International audienceNaSICON-type lithium conductor Li1.3Al0.3Ti1.7(PO4)3 (LATP) is synthesized with controlled grain size and composition using solution chemistry. After thermal treatment at 850 °C, sub-micronic crystallized powders with high purity are obtained. They are converted into ceramic through Spark Plasma Sintering at 850-1000 °C. By varying the processing parameters, pellet with conductivities up to 1.6 × 10−4 S/cm with density of 97% of the theoretical density have been obtained. XRD, FEG-SEM, ac-impedance and Vickers indentation were used to characterize the products. The influence of sintering parameters on pellet composition, microstructure and conductivity is discussed in addition to the analysis of the mechanical behavior of the grains interfaces

In this paper, acoustic emission data fusion based on multiple measurements is presented for damage detection and identification in oxide-based ceramic matrix composites. Multi-AE (acoustic emission) sensor fusion is considered with the aim of a better identification of damage mechanisms. In this context, tensile tests were conducted on ceramic matrix composites, fabricated with 3M™ Nextel™ 610 fibers and aluminosilicate matrix, with two kinds of AE sensors. Redundant and complementary sensor data were merged to enhance AE system capability and reliability. Data fusion led to consistent signal clustering with an unsupervised procedure. A correlation between these clusters and the damage mechanisms was established thanks to in situ observations. The complementarity of the information from both sensors greatly improves the characterization of sources for their classification. Moreover, this complementarity allows features to be perceived more precisely than using only the information from one kind of sensor.

A dense membrane of lithium aluminum titanium phosphate Li1+xAlxTi2−x(PO4)3, x = 0.3 (LATP) is deposited on a porous LATP substrate via wet chemistry. In the polymerized complex process, phosphate precursors with different active groups and steric hindrance are selected to tune precursor's reactivity. Rheological studies and microstructural observations lead to the selection of an LATP powder slurry charged with lithium, aluminum, titanium, and phosphate ion precursors. The optimized formulation is impregnated into a porous LATP substrate. After thermal treatment, dense LATP membranes on top of a porous LATP substrate are obtained with conductivities as high as 3 × 10−4 S/cm for the dense part, the porous part acting as a mechanical support. An original Van der Pauw impedance setup is validated for the measurement of the ionic conductivity of such dense/porous systems.

No abstract