Intermittent energy sources, including solar and wind, require scalable, low‐cost, multi‐hour energy storage solutions in order to be effectively incorporated into the grid. All‐Organic non‐aqueous redox‐flow batteries offer a solution, but suffer from rapid capacity fade and low Coulombic efficiency due to the high permeability of redox‐active species across the battery's membrane. Here we show that active‐species crossover is arrested by scaling the membrane's pore size to molecular dimensions and in turn increasing the size of the active material above the membrane's pore‐size exclusion limit. When oligomeric redox‐active organics (RAOs) were paired with microporous polymer membranes, the rate of active‐material crossover was reduced more than 9000‐fold compared to traditional separators at minimal cost to ionic conductivity. This corresponds to an absolute rate of RAO crossover of less than 3 μmol cm−2 day−1 (for a 1.0 m concentration gradient), which exceeds performance targets recently set forth by the battery industry. This strategy was generalizable to both high and low‐potential RAOs in a variety of non‐aqueous electrolytes, highlighting the versatility of macromolecular design in implementing next‐generation redox‐flow batteries.
Redox flow batteries (RFBs) present unique opportunities for multi-hour electrochemical energy storage (EES) at low cost. Too often, the barrier for implementing them in large-scale EES is the unfettered migration of redox active species across the membrane, which shortens battery life and reduces Coulombic efficiency. To advance RFBs for reliable EES, a new paradigm for controlling membrane transport selectivity is needed. We show here that size- and ion-selective transport can be achieved using membranes fabricated from polymers of intrinsic microporosity (PIMs). As a proof-of-concept demonstration, a first-generation PIM membrane dramatically reduced polysulfide crossover (and shuttling at the anode) in lithium-sulfur batteries, even when sulfur cathodes were prepared as flowable energy-dense fluids. The design of our membrane platform was informed by molecular dynamics simulations of the solvated structures of lithium bis(trifluoromethanesulfonyl)imide (LiTFSI) vs lithiated polysulfides (Li2Sx, where x = 8, 6, and 4) in glyme-based electrolytes of different oligomer length. These simulations suggested polymer films with pore dimensions less than 1.2-1.7 nm might incur the desired ion-selectivity. Indeed, the polysulfide blocking ability of the PIM-1 membrane (∼0.8 nm pores) was improved 500-fold over mesoporous Celgard separators (∼17 nm pores). As a result, significantly improved battery performance was demonstrated, even in the absence of LiNO3 anode-protecting additives.
A series of divalent first row triflate complexes supported by the ligand tris(2-pyridylmethyl)amine (TPA) have been investigated as oxygen reduction catalysts for fuel cell applications. [(TPA)M(2+)](n+) (M = Mn, Fe, Co, Ni, and Cu) derivatives were synthesized and characterized by X-ray crystallography, cyclic voltammetry, NMR spectroscopy, magnetic susceptibility, IR spectroscopy, and conductance measurements. The stoichiometric and electrochemical O(2) reactivities of the series were examined. Rotating-ring disk electrode (RRDE) voltammetry was used to examine the catalytic activity of the complexes on a carbon support in acidic media, emulating fuel cell performance. The iron complex displayed a selectivity of 89% for four-electron conversion and demonstrated the fastest reaction kinetics, as determined by a kinetic current of 7.6 mA. Additionally, the Mn, Co, and Cu complexes all showed selective four-electron oxygen reduction (<28% H(2)O(2)) at onset potentials (~0.44 V vs RHE) comparable to state of the art molecular catalysts, while being straightforward to access synthetically and derived from nonprecious metals.
Photochemical route to actinide-transition metal bonds: synthesis,characterization and reactivity of a series of thoriumand uranium heterobimetallic complexes Permalink https://escholarship.org/uc/item/5qz819w8
The first examples of actinide complexes incorporating corrole ligands are presented. Thorium(IV) and uranium(IV) macrocycles of Mes2(p-OMePh)corrole were synthesized via salt metathesis with the corresponding lithium corrole in remarkably high yields (93% and 83%, respectively). Characterization by single-crystal X-ray diffraction revealed both complexes to be dimeric, having two metal centers bridged via bis(μ-chlorido) linkages. In each case, the corrole ring showed a large distortion from planarity, with the Th(IV) and U(IV) ions residing unusually far (1.403 and 1.330 Å, respectively) from the N4 plane of the ligand. (1)H NMR spectroscopy of both the Th and U dimers revealed dynamic solution behavior. In the case of the diamagnetic thorium corrole, variable-temperature, DOSY (diffusion-ordered) and EXSY (exhange) (1)H NMR spectroscopy was employed and supported that this behavior was due to an intrinsic pseudorotational mode of the corrole ring about the M-M axis. Additionally, the electronic structure of the actinide corroles was assessed using UV-vis spectroscopy, cyclic voltammetry, and variable-temperature magnetic susceptibility. This novel class of macrocyclic complexes provides a rich platform in an underdeveloped area for the study of nonaqueous actinide bonding and reactivity.
Intermittent energy sources, including solar and wind, require scalable, low‐cost, multi‐hour energy storage solutions in order to be effectively incorporated into the grid. All‐Organic non‐aqueous redox‐flow batteries offer a solution, but suffer from rapid capacity fade and low Coulombic efficiency due to the high permeability of redox‐active species across the battery's membrane. Here we show that active‐species crossover is arrested by scaling the membrane's pore size to molecular dimensions and in turn increasing the size of the active material above the membrane's pore‐size exclusion limit. When oligomeric redox‐active organics (RAOs) were paired with microporous polymer membranes, the rate of active‐material crossover was reduced more than 9000‐fold compared to traditional separators at minimal cost to ionic conductivity. This corresponds to an absolute rate of RAO crossover of less than 3 μmol cm−2 day−1 (for a 1.0 m concentration gradient), which exceeds performance targets recently set forth by the battery industry. This strategy was generalizable to both high and low‐potential RAOs in a variety of non‐aqueous electrolytes, highlighting the versatility of macromolecular design in implementing next‐generation redox‐flow batteries.
Selective ion transport across membranes
is critical to the performance
of many electrochemical energy storage devices. While design strategies
enabling ion-selective transport are well-established, enhancements
in membrane selectivity are made at the expense of ionic conductivity.
To design membranes with both high selectivity and high ionic conductivity,
there are cues to follow from biological systems, where regulated
transport of ions across membranes is achieved by transmembrane proteins.
The transport functions of these proteins are sensitive to their environment:
physical or chemical perturbations to that environment are met with
an adaptive response. Here we advance an analogous strategy for achieving
adaptive ion transport in microporous polymer membranes. Along the
polymer backbone are placed redox-active switches that are activated
in situ, at a prescribed electrochemical potential, by the device’s
active materials when they enter the membrane’s pore. This
transformation has little influence on the membrane’s ionic
conductivity; however, the active-material blocking ability of the
membrane is enhanced. We show that when used in lithium–sulfur
batteries, these membranes offer markedly improved capacity, efficiency,
and cycle-life by sequestering polysulfides in the cathode. The origins
and implications of this behavior are explored in detail and point
to new opportunities for responsive membranes in battery technology
development.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.