We report the first hybrid tandem solar cell with solution processable active layers using colloidal PbS quantum dots (QDs) as the front subcell in combination with a polymer-fullerene rear subcell. Al/WO3 is introduced as an interlayer, yielding an open circuit voltage (VOC) equal to about 92% of the sum of the VOC of the subcells. The device exhibits a power conversion efficiency of 1.8%. Optical simulations of various tandem configurations show that combining PbS QDs with small-bandgap polymers is a promising strategy to obtain tandem solar cells with a very broad absorption range and a high short circuit current.

Ruddlesden-Popper organic-inorganic hybrid copper-based perovskites have been studied for decades owing to a variety of interesting properties, such as thermochromism and piezochromism, and the mechanisms behind these phenomena have been...

Results of optical frequency transfer over a carrier-grade dense-wavelength-division-multiplexing (DWDM) optical fibre network are presented. The relation between soil temperature changes on a buried optical fibre and frequency changes of an optical carrier through the fibre is modelled. Soil temperatures, measured at various depths by the Royal Netherlands Meteorology Institute (KNMI) are compared with observed frequency variations through this model. A comparison of a nine-day record of optical frequency measurements through the 2 × 298 km fibre link with soil temperature data shows qualitative agreement. A soil temperature model is used to predict the link stability over longer periods (days-months-years). We show that one-way optical frequency dissemination is sufficiently stable to distribute and compare e.g. rubidium frequency standards over standard DWDM optical fibre networks.

We present efficient p-i-n type perovskite solar cells using NiOx as the hole transport layer and a fulleropyrrolidine with a triethylene glycol monoethyl ether side chain (PTEG-1) as electron transport layer. This electron transport layer leads to higher power conversion efficiencies compared to perovskite solar cells with PCBM (phenyl-C61-butyric acid methyl ester). The improved performance of PTEG-1 devices is attributed to the reduced trap-assisted recombination and improved charge extraction in these solar cells, as determined by light intensity dependence and photoluminescence measurements. Through optimization of the hole and electron transport layers, the power conversion efficiency of the NiOx/perovskite/PTEG-1 solar cells was increased up to 16.1%.