The plant cuticle consists of cutin, a polyester of glycerol, hydroxyl, and epoxy fatty acids, covered and filled by waxes. While the biosynthesis of cutin building blocks is well documented, the mechanisms underlining their extracellular deposition remain unknown. Among the proteins extracted from dewaxed tomato (Solanum lycopersicum) peels, we identified GDSL1, a member of the GDSL esterase/acylhydrolase family of plant proteins. GDSL1 is strongly expressed in the epidermis of growing fruit. In GDSL1-silenced tomato lines, we observed a significant reduction in fruit cuticle thickness and a decrease in cutin monomer content proportional to the level of GDSL1 silencing. A significant decrease of wax load was observed only for cuticles of the severely silenced transgenic line. Fourier transform infrared (FTIR) analysis of isolated cutins revealed a reduction in cutin density in silenced lines. Indeed, FTIR-attenuated total reflectance spectroscopy and atomic force microscopy imaging showed that drastic GDSL1 silencing leads to a reduction in ester bond cross-links and to the appearance of nanopores in tomato cutins. Furthermore, immunolabeling experiments attested that GDSL1 is essentially entrapped in the cuticle proper and cuticle layer. These results suggest that GDSL1 is specifically involved in the extracellular deposition of the cutin polyester in the tomato fruit cuticle.

The cuticle is a protective layer synthesized by epidermal cells of the plants and consisting of cutin covered and filled by waxes. In tomato (Solanum lycopersicum) fruit, the thick cuticle embedding epidermal cells has crucial roles in the control of pathogens, water loss, cracking, postharvest shelf-life, and brightness. To identify tomato mutants with modified cuticle composition and architecture and to further decipher the relationships between fruit brightness and cuticle in tomato, we screened an ethyl methanesulfonate mutant collection in the miniature tomato cultivar Micro-Tom for mutants with altered fruit brightness. Our screen resulted in the isolation of 16 glossy and 8 dull mutants displaying changes in the amount and/or composition of wax and cutin, cuticle thickness, and surface aspect of the fruit as characterized by optical and environmental scanning electron microscopy. The main conclusions on the relationships between fruit brightness and cuticle features were as follows: (1) screening for fruit brightness is an effective way to identify tomato cuticle mutants; (2) fruit brightness is independent from wax load variations; (3) glossy mutants show either reduced or increased cutin load; and (4) dull mutants display alterations in epidermal cell number and shape. Cuticle composition analyses further allowed the identification of groups of mutants displaying remarkable cuticle changes, such as mutants with increased dicarboxylic acids in cutin. Using genetic mapping of a strong cutindeficient mutation, we discovered a novel hypomorphic allele of GDSL lipase carrying a splice junction mutation, thus highlighting the potential of tomato brightness mutants for advancing our understanding of cuticle formation in plants.

The relationship between the primary cell wall phenolic acids, dehydrodimers of ferulic acid, and maize grain resistance to Fusarium graminearum, the causal agent of gibberella ear rot, was investigated. Concentrations of dehydrodimers of ferulic acid were determined in the pericarp and aleurone tissues of five inbreds and two hybrids of varying susceptibility and in a segregating population from a cross between a resistant and susceptible inbred. Significant negative correlations were found between disease severity and diferulic acid content. Even stronger correlations were observed between diferulic acid and the fungal steroid ergosterol, which is an indicator of fungal biomass in infected plant tissue. These results were consistent over two consecutive field seasons, which differed significantly for temperature and rainfall during pollination, the most susceptible stage of ear development. No correlation was found between the levels of these phenolics and deoxynivalenol levels. This is the first report of in vivo evidence that the dehydrodimers of ferulic acid content in pericarp and aleurone tissues may play a role in genotypic resistance of maize to gibberella ear rot.

Cuticle function is closely related to the structure of the cutin polymer. However, the structure and formation of this hydrophobic polyester of glycerol and hydroxy/epoxy fatty acids has not been fully resolved. An apoplastic GDSL-lipase known as CUTIN SYNTHASE1 (CUS1) is required for cutin deposition in tomato (Solanum lycopersicum) fruit exocarp. In vitro, CUS1 catalyzes the self-transesterification of 2-monoacylglycerol of 9(10),16-dihydroxyhexadecanoic acid, the major tomato cutin monomer. This reaction releases glycerol and leads to the formation of oligomers with the secondary hydroxyl group remaining nonesterified. To check this mechanism in planta, a benzyl etherification of nonesterified hydroxyl groups of glycerol and hydroxy fatty acids was performed within cutin. Remarkably, in addition to a significant decrease in cutin deposition, mid-chain hydroxyl esterification of the dihydroxyhexadecanoic acid was affected in tomato RNA interference and ethyl methanesulfonate-cus1 mutants. Furthermore, in these mutants, the esterification of both sn-1,3 and sn-2 positions of glycerol was impacted, and their cutin contained a higher molar glycerol-to-dihydroxyhexadecanoic acid ratio. Therefore, in planta, CUS1 can catalyze the esterification of both primary and secondary alcohol groups of cutin monomers, and another enzymatic or nonenzymatic mechanism of polymerization may coexist with CUS1-catalyzed polymerization. This mechanism is poorly efficient with secondary alcohol groups and produces polyesters with lower molecular size. Confocal Raman imaging of benzyl etherified cutins showed that the polymerization is heterogenous at the fruit surface. Finally, by comparing tomato mutants either affected or not in cutin polymerization, we concluded that the level of cutin cross-linking had no significant impact on water permeance.Cuticles are ubiquitous hydrophobic barriers at the surfaces of aerial plant organs. These complex hydrophobic assemblies consist of a biopolymer, cutin, coated and filled with waxes and can also comprise embedded cell wall polysaccharides. Waxes comprise solventsoluble aliphatic molecules with long hydrocarbon chains, terpenes, and steroids (Kunst and Samuels,

