The global pressure for recycling and ecological energy production increases steadily in combination with the demand of cost-effective application of materials. However, some severe corrosion problems, associated with the high internal/intergranular corrosion rates in boiler components need to be avoid. Some commercial boiler materials contain a Cr content of 0.55 (wt. (%)) - 2.25 (wt. (%)). This Cr concentration in the alloys is not sufficient for the formation of a complete dense Cr2O3 scale. Hence, high oxidation kinetics may result. In this study, pure Fe and the steel 2.25Cr1Mo were oxidized in laboratory air at 550 °C using a thermobalance system. The surface as well as the cross section of oxidized specimens were analysed using scanning electron microscopy in order to quantify several factors (e.g. surface finishing, cold working and grain size) on the overall oxidation kinetics. For alloys with low Cr content, a decreasing in the grain size leads to an acceleration of the oxidation rate by facilitating the oxygen diffusion along alloy grain boundaries leading to an inward oxide layer formation. The study of effects of surface finish and cold working yielded results revealing that the oxidation process is complex and comparison of results from different laboratories is difficult and should be done

Generally, oxide scales formed on high Cr steels are multi-layered and the kinetics are strongly influenced by the alloy grain boundaries. In the present study, the oxidation behaviour of an austenite steel TP347 with different grain sizes was studied to identify the role of grain-boundaries in the oxidation process. Heat treatment in an inert gas atmosphere at 1050 °C was applied to modify the grain size of the steel TP347. The mass gain during subsequent oxidation was measured using a microbalance with a resolution of 10 -5 g. The scale morphology was examined using SEM in combination with energy-dispersive X-ray spectroscopy (EDS). Oxidation of TP347 with a grain size of 4 µm at 750 °C in air follows a parabolic rate law. For a larger grain size (65 µm), complex kinetics is observed with a fast initial oxidation followed by several different parabolic oxidation stages. SEM examinations indicated that the scale formed on specimens with smaller grain size was predominantly Cr 2 O 3 , with some FeCr 2 O 4 at localized sites. For specimens with larger grain size the main oxide is iron oxide. It can be concluded that protective Cr 2 O 3 formation is promoted by a high density of fast grain-boundary diffusion paths which is the case for fine-grained materials.

No abstract