This work aims to introduce a new needle insertion simulation to predict the deflection of a bevel-tip needle inside soft tissue. The development of such a model, which predicts the steering behavior of the needle during needle-tissue interactions, could improve the performance of many percutaneous needle-based procedures such as brachytherapy and thermal ablation, by means of the virtual path planning and training systems of the needle toward the target and thus reducing possible incidents of complications in clinical practices. The Arbitrary-Lagrangian-Eulerian (ALE) formulation in LS-DYNA software was used to model the solid-fluid interactions between the needle and tissue. Since both large deformation and fracture of the continuum need to be considered in this model, applying ALE method for fluid analysis was considered a suitable approach. A 150 mm long needle was used to bend within the tissue due to the interacting forces on its asymmetric bevel tip. Three experimental cases of needle steering in a soft phantom were performed to validate the simulation. An error measurement of less than 10 % was found between the predicted deflection by the simulations and the one observed in experiments, validating our approach with reasonable accuracy. The effect of the needle diameter and its bevel tip angle on the final shape of the needle was investigated using this model. To maneuver around the anatomical obstacles of the human body and reach the target location, thin sharp needles are recommended, as they would create a smaller radius of curvature. The insertion model presented in this work is intended to be used as a base structure for path planning and training purposes for future studies.
Needle insertion is used in many diagnostic and therapeutic percutaneous medical procedures such as brachytherapy, thermal ablations, and breast biopsy. Insufficient accuracy using conventional surgical cannulas motivated researchers to provide actuation forces to the cannula's body for compensating the possible errors of surgeons/physicians. In this study, we present the feasibility of using shape memory alloy (SMA) wires as actuators for an active steerable surgical cannula. A three-dimensional (3D) finite element (FE) model of the active steerable cannula was developed to demonstrate the feasibility of using SMA wires as actuators to bend the surgical cannula. The material characteristics of SMAs were simulated by defining multilinear elastic isothermal stress–strain curves that were generated through a matlab code based on the Brinson model. Rigorous experiments with SMA wires were done to determine the material properties as well as to show the capability of the code to predict a stabilized SMA transformation behavior with sufficient accuracy. In the FE simulation, birth and death method was used to achieve the prestrain condition on SMA wire prior to actuation. This numerical simulation was validated with cannula deflection experiments with developed prototypes of the active cannula. Several design parameters affecting the cannula's deflection such as the cannula's Young's modulus, the SMA's prestrain, and its offset from the neutral axis of the cannula were studied using the FE model. Real-time experiments with different prototypes showed that the quickest response and the maximum deflection were achieved by the cannula with two sections of actuation compared to a single section of actuation. The numerical and experimental studies showed that a highly maneuverable active cannulas can be achieved using the actuation of multiple SMA wires in series.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.