In hydrogenases and many other redox enzymes, the buried active site is connected to the solvent by a molecular channel whose structure may determine the enzyme's selectivity with respect to substrate and inhibitors. The role of these channels has been addressed using crystallography and molecular dynamics, but kinetic data are scarce. Using protein film voltammetry, we determined and then compared the rates of inhibition by CO and O2 in ten NiFe hydrogenase mutants and two FeFe hydrogenases. We found that the rate of inhibition by CO is a good proxy of the rate of diffusion of O2 toward the active site. Modifying amino acids whose side chains point inside the tunnel can slow this rate by orders of magnitude. We quantitatively define the relations between diffusion, the Michaelis constant for H2 and rates of inhibition, and we demonstrate that certain enzymes are slowly inactivated by O2 because access to the active site is slow.

Hydrogenases, which catalyze H2 to H ؉ conversion as part of the bioenergetic metabolism of many microorganisms, are among the metalloenzymes for which a gas-substrate tunnel has been described by using crystallography and molecular dynamics. However, the correlation between protein structure and gas-diffusion kinetics is unexplored. Here, we introduce two quantitative methods for probing the rates of diffusion within hydrogenases. One uses protein film voltammetry to resolve the kinetics of binding and release of the competitive inhibitor CO; the other is based on interpreting the yield in the isotope exchange assay. We study structurally characterized mutants of a NiFe hydrogenase, and we show that two mutations, which significantly narrow the tunnel near the entrance of the catalytic center, decrease the rates of diffusion of CO and H2 toward and from the active site by up to 2 orders of magnitude. This proves the existence of a functional channel, which matches the hydrophobic cavity found in the crystal. However, the changes in diffusion rates do not fully correlate with the obstruction induced by the mutation and deduced from the x-ray structures. Our results demonstrate the necessity of measuring diffusion rates and emphasize the role of side-chain dynamics in determining these.crystallography ͉ structure/function relationships ͉ substrate tunnel ͉ protein film voltammetry ͉ isotope exchange

Kinetic, EPR, and Fourier transform infrared spectroscopic analysis of Desulfovibrio fructosovorans [NiFe]hydrogenase mutants targeted to Glu-25 indicated that this amino acid participates in proton transfer between the active site and the protein surface during the catalytic cycle. Replacement of that glutamic residue by a glutamine did not modify the spectroscopic properties of the enzyme but cancelled the catalytic activity except the para-H 2 /ortho-H 2 conversion. This mutation impaired the fast proton transfer from the active site that allows high turnover numbers for the oxidation of hydrogen. Replacement of the glutamic residue by the shorter aspartic acid slowed down this proton transfer, causing a significant decrease of H 2 oxidation and hydrogen isotope exchange activities, but did not change the para-H 2 /ortho-H 2 conversion activity. The spectroscopic properties of this mutant were totally different, especially in the reduced state in which a non-photosensitive nickel EPR spectrum was obtained.Many microorganisms use molecular hydrogen in their metabolic routes as an energy source or for evacuating an excess of electrons. The enzymes that catalyze reversibly the conversion of molecular hydrogen to two electrons and two protons are known as hydrogenases. Although this is the simplest chemical reaction, the catalytic mechanism of these enzymes is quite complicated, and its details are still a matter of debate (1). Hydrogen isotope exchange experiments indicate that the H 2 cleavage reaction is heterolytic; thus, a hydride and a proton are formed in the first step (2, 3). In the second step, the two electrons of the hydride are extracted, and a second proton is formed. Subsequently, the two electrons have to be transported, via the intramolecular electron transfer chain, from the active site to the redox partner of the hydrogenase (a redox protein or NAD ϩ (P)) in vivo, or a redox dye in vitro; the two protons have to be transferred to the protein environment as well. These steps are reversed in the case of H 2 production activity (1).How do all these steps take place in hydrogenases? These proteins are metalloenzymes that all contain iron, and in many cases, also nickel. The crystallographic structures of several [Fe] hydrogenases (4, 5) and [NiFe] hydrogenases (6, 7) have been obtained by x-ray diffraction studies. In both types of enzymes, the active site is a deeply buried bimetallic center, in which the metals are bridged by thiol groups and have CO and CN Ϫ as ligands. This type of coordination favors the binding of molecular hydrogen or hydride to the active site (1, 8). The crystal structures also indicate that Fe-S clusters are located between the active site and the protein surface, which are thought to form the intramolecular electron pathway in the H 2 production/oxidation mechanism (9). In [NiFe] hydrogenases, one nickel and one iron atom form the bimetallic center. The nickel is coordinated to four cysteine ligands via their thiol groups. Two of them are terminal ligands, and the other...

Genes potentially coding for three distinct [NiFe] hydrogenases are present in the genome of Aquifex aeolicus. We have demonstrated that all three hydrogenases are expressed under standard growth conditions of the organism. Two hydrogenases were further purified to homogeneity. A periplasmically oriented hydrogenase was obtained in two forms, i.e., as a soluble enzyme containing only the two essential subunits and as a detergent-solubilized complex additionally containing a membrane-integral b-type cytochrome. The second hydrogenase purified was identified as a soluble cytoplasmic enzyme. The isolated enzymes were characterized with respect to biochemical/biophysical parameters, activity, thermostability, and substrate specificity. The phylogenetic positioning of all three hydrogenases was analyzed. A model for the metabolic roles of the three enzymes is proposed on the basis of the obtained results.