Barley lipid transfer protein (LTP1) is a heat-stable and protease-resistant albumin that concentrates in beer, where it participates in the formation and stability of beer foam. Whereas the barley LTP1 does not display any foaming properties, the corresponding beer protein is surface-active. Such an improvement is related to glycation by Maillard reactions on malting, acylation on mashing, and structural unfolding on brewing. The structural stability of purified barley and glycated malt LTP1 toward heating has been analyzed. Whatever the modification, lipid adduction or glycation, barley LTP1s are highly stable proteins that resisted temperatures up to 100 degrees C. Unfolding of LTP1 occurred only when heating was conducted in the presence of a reducing agent. In the presence of sodium sulfite, the lipid-adducted barley and malt LTP1 displayed higher heat stability than the nonadducted protein. Glycation had no or weak effect on heat-induced unfolding. Finally, it was shown that unfolding occurred on wort boiling before fermentation and that the reducing conditions are provided by malt extract.

Fungi of the genus Fusarium are common fungal contaminants of maize and are also known to produce mycotoxins. Maize that has been genetically modified to express a Bt endotoxin has been used to study the effect of insect resistance on fungal infection of maize grains by Fusarium species and their related mycotoxins. Maize grain from Bt hybrids and near-isogenic traditional hybrids was collected in France and Spain from the 1999 crop, which was grown under natural conditions. According to the ergosterol level, the fungal biomass formed on Bt maize grain was 4-18 times lower than that on isogenic maize. Fumonisin B(1) grain concentrations ranged from 0.05 to 0.3 ppm for Bt maize and from 0.4 to 9 ppm for isogenic maize. Moderate to low concentrations of trichothecenes and zearalenone were measured on transgenic as well as on non-transgenic maize. Nevertheless, significant differences were obtained in certain regions. The protection of maize plants against insect damage (European corn borer and pink stem borer) through the use of Bt technology seems to be a way to reduce the contamination of maize by Fusarium species and the resultant fumonisins in maize grain grown in France and Spain.

Screening of transfer DNA (tDNA) tagged lines of Arabidopsis thaliana for mutants defective in systemic acquired resistance led to the characterization of dir1-1 (defective in induced resistance [systemic acquired resistance, SAR]) mutant. It has been suggested that the protein encoded by the dir1 gene, i.e., DIR1, is involved in the long distance signaling associated with SAR. DIR1 displays the cysteine signature of lipid transfer proteins, suggesting that the systemic signal could be lipid molecules. However, previous studies have shown that this signature is not sufficient to define a lipid transfer protein, i.e., a protein capable of binding lipids. In this context, the lipid binding properties and the structure of a DIR1-lipid complex were both determined by fluorescence and X-ray diffraction. DIR1 is able to bind with high affinity two monoacylated phospholipids (dissociation constant in the nanomolar range), mainly lysophosphatidyl cholines, side-by-side in a large internal tunnel. Although DIR1 shares some structural and lipid binding properties with plant LTP2, it displays some specific features that define DIR1 as a new type of plant lipid transfer protein. The signaling function associated with DIR1 may be related to a specific lipid transport that needs to be characterized and to an additional mechanism of recognition by a putative receptor, as the structure displays on the surface the characteristic PxxP structural motif reminiscent of SH3 domain signaling pathways.

Summary The cuticle is an essential and ubiquitous biological polymer composite covering aerial plant organs, whose structural component is the cutin polyester entangled with cell wall polysaccharides. The nature of the cutin‐embedded polysaccharides (CEPs) and their association with cutin polyester are still unresolved Using tomato fruit as a model, chemical and enzymatic pretreatments combined with biochemical and biophysical methods were developed to compare the fine structure of CEPs with that of the noncutinized polysaccharides (NCPs). In addition, we used tomato fruits from cutin‐deficient transgenic lines cus1 (cutin synthase 1) to study the impact of cutin polymerization on the fine structure of CEPs. Cutin‐embedded polysaccharides exhibit specific structural features including a high degree of esterification (i.e. methylation and acetylation), a low ramification of rhamnogalacturonan (RGI), and a high crystallinity of cellulose. In addition to decreasing cutin deposition and polymerization, cus1 silencing induced a specific modification of CEPs, especially on pectin content, while NCPs were not affected. This new evidence of the structural specificities of CEPs and of the cross‐talk between cutin polymerization and polysaccharides provides new hypotheses concerning the formation of these complex lipopolysaccharide edifices.