The phase behavior, including glass, devitrification, solid crystal melting, and liquid boiling transitions, and physicochemical properties, including density, refractive index, viscosity, conductivity, and air-liquid surface tension, of a series of 25 protic ionic liquids and protic fused salts are presented along with structure-property comparisons. The protic fused salts were mostly liquid at room temperature, and many exhibited a glass transition occurring at low temperatures between -114 and -44 degrees C, and high fragility, with many having low viscosities, down to as low as 17 mPa.s at 25 degrees C, and ionic conductivities up to 43.8 S/cm at 25 degrees C. These protic solvents are easily prepared through the stoichiometric combination of a primary amine and Brønsted acid. They have poor ionic behavior when compared to the far more studied aprotic ionic liquids. However, some of the other physicochemical properties possessed by these solvents are highly promising and it is anticipated that these, or analogous protic solvents, will find applications beyond those already identified for aprotic ionic liquids. This series of protic fused salts was employed to determine the effect of structural changes on the physicochemical properties, including the effect of hydroxyl groups, increasing alkyl chain lengths, branching, and the differences between inorganic and organic anions. It was found that simple structural modifications provide a mechanism to manipulate, over a wide range, the temperature at which phase transitions occur and to specifically tailor physicochemical properties for potential end-use applications.

The physicochemical properties of 22 protic ionic liquids (PILs) and 6 protic molten salts, and the self-assembly behavior of 3 amphiphiles in the PILs, are reported. Structure-property relationships have been explored for the PILs, including the effect of increasing the substitution of ammonium cations and the presence of methoxy and hydroxyl moieties in the cation. Anion choices included the formate, pivalate, trifluoroacetate, nitrate, and hydrogen sulfate anions. This series of PILs had a diverse range of physicochemical properties, with ionic conductivities up to 51.10 mS/cm, viscosities down to 5.4 mPa.s, surface tensions between 38.3 and 82.1 mN/m, and densities between 0.990 and 1.558 g/cm3. PILs were designed with various levels of solvent cohesiveness, as quantified by the Gordon parameter. Fourteen PILs were found to promote the self-assembly of amphiphiles. High-throughput polarized optical microscopy was used to identify lamellar, hexagonal, and bicontinuous cubic amphiphile self-assembly phases. The presence and extent of amphiphile self-assembly have been discussed in terms of the Gordon parameter.

A large number of protic ionic liquids (PILs) have been found to mediate solvent-hydrocarbon interactions and promote amphiphile self-assembly. Hexagonal, cubic, and lamellar lyotropic liquid crystalline phases were observed in PIL-hexadecyltrimethylammonium bromide systems. The driving force for the formation of the self-assembled aggregate structures has been attributed to an entropic contribution to the free energy of association, analogous to the hydrophobic effect in water. The specific aggregate structures formed depend upon the cationic and anionic components of the PIL and their interactions with the amphiphiles.

A range of protic ionic liquids (PILs) have been identified as being capable of supporting the self-assembly of the nonionic surfactants myverol 18-99 K (predominantly monoolein) and phytantriol. PIL-surfactant penetration scans have provided a high throughput technique to determine which lyotropic liquid crystalline phases were formed in the 40 PIL-surfactant systems investigated. Lamellar, inverse hexagonal, and bicontinuous cubic phases that are stable in excess PIL have been observed in surfactant-PIL systems. The studied PILs possess a wide range of solvent properties, including surface tension and viscosity. The nature of the formed amphiphile self-assembly phases is discussed in terms of the PIL structure and solvent properties.