Surprisingly uninhibited: The inhibition of hydrogenases by oxygen is intensely studied because this is the main obstacle to using these enzymes in biofuel cells. The hydrogenase from Clostridium acetobutylicum (see structure) was found to react surprisingly slowly with O2. The inhibition mechanism was elucidated and the kinetics were quantitatively defined. This is a prerequisite for improving the enzyme further by genetic engineering and for assessing its potential in technological devices.

Hydrogenases catalyze the conversion between 2H(+) + 2e(-) and H(2)(1). Most of these enzymes are inhibited by O(2), which represents a major drawback for their use in biotechnological applications. Improving hydrogenase O(2) tolerance is therefore a major contemporary challenge to allow the implementation of a sustainable hydrogen economy. We succeeded in improving O(2) tolerance, which we define here as the ability of the enzyme to resist for several minutes to O(2) exposure, by substituting with methionines small hydrophobic residues strongly conserved in the gas channel. Remarkably, the mutated enzymes remained active in the presence of an O(2) concentration close to that found in aerobic solutions in equilibrium with air, while the wild type enzyme is inhibited in a few seconds. Crystallographic and spectroscopic studies showed that the structure and the chemistry at the active site are not affected by the mutations. Kinetic studies demonstrated that the inactivation is slower and reactivation faster in these mutants. We propose that in addition to restricting O(2) diffusion to the active site of the enzyme, methionine may also interact with bound peroxide and provide an assisted escape route for H(2)O(2) toward the gas channel. These results show for the first time that it is possible to improve O(2)-tolerance of [NiFe] hydrogenases, making possible the development of biohydrogen production systems.

Hydrogenases are efficient biological catalysts of H(2) oxidation and production. Most of them are inhibited by O(2), and a prerequisite for their use in biotechnological applications under air is to improve their oxygen tolerance. We have previously shown that exchanging the residue at position 74 in the large subunit of the oxygen-sensitive [NiFe] hydrogenase from Desulfovibrio fructosovorans could impact the reaction of the enzyme with O(2) (Dementin, S.; J. Am. Chem. Soc. 2009, 131, 10156-10164; Liebgott, P. P.; Nat. Chem. Biol. 2010, 6, 63-70). This residue, a valine in the wild-type enzyme, located at the bottleneck of the gas channel near the active site, has here been exchanged with a cysteine. A thorough characterization using a combination of kinetic, spectroscopic (EPR, FTIR), and electrochemical studies demonstrates that the V74C mutant has features of the naturally occurring oxygen-tolerant membrane-bound hydrogenases (MBH). The mutant is functional during several minutes under O(2), has impaired H(2)-production activity, and has a weaker affinity for CO than the WT. Upon exposure to O(2), it is converted into the more easily reactivatable inactive form, Ni-B, and this inactive state reactivates about 20 times faster than in the WT enzyme. Control experiments carried out with the V74S and V74N mutants indicate that protonation of the position 74 residue is not the reason the mutants reactivate faster than the WT enzyme. The electrochemical behavior of the V74C mutant toward O(2) is intermediate between that of the WT enzyme from D. fructosovorans and the oxygen-tolerant MBH from Aquifex aeolicus.

Enzymes of the DMSO reductase family use a mononuclear Mo-bis(molybdopterin) cofactor (MoCo) to catalyze a variety of oxo-transfer reactions. Much functional information on nitrate reductase, one of the most studied members of this family, has been gained from EPR spectroscopy, but this technique is not always conclusive because the signature of the MoCo is heterogeneous, and which signals correspond to active species is still unsure. We used site-directed mutagenesis, EPR and protein film voltammetry to demonstrate that the MoCo in R. sphaeroides periplasmic nitrate reductase (NapAB) is subject to an irreversible reductive activation process whose kinetics we precisely define. This activation quantitatively correlates with the disappearance of the so-called "Mo(V) high-g" EPR signal, but this reductive process is too slow to be part of the normal catalytic cycle. Therefore, in NapAB, this most intense and most commonly observed signature of the MoCo arises from a dead-end, inactive state that gives a catalytically competent species only after reduction. This activation proceeds, even without substrate, according to a reduction followed by an irreversible nonredox step, both of which are pH independent. An apparently similar process occurs in other nitrate reductases (both assimilatory and membrane bound), and this also recalls the redox cycling procedure, which activates periplasmic DMSO reductases and simplifies their spectroscopic signatures. Hence we propose that heterogeneity at the active site and reductive activation are common properties of enzymes from the DMSO reductase family. Regarding NapAB, the fact that we could detect no Mo EPR signal upon reoxidizing the fully reduced enzyme suggests that the catalytically active form of the Mo(V) is thermodynamically unstable, as is the case for other enzymes of the DMSO reductase family. Our original approach, which combines spectroscopy and protein film voltammetry, proves useful for discriminating the forms of the active site on the basis of their catalytic properties. This could be applied to other enzymes for which the question arises as to the catalytic relevance of certain long-lived, spectroscopically characterized species.