A system of two taper roller bearings can carry loads with a high ratio of axial load to radial load. Such a system was proposed for a wind turbine gearbox following the poor durability of original bearing design with the aim of increasing durability. Because of size limits, a proposed system is composed of two different taper roller bearings. Standard manufacturers’ catalogues do not provide information on recommended preload or clearance conditions or the durability as a function of pre-load. That was the reason why durability was calculated on the basis of software provided by one of the manufacturers. The analysis presented in the paper shows the relationship between bearing fits, preload values, and the theoretical durability of the bearing.
The use of preloaded tapered roller bearings in wind turbine drive systems allows a transfer of load in the case of high variations of axial forces. The examined bearing system, a modification of a current design, consists of a pair of different sized bearings. Previous study showed the high sensitivity of tapered roller bearings on the existing radial interference. Dimensional tolerances used in the original design do not allow obtaining precise values of preload required for slippage-free operation of bearings with varying wind turbine load conditions. With the aim of achieving expected preload values, the use of plate springs (Belleville springs) is proposed. The springs will allow creating an axial force, independently of real dimensions in a modernised unit. Furthermore, it is very important in the case of gearbox retrofits to be executed up in the wind turbine nacelle without dismantling the gearbox.
During the operation of wind turbines with a gearbox of traditional configuration, a high failure rate of high-speed shaft bearings is observed. Such a high failures frequency is not reflected in standard bearing durability calculation methods, which can be attributed to atypical failure mechanism. To avoid observed problems in the 1.5 MW wind turbine, the modification of the existing bearing system is proposed. Multiple options, utilizing various bearing types were investigated. Different versions were examined for a potential durability increase, the extent of necessary design modifications, and possibility of solving existing problems in operation.
The literature describes acoustic levitation phenomena with the utilization of air squeeze film between the
vibrating inducer and the lifted object. The objective of the study is to determine the shape of the inducer with
vibration characteristics that would allow the levitation of an object of the assumed geometry. In this paper, the
influence of the dimension ratio of the inducer on the frequency of the first mode of vibration was presented.
CFD calculations for a selected dimension series were performed with the goal of the determination of lifting
conditions. The data obtained from the analysis will be used to manufacture an inducer that will serve as an
experimental verification for the fluid dynamics calculation.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.