We examined the removal of abamectin by the electro-Fenton (EF) process and the feasibility of biological treatment after degradation. The effect of the operating parameters showed that abamectin (Aba) degradation was enhanced with increasing temperature. Response surface analysis of the central composite design led to the following optimal conditions for the abatement of chemical oxygen demand: 45.5 °C, 5 mg L, 150 mA, and 0.15 mmol L for the temperature, initial Aba concentration, current intensity, and catalyst concentration, respectively. Under these conditions, 68.01% of the organic matter was removed and 94% of Aba was degraded after 5 h and 20 min of electrolysis, respectively. A biodegradability test, which was performed on a solution electrolyzed at 47 °C, 9 mg L, 150 mA, and 0.15 mmol L, confirms that the ratio of biological oxygen demand/chemical oxygen demand increased appreciably from 0.0584 to 0.64 after 5 h of electrolysis. This increased ratio is slightly above the limit of biodegradability (0.4). These results show the relevance of the EF process and its effectiveness for abamectin degradation. We conclude that biological treatment can be combined with the EF process for total mineralization.
The feasibility of the electro-Fenton (EF) process to improve the biodegradability of Algerian leachates was examined, in order to prepare this kind of flux for conventional biological treatment. This work also included, for the first time in Algeria, the control and monitorization of a landfill-the "Hamici" landfill. Several physicochemical parameters were determined allowing its classification into an intermediate degradation phase, namely considering their alkaline pH (8.7), high ammonium concentration (3,120 mg/L), low content in heavy metals, and biodegradability (BOD 5 / COD = 0.22). The effects of important parameters such as current intensity, treatment time, and temperature on COD removal have been studied and optimized by using response surface analysis of a central composite design, where 91.1% of COD was removed with a treatment time of 285 min, a current intensity of 3 A, and a temperature of 20°C. A biodegradability test, which was performed on a solution electrolyzed with 120 min, 2 A, and 20°C, allowed to improve the leachates biodegradability from 0.2 to 0.42, with a removal rate of COD and TOC of 53.35% and 34.5%, respectively. However, the current efficiency declined from 137% to 76.6% when the current intensity was rise from 0.5 to 2 A. These results showed the relevance of EF process applied on raw intermediate leachates and its possible benefit in the Algiers leachates treatment processes. Thus, it was concluded that biological treatment can be combined with EF process for optimal mineralization of leachates with clear advantages in this studied location. • Practitioner points• Characterization and treatment of leachates by electro-Fenton (EF) process were carried out. • The leachates are intermediate type and therefore biologically recalcitrant. • The operating parameter for EF process were modeled and optimized by the central composite design. • Current intensity of 2 A reduces COD and TOC of 53.35% and 34.5%, respectively. • The ratio BOD 5 /COD increased from 0.2 to 0.42 after 120 min of electrolysis time.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.