Purpose The purpose of this paper is to investigate the effect of surface protrusions on the flow unsteadiness of NACA 0012 at a Reynolds number of 100,000. Design/methodology/approach Effect of protrusions is investigated through numerical simulation of two-dimensional Navier–Stokes equations using a finite volume solver. Turbulent stresses are resolved through the transition Shear stress transport (four-equation) turbulence model. Findings The small protrusion located at 0.05c and 0.1c significantly improve the lift coefficient by up to 36% in the post-stall regime. It also alleviates the leading edge stall. The larger protrusions increase the drag significantly along with significant degradation of lift characteristics in the pre-stall regime as well. The smaller protrusions also increase the frequency of the vortex shedding. Originality/value The effect of macroscopic protrusions or deposits in rarely investigated. The delay in stall shown by smaller protrusions can be beneficial to micro aerial vehicles. The smaller protrusions increase the frequency of the vortex shedding, and hence, can be used as a tool to enhance energy production for energy harvesters based on vortex-induced vibrations and oscillating wing philosophy.
Detailed numerical simulations have been carried out on a spiked blunt body with multiple hemispherical disks using a commercial CFD code in order to investigate their effectiveness in reducing the aerodynamic drag and heating. The base configuration is a hemispherical cylinder whose diameter is 40 mm with an overall length of 70 mm. The lengths of the aerospikes investigated are 1, 1.5, 2 and 2.5 times the base diameter of the cylinder and the radii of the aerodisks are varied between 0.05, 0.1, 0.15 and 0.2 times the diameter of the cylinder. Besides these, the position of the aerodisks is varied with the rearmost aerodisk placed at 25%, 50% and 75% along the length of the aerospike and the intermediate aerodisk for three-disk cases, positioned at 25%, 50% and 75% of the distance between the front and the rearmost disk. All the investigations have carried out at a freestream Mach number of 6.2 and Reynolds number of 2.64 × 107/m. It has been observed that the multidisk spikes are advantageous for the purpose of reduction of both aerodynamic drag and heating at hypersonic speed. The two aerodisk spiked configurations show better results in terms of aerodynamic heating and drag in comparison to the single-disk aerospikes while the three-disk spikes yield only a marginal reduction in aerodynamic drag over the two-disk configurations. For reduction of heat fluxes and heat transfer rates though, the three-disk configurations are extremely advantageous and give much larger reductions are compared to the two-disk configurations.
Time accurate numerical simulations were conducted to investigate the effect of triangular cavities on the unsteady aerodynamic characteristics of NACA 0012 airfoil at a Reynolds number of 50,000. Right-angled triangular cavities are placed at 10%, 25% and 50% chord location on the suction and have depths of 0.025c and 0.05c, measured normal to the surface of the airfoil. The second-order accurate solution to the RANS equations is obtained using a pressure-based finite volume solver with a four-equation transition turbulence model, γ–Re θt, to model the effect of turbulence. The two-dimensional results suggest that the cavity of depth 0.025c at 10% chord improves the aerodynamic efficiency ( l/d ratio) by 52%, at an angle of attack of α = 8°, wherein the flow is steady. The shallower triangular cavity when placed at 25%c and 50%c enhances the l/d ratio by only 10% and 17%, respectively, in the steady-state regime of angles of attack between α = 6° and 10°. The deeper cavity also enhances the l/d ratio by up to 13%, 22% and 14% at angles of attack between α = 6° and 10°. Even in the unsteady vortex shedding regime, at α =12° and higher, significant improvements in the time-averaged l/d ratios are observed for both cavity depths. The improvements in l/d ratio in the steady-state, pre-stall regime are primarily because of drag reduction while in the post-stall, unsteady regime, the improvements are because of enhancements in time-averaged C l values. The current finding can thus be used to enhance the aerodynamic performance of MAVs and UAVs that fly at low Reynolds numbers.
Need of micro aerial vehicles and Unmanned AirVehicles is increasing due to military, defense and civilian requirements. These vehicles fly at very small Reynolds numbers and have to move in confined spaces with a bare minimum speed, to achieve high lift coefficient is the main concern. The main focus of this research paper is to carry out the computational analysis and study the unsteady flow over NACA0012 airfoil with right angle triangular protrusion at the Reynolds number 10 5 . The location of the protrusion is 0.05c, with three different heights of protrusion 0.005c, 0.01c, and 0.02c, normal to the surface of the airfoil. Geometric modeling and grid generation are created using the ICEM CFD software and numerical analysis carried out using CFD Software at various angle of attacks ranging from 0 0 to 16 0 with 2 0 intervals. Numerical validation has done and compared. The results obtained from the research work is recommend that for smaller protrusions the lift and drag coefficients are unaffected in the low angle of attacks while the lift characteristic is significantly improved at the higher angle of attacks.Numerical Analysis of Protrusion Effect over an Airfoil at Reynolds Number -10 5 2584 Fusion Technologies, advanced nuclear methods. He has written over 50 papers, 30 opinion articles and 4 books on future of space technology and nuclear technology. Dr. Guven has taught wide range of courses and he is coordinator in an Experimental Nanosatellite project.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.