catalyst system is comparable to that of competitive Pd/phosphine systems; full conversion is achieved with most substrates with 1-2 mol % of Pd source and a fourfold excess of ligand (L).

With regard to sustainability, carbon dioxide (CO2) is an attractive C1 building block. However, due to thermodynamic restrictions, reactions incorporating CO2 are relatively limited so far. One of the so-called "dream reactions" in this field is the catalytic oxidative coupling of CO2 and ethene and subsequent β-H elimination to form acrylic acid. This reaction has been studied intensely for decades. However up to this date no suitable catalytic process has been established. Here we show that the catalytic conversion of ethene and CO2 to acrylate is possible in the presence of a homogeneous nickel catalyst in combination with a "hard" Lewis acid. For the first time, catalytic conversion of CO2 and ethene to acrylate with turnover numbers (TON) of up to 21 was demonstrated.

The phenol countdown: Novel imidazole‐based phosphine ligands are synthesized on scales up to 100 g by a convenient lithiation–phosphorylation method. The phosphines are stable towards air and moisture and are successfully applied as ligands in the palladium‐catalyzed selective hydroxylation of aryl halides (see scheme, dba=dibenzylideneacetone).