Silicon (Si)-based photodetectors are appealing candidates due to their low cost and compatibility with the complementary metal oxide semiconductor (CMOS) technology. The nanoscale devices based on Si can contribute efficiently in the field of photodetectors. In this report, we investigate the photodetection capability of nano-Schottky junctions using gold (Au) coated conductive atomic force microscope (C-AFM) tips, and highly cleaned n-Si substrate interface. The Au nanotip/n-Si interface forms the proposed structure of a nano Schottky diode based photodetector. The electrical characteristics measured at the nanoscale junction with different Au nanotip radii show that the tunneling current increases with decreasing the tip radius. Moreover, the tunneling process and photodetection effects are discussed in terms of barrier width/height decrease at the tip-semiconductor interface due to the applied electric field as well as the generation of plasmon-induced hot-electron at the nanoparticle (i.e. C-AFM tip)/n-Si interface. Furthermore, the photodetection sensitivity is investigated and it is found to be higher for C-AFM tips with smaller radii. Moreover, this research will open a new path for the miniaturization of photodetectors with high sensitivity based on nano-Schottky interfaces.
Improving Schottky diode characteristics in semiconducting devices is essential for better functionality in electronic and optoelectronic devices at nanoscale. In this paper, we investigate the electric transport characteristics of a gold (Au)-tip/n-Si-based nano-Schottky diode by using a conductive-mode atomic force microscope (CAFM). First, 10 nm average diameter Au nanoparticles (NPs) are monodispersed on the highly cleaned n-type Si substrate using an optimized spin-coating technique. The controlled and well dispersed NPs are confirmed by using the AC imaging mode of the AFM. The electrical characteristics are established by using an Aucoated AFM tip, by either soft engaging at the surface of the n-Si substrate or at the top of an individual Au NP. Landing of the AFM tip on the NP or n-Si substrate is validated by the force curves of the AFM. From the localized CAFM electrical characteristics, we observed the improvement in the figures of merit (FOM) that characterize the rectification performance including the (1-V) asymmetry ( f ASYM ), and the turn-on voltage due to placing the Au NP between the AFM tip and n-Si substrate. These improved FOM of the nanoscale diodes are explained based on the increase in the tunneling current at the nanoscale Au-NP/n-Si interface. Moreover, the nanoscale control of interface structure is extremely important to improve the characteristics of nano-Schottky diodes.
We demonstrate a metal-oxide-semiconductor based nonvolatile memory element structure with a single isolated gold nanoparticle (Au-NP) acting as the storage site. The Au-NPs are sandwiched between amorphous Al2O3 thin films, deposited using the atomic layer deposition method to form the blocking and tunneling layers. The current voltage characteristics of the fabricated structure during write/erase cycles are obtained using conductive mode atomic force microscopy (C-AFM) by probing a single isolated NP at a time. Consecutive voltage sweeps show a memory window in I–V characterization with an average of ΔV ∼0.9 V at a reading current of 1.5 nA, demonstrating the presence of stored charge in the Au-NP, which originates from the AFM metal-coated probe. The results show the writing and erasing operation of the device by charging and discharging a single Au-NP. Moreover, the physics is discussed in terms of the electric field enhancement due to the charge confinement and its effect on the conduction mechanisms.
Optoelectronic devices are advantageous in in-memory light sensing for visual information processing, recognition, and storage in an energy-efficient manner. Recently, in-memory light sensors have been proposed to improve the energy, area, and time efficiencies of neuromorphic computing systems. This study is primarily focused on the development of a single sensing-storage-processing node based on a two-terminal solution-processable MoS2 metal–oxide–semiconductor (MOS) charge-trapping memory structure—the basic structure for charge-coupled devices (CCD)—and showing its suitability for in-memory light sensing and artificial visual perception. The memory window of the device increased from 2.8 V to more than 6 V when the device was irradiated with optical lights of different wavelengths during the program operation. Furthermore, the charge retention capability of the device at a high temperature (100 °C) was enhanced from 36 to 64% when exposed to a light wavelength of 400 nm. The larger shift in the threshold voltage with an increasing operating voltage confirmed that more charges were trapped at the Al2O3/MoS2 interface and in the MoS2 layer. A small convolutional neural network was proposed to measure the optical sensing and electrical programming abilities of the device. The array simulation received optical images transmitted using a blue light wavelength and performed inference computation to process and recognize the images with 91% accuracy. This study is a significant step toward the development of optoelectronic MOS memory devices for neuromorphic visual perception, adaptive parallel processing networks for in-memory light sensing, and smart CCD cameras with artificial visual perception capabilities.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.