This article describes the observed and examined effect of crumb rubber on the strength (compressive, bending and splitting tensile) of concrete. The tests have shown that the change in the strength of concrete with crumb rubber waste additives can be forecasted from exponential equations. These relationships enable to foresee the regularities of strength properties when a certain amount of crumb rubber of a certain size fraction is added to concrete. The obtained exponential equations show that concrete compressive, flexural and splitting tensile strengths decrease with increasing crumbed rubber additive amount. The testing has also shown that the addition of a small amount of crumbed rubber slightly increases (7%) the tensile splitting strength. The reason is better adhesion of the cement stone with rubber particles compared to the adhesion of sand, which was replaced by crumbed rubber. With higher content of crumbed rubber additive in the concrete, the tensile splitting strength decreases due to the significant increase of entrained air content and lower density.

No abstract

This paper analyzes concrete fine aggregate (sand) modification by scrap tire rubber particles-fine crumb rubber (FCR) and coarse crumb rubber (CCR) of fraction 0/1mm. Such rubberized concrete to get better bonding properties were modified by car-boxylated styrene butadiene rubber (SBR) latex and to gain the strength were modified by glass waste. The following tests—slump test, fresh concrete density, fresh concrete air content, compressive strength, flexural strength, fracture energy, freezing-thawing, porosity parameter, and scanning electron microscope—were conducted for rubberized concretes. From experiments, we can see that fresh concrete properties decreased when crumb rubber content has increased. Mostly it is related to crumb rubber (CR) lower specific gravity nature and higher fineness compared with changed fine aggregate-sand. In this research, we obtained a slight loss of compressive strength when CR was used in concrete However, these rubberized concretes with a small amount of rubber provided sufficient compressive strength results (greater than 50 MPa). Due to the pozzolanic reaction, we see that compressive strength results after 56 days in glass powder modified samples increased by 11–13% than 28 days com-pressive strengths, while at the same period control samples increased its compressive strength about 2.5%. Experiments have shown that the flexural strength of rubberized concrete with small amounts of CR increased by 3.4–15.8% compared to control mix, due the fact that rubber is an elastic material and it will absorb high energy and perform positive bending toughness. The test results indicated that CR can intercept the tensile stress in concrete and make the deformation more plastic. Fracturing of such conglomerate concrete is not brittle, there is no abrupt post-peak load drop and gradually continues after the maximum load is exceeded. Such concrete requires much higher fracture energy. It was obtained that FCR particles (lower than A300) will entrap more micropores content than coarse rubbers because due to their high specific area. Freezing-thawing results have confirmed that Kf values can be conveniently used to predict freeze-thaw resistance and durability of concrete. The test has shown that modification of concrete with 10 kg fine rubber waste will lead to similar mechanical and durability properties of concrete as was obtained in control concrete with 2 kg of prefabricated air bubbles.

Every year, colossal amounts of used and non-biodegradable rubber tyres are accumulated in the world. Experience shows that the most efficient way to increase the concrete fracture energy G F (N/m) is to use metal or polypropylene fibres. The optimal content of fibre increases concrete resistance to stress (especially tensile stress under bending force). Concrete fracture is not brittle; concrete continues deforming after maximum stresses and is able to resist certain stresses, there is no abrupt decrease in loading. The research has proved that crumb rubber can be used in concretes as an alternative to metal and polypropylene fibres. The investigation has found that rubber waste additives, through their specific properties can partly take up tensile stresses in concrete and make the concrete fracture more plastic; besides, such concrete requires a significantly higher fracture energy and concrete samples can withstand much higher residual strength at 500 mm crack mouth opening displacement (CMOD) and deflection.

This paper analyses the effect of mineral additives on alkali-silica reaction. Amorphous SiO 2 contained in concrete aggregate is known for reactions with Na 2 O and K 2 O that cause concrete expansion and cracking. Concrete expansion is the result of silicates reaction (ASR). Alkali silica gel is a reaction product having expanding properties. Expanding silica gel creates stress that causes concrete cracking. The paper investigates the elimination of the negative effect of ASR by using fly ash as active mineral additive. In the tests active mineral additive (fly ash) is expected to reduce the effect of alkali-silica reaction and volumetric strain.