The surface energy is a fundamental property of the different facets of a crystal that is crucial to the understanding of various phenomena like surface segregation, roughening, catalytic activity, and the crystal’s equilibrium shape. Such surface phenomena are especially important at the nanoscale, where the large surface area to volume ratios lead to properties that are significantly different from the bulk. In this work, we present the largest database of calculated surface energies for elemental crystals to date. This database contains the surface energies of more than 100 polymorphs of about 70 elements, up to a maximum Miller index of two and three for non-cubic and cubic crystals, respectively. Well-known reconstruction schemes are also accounted for. The database is systematically improvable and has been rigorously validated against previous experimental and computational data where available. We will describe the methodology used in constructing the database, and how it can be accessed for further studies and design of materials.

NASICON is one of the most promising sodium solid electrolytes that can enable the assembly of cheaper and safer sodium all-solid-state batteries. In this study, we perform a combined experimental and computational investigation into the effects of aliovalent doping in NASICON on both bulk and grain boundary (secondary phase) ionic conductivity. Our results show that the dopants with low solid solubility limits in NASICON lead to the formation of a conducting (less insulating) secondary phase, thereby improving the grain boundary conductivity measured by electrochemical impedance spectroscopy (including grain-boundary, secondary-phase, and other microstructural contributions) that is otherwise hindered by the poorly-conducting secondary phases in undoped NASICON. This is accompanied by a change in the Si/P ratio in the primary NASICON bulk phase, thereby transforming monoclinic NASICON to rhombohedral NASICON. Consequently, we have synthesized NASICON chemistries with significantly improved and optimized total ionic conductivity of 2.7 mS/cm. More importantly, this study has achieved a understanding of the underlying mechanisms of improved conductivities via doping (differing from the common wisdom) and further suggests a new general direction to improve the ionic conductivity of † M.S. and B.R. contributed equally to this work.

The newly discovered lithium-rich antiperovskite (LRAP) superionic conductors are an extremely interesting class of materials with potential applications as solid electrolytes in Li-ion batteries. In this work, we present a rational composition optimization strategy for maximizing the Li + conductivity in the LRAP guided by a combination of firstprinciples calculations and percolation theory. Using nudged elastic band (NEB) calculations, we show that a Cl-rich channel with Br-rich end points configuration leads to low vacancy migration barriers in the LRAP structure. By incorporating the halide-environment-dependent NEB barriers in a bond percolation model, we predict that there are potentially higher conductivity Li 3 OCl 1−x Br x structures near 0.235 ≤ x ≤ 0.395. This prediction is confirmed by AIMD simulation that finds Li 3 OCl 0.75 Br 0.25 to have a higher Li + conductivity than Li 3 OCl 0.5 Br 0.5 , the highest conductivity LRAP identified experimentally thus far. These results highlight that there is scope for further enhancing the conductivity in the LRAP chemistry. The general approach developed can potentially be extended to other ion-conducting systems, such as the structurally similar perovskite oxygen-ion conductors of interest in solid-oxide fuel cells as well as other superionic conductors.

Metal-ion doping can improve the electrochemical performance of Na 3 V 2 (PO 4) 3. However, the reason for the enhanced electrochemical performance and the effects of cation doping on the structure of Na 3 V 2 (PO 4) 3 have yet been probed. Herein, Mg 2+ is doped into Na 3 V 2 (PO 4) 3 /C according to the firstprinciples calculation. The results indicate that Mg 2+ prefers to reside in the V site and an extra electrochemical active Na + is introduced to the Na 3 V 2 (PO 4) 3 /C crystal to maintain the charge balance. The distribution of Mg 2+ in the particle of Na 3 V 2 (PO 4) 3 /C is further studied by electrochemical impedance spectroscopy. We find that the highest distribution of Mg 2+ on the surface of the particles leads to facile surface electrochemical reactions for Mg 2+doped samples, especially at high rates.

The thermal stability of electrochemically delithiated Li0.1Ni0.8Co0.15Al0.05O2 (NCA), FePO4 (FP), Mn0.8Fe0.2PO4 (MFP), hydrothermally synthesized VOPO4, LiVOPO4, and electrochemically lithiated Li2VOPO4 is investigated by differential scanning calorimetry (DSC) and thermogravimetric analysis, coupled with mass spectrometry (TGA-MS). The thermal stability of the delithiated materials is found to be in the order of NCA < VOPO4 < MFP < FP. Unlike the layered oxides and MFP, VOPO4 does not evolve O2 on heating. Thus, VOPO4 is less likely to cause a thermal run-away phenomenon in batteries at elevated temperature and so is inherently safer. The lithiated materials LiVOPO4, Li2VOPO4, and LiNi0.8Co0.15Al0.05O2 are found to be stable in the presence of electrolyte, but sealed-capsule high-pressure experiments show a phase transformation of VOPO4 → HVOPO4 → H2VOPO4 when VOPO4 reacts with electrolyte (1 M LiPF6 in EC/DMC = 1:1) between 200 and 300 °C. Using first-principles calculations, we confirm that the charged VOPO4 cathode is indeed predicted to be marginally less stable than FP but significantly more stable than NCA in the absence of electrolyte. An analysis of the reaction equilibria between VOPO4 and EC using a multicomponent phase diagram approach yields products and reaction enthalpies that are highly consistent with the experiment results.