A series of 11 new protic ionic liquids with fluorous anions (FPILs) have been identified and their self-assembled nanostructure, thermal phase transitions and physicochemical properties were investigated. To the best of our knowledge this is the first time that fluorocarbon domains have been reported in PILs. The FPILs were prepared from a range of hydrocarbon alkyl and heterocyclic amine cations in combination with the perfluorinated anions heptafluorobutyrate and pentadecafluorooctanoate. The nanostructure of the FPILs was established by using small- and wide-angle X-ray scattering (SAXS and WAXS). In the liquid state many of the FPILs showed an intermediate range order, or self-assembled nanostructure, resulting from segregation of the polar and nonpolar hydrocarbon and fluorocarbon domains of the ionic liquid. In addition, the physicochemical properties of the FPILs were determined including the melting point (T(m)), glass transition (T(g)), devitrification temperature (T(c)), thermal stability and the density ρ, viscosity η, air/liquid surface tension γ(LV), refractive index n(D), and ionic conductivity κ. The FPILs were mostly solids at room temperature, however two examples 2-pyrrolidinonium heptafluorobutyrate (PyrroBF) and pyrrolidinium heptafluorobutyrate (PyrrBF) were liquids at room temperature and all of the FPILs melted below 80 °C. Four of the FPILs exhibited a glass transition. The two liquids at room temperature, PyrroBF and PyrrBF, had a similar density, surface tension and refractive index but their viscosity and ionic conductivity were very different due to dissimilar self-assembled nanostructure.

Small- and wide-angle X-ray scattering (SWAXS) has been used to investigate the effect that water has on the nanoscale structure of protic ionic liquids (PILs) along with their precursor Brønsted acids and bases. The series of PILs consisted of primary, secondary, and tertiary alkylammonium cations in conjunction with formate, nitrate, or glycolate anions. Significant differences were observed for these systems. The nanoscale aggregates present in neat protic ionic liquids were shown to be stable in size on dilution to high concentrations of water, indicating that the water is localized in the ionic region and has little effect on the nonpolar domains. The Brønsted acid-water solutions did not display nanostructure at any water concentration. Primary amine Brønsted bases formed aggregates in water, which generally displayed characteristics of poorly structured microemulsions or a form of bicontinuous phase. Exceptions were butyl- and pentylamine with high water concentrations, for which the SWAXS patterns fitted well to the Teubner-Strey model for microemulsions. Brønsted base amines containing multiple alkyl chains or hydroxyl groups did not display nanostructure at any water concentration. IR spectroscopy was used to investigate the nature of water in the various solutions. For low PIL concentrations, the water was predominately present as bulk water for PIL molar fractions less than 0.4-0.5. At high PIL concentrations, in addition to the bulk water, there was a significant proportion of perturbed water, which is water influenced in some way by the cations and anions. The molecular state of the water in the studied amines was predominately present as bulk water, with smaller contributions from perturbed water than was seen in the PILs.

Protic ionic liquids (PILs) are a subset of ionic liquids formed by the equimolar mixing of a Brønsted acid and a Brønsted base. PILs have been categorized as poor ionic liquids. However, the issue of assessing the ionicity of PILs is still a matter of debate. In this work we studied some physicochemical properties of three chosen PILs, namely, ethanolammonium acetate (EOAA), 2-methylbutylammonium formate (2MBAF), and pentylammonium formate (PeAF), at the initial equimolar (stoichiometric) acid/base ratio and in the presence of excess acid and base. DSC phase-transition studies along with NMR, IR, and Raman spectroscopy were performed on the chosen PILs. The results are discussed in terms of the degree of ionization (extent of proton transfer from the Brønsted acid to Brønsted base), and the possibility of the formation of polar 1:1 complexes and larger aggregates in the neat stoichiometric PILs.

The ability of low molecular weight amides to support amphiphile self-assembly is shown to be a general feature for this class of solvents. This report extends the number of known polar solvents which can support amphiphile self-assembly by five new amides; more than doubling the number of known amides able to serve as amphiphile self-assembly media. The formation of lyotropic liquid crystalline phases by cationic and non-ionic surfactants in these liquid amides is reported. The ability of a solvent to promote amphiphile self-assembly is governed by the "solvophobic effect" and is linked to the solvent cohesiveness. The Gordon parameter which is a measure of the solvent cohesiveness was found to provide a guide to an amides capacity to support lyotropic liquid crystalline phase diversity and thermal stability ranges of those phases. The "solvophobic effect" and steric hindrance factors were compared between amide's and protic ionic liquids possessing analogous chemical structures and also being able to promote amphiphile self-assembly.