Plasma catalysis is gaining increasing interest for CO2 conversion, but the interaction between the plasma and catalyst is still poorly understood. This is caused by limited systematic materials research, since most works combine a plasma with commercial supported catalysts and packings. In the present paper, we study the influence of specific material and reactor properties, as well as reactor/bead configuration, on the conversion and energy efficiency of CO2 dissociation in a packed bed dielectric barrier discharge (DBD) reactor. Of the various packing materials investigated, BaTiO3 yields the highest conversion and energy efficiency, i.e., 25% and 4.5%.Our results show that, when evaluating the influence of catalysts, the impact of the packing (support) material itself cannot be neglected, since it can largely affect the conversion and energy efficiency. This shows the large potential for further improvement of packed bed plasma reactors for CO2 conversion and other chemical conversion reactions by adjusting both packing (support) properties and catalytically active sites. Moreover, we clearly prove that comparison of results obtained in different reactor setups should be done with care, since there is a large effect of the reactor setup and reactor/bead configuration.

The complex of halothane (CHClBrCF(3)) and dimethyl ether has been investigated experimentally in solutions of liquid krypton using infrared spectroscopy and theoretically using ab initio calculations at the MP2/6-311++G(d,p) level. The formation of a 1:1 complex was experimentally detected. The most stable ab initio geometry found is the one in which the C--H bond of halothane interacts with the oxygen atom of dimethyl ether. The complexes in which the chlorine or the bromine atom of halothane interacts with the oxygen atom of the ether were found to be local energy minima and were less stable by 14.5 and 9.3 kJ mol(-1), respectively, than the global minimum. The formation of a single complex species was observed in the infrared spectra; the standard complexation enthalpy of this complex was determined to be -12.3(8) kJ mol(-1). Analysis of the observed complexation shifts supports the identification of the complex as the hydrogen-bonded species. The C--H stretching vibration of halothane was found to show a redshift upon complexation of 19(2) cm(-1). The infrared intensity ratios epsilon(complex)/epsilon(monomer) for the fundamental and its first overtone were measured to be 6.5(1) and 0.31(1). The frequency shift was analyzed using Morokuma-type analysis, and the infrared intensity ratios were rationalized using a model including the mechanical and electric anharmonicity of the C--H stretching fundamental.

The formation of C-H...π bonded complexes of halothane with benzene(-d(6)) has been studied using infrared and Raman spectroscopy of solutions in liquid krypton, in supersonic jet expansions and in room temperature vapour phase. The formation of complexes with 1 ∶ 1 and 2 ∶ 1 stoichiometry was observed. The complexation enthalpy in liquid krypton for the 1 ∶ 1 complex was determined to be -9.8(2) kJ mol(-1) and the enthalpy for the addition of a second halothane molecule to the 1 ∶ 1 complex was determined at -7.0(3) kJ mol(-1). The stretching mode of the halothane C-H bond involved in the formation of the complex in the jets was observed to blue shift by 7.7(10) cm(-1). In contrast, for the solutions of liquid krypton and the room temperature measurements a small red shift was observed. Supported by ab initio calculations and Monte Carlo simulations, this shift was explained by the differences in thermal populations of the van der Waals vibrations of the complex in the different experiments.

No abstract

No abstract

PLATInum group metals Recovery Using Secondary raw materials (PLATIRUS), a European Union (EU) Horizon 2020 project, aims to address the platinum group metal (pgm) supply security within Europe by developing novel and greener pgm recycling processes for autocatalysts, mining and electronic wastes. The initial focus was on laboratory-scale research into ionometallurgical leaching, microwave assisted leaching, solvometallurgical leaching, liquid separation, solid phase separation, electrodeposition, electrochemical process: gas-diffusion electrocrystallisation and selective chlorination. These technologies were evaluated against key performance indicators (KPIs) including recovery, environmental impact and process compatibility; with the highest scoring technologies combining to give the selected PLATIRUS flowsheet comprising microwave assisted leaching, non-conventional liquid-liquid extraction and gas-diffusion electrocrystallisation. Operating in cascade, the PLATIRUS flowsheet processed ~1.3 kg of spent milled autocatalyst and produced 1.2 g palladium, 0.8 g platinum and 0.1 g rhodium in nitrate form with a 92–99% purity. The overall recoveries from feedstock to product were calculated as 46 ± 10%, 32 ± 8% and 27 ± 3% for palladium, platinum and rhodium respectively. The recycled pgm has been manufactured into autocatalysts for validation by end users. This paper aims to be a project overview, an in‐depth technical analysis into each technology is not included. It summarises the most promising technologies explored, the technology evaluation, operation of the selected technologies in cascade, the planned recycled pgm end user validation and the next steps required to ready the technologies for implementation and to further validate their potential.

The complex of halothane (CF(3)CBrClH) with ([D(3)])methyl fluoride is investigated theoretically by means of ab initio calculations at the MP2/6-311++G(d,p) level and experimentally by infrared spectroscopy of solutions in liquid krypton. The complexation energy is calculated to be -12.5 kJ mol(-1). The dipole moment of halothane monomer as a function of the C-H stretching coordinate is calculated with different methodologies and the value of (partial differential(mu)/partial differential(Q(1)))0 is found to be positive. In the spectra, formation of a 1:1 complex is observed. The standard complexation enthalpy is measured to be -8.4(2) kJ mol(-1). The C-H stretching vibration of halothane shows a blueshift of +15.4 cm(-1) on complexation, and its infrared intensity ratio epsilon(complex)/epsilon(monomer) is found to be 1.39(7). The frequency shift is analyzed by a Morokuma analysis, and the infrared intensities are rationalized by using a model which includes the mechanical and electrical anharmonicity of the C-H stretching vibration.

No abstract