For hydrogen sensors built with pure Pd nanowires, the instabilities causing baseline drifting and temperature-driven sensing behavior are limiting factors when working within a wide temperature range. To enhance the material stability, we have developed superlattice-structured palladium and copper nanowires (PdCu NWs) with random-gapped, screw-threaded, and spiral shapes achieved by wet-chemical approaches. The microstructure of the PdCu NWs reveals novel superlattices composed of lattice groups structured by four-atomic layers of alternating Pd and Cu. Sensors built with these modified NWs show significantly reduced baseline drifting and lower critical temperature (259.4 K and 261 K depending on the PdCu structure) for the reverse sensing behavior than those with pure Pd NWs (287 K). Moreover, the response and recovery times of the PdCu NWs sensor were of ~9 and ~7 times faster than for Pd NWs sensors, respectively.

We report for the first time a novel room temperature methane (CH(4)) sensor fabricated using porous tin oxide (SnO(2)) nanorods as the sensing material. The porous SnO(2) nanorods were synthesized by using multiwall carbon nanotubes (MWCNTs) as templates. Current versus time curves were obtained demonstrating the room temperature sensing capabilities of the sensor system when exposed to 0.25% CH(4) in air. The sensor also exhibited a wide temperature range for different concentrations of CH(4) (25-500 °C), making it useful in harsh environments as well.

Breath analysis techniques offer a potential revolution in health care diagnostics, especially if these techniques can be brought into standard use in the clinic and at home. The advent of microsensors combined with smart sensor system technology enables a new generation of sensor systems with significantly enhanced capabilities and minimal size, weight and power consumption. This paper discusses the microsensor/smart sensor system approach and provides a summary of efforts to migrate this technology into human health breath monitoring applications. First, the basic capability of this approach to measure exhaled breath associated with exercise physiology is demonstrated. Building from this foundation, the development of a system for a portable asthma home health care system is described. A solid-state nitric oxide (NO) sensor for asthma monitoring has been identified, and efforts are underway to miniaturize this NO sensor technology and integrate it into a smart sensor system. It is concluded that base platform microsensor technology combined with smart sensor systems can address the needs of a range of breath monitoring applications and enable new capabilities for healthcare.

The synthesis of silica nanorods by electron beam irradiation of porous silicon (PSi) films was investigated. The method allows us to monitor the growth process in real time at the nanoscale. Depending on the electron dose we obtain nanorods with diameters in the range of 10–50 nm and lengths up to 500 nm. We found that the adequate electron dose rates were between 0.02 and 2 A cm−2. Larger electron doses cause plastic and failure deformations in the silica nanorods. The growth process is analyzed and a growth mechanism that involves the mass flow from the porous silicon surface controlled by the local electric fields is discussed. A two-step synthesis procedure is finally explained for the fabrication of silica–carbon heterostructures consisting of silica nanorods decorated with amorphous carbon branches.

A nanocrystalline Si-based paste was successfully tested as the light emitting material in a field emission display test device that employed a film of carbon nanofibers as the electron source. Stable emission in the 550-850 nm range was obtained at 16 V µm(-1). This relatively low field required for intense cathodoluminescence (CL) from the PSi paste may lead to longer term reliability of both the electron emitting and the light emitting materials, and to lower power consumption. Here we describe the synthesis, characterization, and analyses of the light emitting nanostructured Si paste and the electron emitting C nanofibers used for building the device, including x-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM), transmission electron microscopy (TEM), and Raman spectroscopy. The corresponding spectra and field emission curves are also shown and discussed.