The wind industry needs airfoil data for ranges of Angle of Attack (AoA) much wider than those of aviation applications, since large portions of the blades may operate in stalled conditions for a significant part of their lives. Vertical axis wind turbines (VAWTs) are even more affected by this need, since data sets across the full incidence range of 180 degree are necessary for a correct performance prediction at different tip-speed ratios. However, the relevant technical literature lacks data in deep and post stall regions for nearly every airfoil. Within this context, the present study shows experimental and numerical results for the well-known NACA 0021 airfoil, which is often used for Darrieus VAWT design. Experimental data were obtained through dedicated wind tunnel measurements of a NACA 0021 airfoil with surface pressure taps, which provided further insight into the pressure coefficient distribution across a wide range of AoAs. The measurements were conducted at two different Reynolds numbers (Re = 140k and Re = 180k): each experiment was performed multiple times to ensure repeatability. Dynamic AoA changes were also investigated at multiple reduced frequencies. Moreover, dedicated unsteady numerical simulations were carried out on the same airfoil shape to reproduce both the static polars of the airfoil and some relevant dynamic AoA variation cycles tested in the experiments. The solved flow field was then exploited both to get further insight into the flow mechanisms highlighted by the wind tunnel tests and to provide correction factors to discard the influence of the experimental apparatus, making experiments representative of open-field behaviour. The present study is then thought to provide the scientific community with high quality, low-Reynolds airfoil data, which may enable in the near future a more effective design of Darrieus VAWTs.
The wind industry needs airfoil data for ranges of angle of attack (AoA) much wider than those of aviation applications, since large portions of the blades may operate in stalled conditions for a significant part of their lives. Vertical axis wind turbines (VAWTs) are even more affected by this need, since data sets across the full incidence range of 180 deg are necessary for a correct performance prediction at different tip-speed ratios. However, the relevant technical literature lacks data in deep and poststall regions for nearly every airfoil. Within this context, the present study shows experimental and numerical results for the well-known NACA 0021 airfoil, which is often used for Darrieus VAWT design. Experimental data were obtained through dedicated wind tunnel measurements of a NACA 0021 airfoil with surface pressure taps, which provided further insight into the pressure coefficient distribution across a wide range of AoAs. The measurements were conducted at two different Reynolds numbers (Re = 140 k and Re = 180 k): each experiment was performed multiple times to ensure repeatability. Dynamic AoA changes were also investigated at multiple reduced frequencies. Moreover, dedicated unsteady numerical simulations were carried out on the same airfoil shape to reproduce both the static polars of the airfoil and some relevant dynamic AoA variation cycles tested in the experiments. The solved flow field was then exploited both to get further insight into the flow mechanisms highlighted by the wind tunnel tests and to provide correction factors to discard the influence of the experimental apparatus, making experiments representative of open-field behavior. The present study is then thought to provide the scientific community with high quality, low-Reynolds airfoil data, which may enable in the near future a more effective design of Darrieus VAWTs.
The wind industry needs reliable and accurate airfoil polars to properly predict wind turbine performance, especially during the initial design phase. Medium- and low-fidelity simulations directly depend on the accuracy of the airfoil data and even more so if, e.g., dynamic effects are modeled. This becomes crucial if the blades of a turbine operate under stalled conditions for a significant part of the turbine's lifetime. In addition, the design process of vertical axis wind turbines needs data across the full range of angles of attack between 0 and 180 deg. Lift, drag, and surface pressure distributions of a NACA 0021 airfoil equipped with surface pressure taps were investigated based on time-resolved pressure measurements. The present study discusses full range static polars and several dynamic sinusoidal pitching configurations covering two Reynolds numbers Re = 140k and 180k, and different incidence ranges: near stall, poststall, and deep stall. Various bistable flow phenomena are discussed based on high frequency measurements revealing large lift-fluctuations in the post and deep stall regime that exceed the maximum lift of the static polars and are not captured by averaged measurements. Detailed surface pressure distributions are discussed to provide further insight into the flow conditions and pressure development during dynamic motion. The experimental data provided within the present paper are dedicated to the scientific community for calibration and reference purposes, which in the future may lead to higher accuracy in performance predictions during the design process of wind turbines.
Wind turbine industry has a special need for accurate post stall airfoil data. While literature often covers incidence ranges [−10deg,+25deg] smaller machines experience a range of up to 90 deg for horizontal axis and up to 360 deg for vertical axis wind turbines (VAWTs). The post stall data of airfoils is crucial to improve the prediction of the start-up behavior as well as the performance at low tip speed ratios. The present paper analyzes and discusses the performance of the symmetrical NACA 0021 airfoil at three Reynolds numbers (Re = 100k, 140k, and 180k) through 180 deg incidence. The typical problem of blockage within a wind tunnel was avoided using an open test section. The experiments were conducted in terms of surface pressure distribution over the airfoil for a tripped and a baseline configuration. The pressure was used to gain lift, pressure drag, moment data. Further investigations with positive and negative pitching revealed a second hysteresis loop in the deep post stall region resulting in a difference of 0.2 in moment coefficient and 0.5 in lift.
Wind turbine industry has a special need for accurate post stall airfoil data. While literature often covers incidence ranges [−10 deg, +25 deg], smaller machines experience a range of up to 90 deg for horizontal axis and up to 360 deg for vertical axis wind turbines (VAWTs). The post stall data of airfoils is crucial to improve the prediction of the start-up behavior as well as the performance at low tip speed ratios. The present paper analyzes and discusses the performance of the symmetrical NACA 0021 airfoil at three Reynolds numbers (Re = 100 k, 140 k, and 180 k) through 180 deg incidence. The typical problem of blockage within a wind tunnel was avoided using an open test section. The experiments were conducted in terms of surface pressure distribution over the airfoil for a tripped and a baseline configuration. The pressure was used to gain lift, pressure drag, moment data. Further investigations with positive and negative pitching revealed a second hysteresis loop in the deep post stall region resulting in a difference of 0.2 in moment coefficient and 0.5 in lift.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.