The effect(s) of SO 2 on the two types of active sites on Cu-SSZ-13 NH 3 −SCR catalysts, Z2Cu and ZCuOH, were investigated. Two Cu-SSZ-13 catalysts with Si:Al ratios of 6 and 30 were synthesized, and they provide very different distributions of these two active sites. Inductively coupled plasma optical emission spectroscopy (ICP-OES), H 2 temperature-programmed reduction (H 2 -TPR), and diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS) were utilized to characterize catalyst samples and quantify the amounts of total Cu, Z2Cu and ZCuOH. In situ DRIFTS results show that Z2Cu and ZCuOH responses to low-temperature (<200 °C) SO 2 poisoning were site-dependent. Results of SO 2 and SO 2 + NH 3 temperatureprogrammed desorption (TPD) and DRIFTS experiments, supplemented with DFT calculations, revealed that the different observed responses correspond to different sulfur intermediates that form. On Z2Cu sites, SO 2 only adsorbs when it is cofed with NH 3 via formation of ammonium sulfate, with its fingerprint TPD feature at 380 °C. However, low-temperature interaction between SO 2 and ZCuOH leads to copper bisulfite species formation, which can be further oxidized to form copper bisulfate with increasing temperature. In terms of low-temperature SCR functionality, the activity of both Cu-SSZ-13 samples were found to be significantly inhibited by SO 2 . However, in terms of regeneration (i.e., desulfation) behavior, Cu-SSZ-13 with a Si:Al = 30 (higher ZCuOH compared to Z2Cu) seemed to require higher desulfation temperatures (>550 °C). Therefore, compared with Z2Cu, ZCuOH sites are more susceptible to severe low-temperature SO 2 poisoning because of the formation of more stable bisulfite and ultimately bisulfate species.

No abstract

Chelating ionic liquids (ILs), in which polyether chains are pendent from the organic pyrrolidinium cation of the ILs (PEGylated ILs), were prepared that facilitate reversible electrochemical deposition/dissolution of Mg from a Mg(BH4)2 source. Mg electrodeposition processes in two specific PEGylated-ILs were compared against that in the widely studied N-butyl-N-methylpyrrolidinium bis(trifluoromethylsulfonyl)imide ionic liquid (BMPyrTFSI). The two chelating IL systems (one with a pendent polyether chain with three ether oxygens, MPEG3PyrTFSI, and the other with a seven-ether chain, MPEG7PyrTFSI) showed substantial improvement over BMPyrTFSI for Mg electrodeposition/dissolution. The best overall electrochemical performance was in MPEG7PyrTFSI. X-ray diffraction (XRD), scanning electron microscopy (SEM), and energy dispersive X-ray spectroscopy (EDS) were used to characterize galvanostatically deposited Mg, revealing production of pure, dendrite-free Mg deposits. Reversible Mg electrodeposition was achieved with high Coulombic efficiency (CE) of 90% and high current density (ca. 2 mA/cm(2) for the stripping peak). Raman spectroscopy was used to characterize Mg(2+) speciation in the PEGylated ILs and BMPyrTFSI containing Mg(BH4)2 by study of Raman modes of the coordinated and free states of borohydride, TFSI(-), and polyether COC groups. Quantitative analysis revealed that the polyether chains can displace both TFSI(-) and BH4(-) from the coordination sphere of Mg(2+). Comparison of the different IL electrolytes suggested that these displacement reactions may play a role in enabling Mg deposition/dissolution with high CE and current density in these PEGylated IL media. These results represent the first demonstration of reversible electrochemical deposition/dissolution of Mg in an ionic liquid specifically designed with this task in mind.

No abstract

SO2 poisoning of NH3-SCR over Cu-SAPO-34 was studied, specifically to evaluate the forms/states of stored S and the effect of such species on low-temperature NO x reduction activity. Two primary sulfur species types were observed and were found to be interchangeable depending on whether NH3 was available or not. In one case both ammonium sulfate and Cu sulfate species could be present and in the other only Cu sulfate species. Cu sulfate, in the absence of ammonia, was found in three different states/forms, identified by three desorption features during temperature-programmed desorption (TPD) experiments. Diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS) of NO adsorption was used to investigate the nature and accessibility of the Cu species before and after sulfate formation, without the interference of ammonium sulfate; these data revealed that the Cu2+ inside the six-membered rings was completely blocked by sulfur and that the nature of the [CuOH]+ close to the eight-membered ring changed. In comparing the effect of different forms of S on low-temperature NO x reduction activity, ammonium sulfate had the greatest impact on performance loss. Interestingly, the results also show that ammonium sulfate can actually play a role as a SCR reactant, likely analogous to the mechanism involving ammonium nitrate. Ammonium sulfate decomposes at temperatures as low as ∼300–350 °C, whereas higher temperatures (>480 °C) were needed to desorb other S-containing species. This appears favorable, as NH3 can react with preadsorbed sulfur on the catalyst to form ammonium sulfate, which decomposes at lower temperatures in comparison to the other sulfate forms.

No abstract

No abstract

No abstract