Shallow embankment slopes are commonly used to support elements of transport infrastructure in seismic regions. In this paper, the seismic performance of such slopes in non-liquefiable granular soils is considered, focusing on permanent movement and dynamic motion at the crest, which would form key inputs into the aseismic design of supported infrastructure. In contrast to previous studies, the evolution of this behaviour under multiple sequential strong ground motions is studied through dynamic centrifuge, numerical (finite-element, FE) and analytical (sliding-block) modelling, the centrifuge tests being used to validate the two non-physical approaches. The FE models focus on the specification of model parameters for existing non-linear constitutive models using routine site investigation data, allowing them to be used routinely in design and analysis. Soil-specific constitutive parameters are derived from shearbox and oedometer test data, and are found to significantly outperform existing empirical correlations based on relative density, highlighting the importance of specifying a suitably detailed site investigation. An improved sliding-block ('Newmark') approach is also developed for estimating permanent deformations during preliminary design, in which the formulation of the yield acceleration is fully strain-dependent, incorporating both material hardening/ softening and geometric hardening (re-grading). The site-specific (improved) FE models and the new sliding-block approach are shown to outperform considerably existing FE parameters and sliding-block models in capturing the permanent deformations of the slope under virgin conditions, and further, only the improved FE and sliding-block models are found to capture correctly the behaviour of the 'damaged' slope under subsequent earthquakes (e.g. strong aftershocks). The FE models can additionally accurately replicate the settlement profile at the crest and quantify the dynamic motions that would be input to supported structures, although these were generally overpredicted. The FE procedures and sliding-block models are therefore complementary, the latter being useful for preliminary design and the former for later detailed design and analysis.
The offshore wind energy sector faces new challenges as it moves into deeper water deployment. To meet these challenges, new and efficient foundation solutions are required. One potential solution is to upscale onshore screw piles but they require verification of performance for new geometries and demanding loading regimes. This paper presents a three-dimensional finite-element analysis investigation of screw pile behaviour when subjected to combined vertical and lateral loading in sand. In the investigation, the screw pile length and helical plate diameter were varied on piles with a fixed core diameter while subjecting the piles to combined axial and lateral loading. The results were compared with results from straight shafted piles with the same core diameter. The results of the analysis revealed that vertical compression loads increased the lateral capacity of the screw piles whereas vertical uplift loads marginally reduced the lateral capacity. The downside of this enhanced lateral capacity is that the screw piles experience higher bending moments. This suggests that, when using screw piles for offshore foundation applications, structures should be designed to maintain axial compressive loads on the piles and induced bending moments need to be adequately assessed when deciding on appropriate structural sections.
Re: Submission of revised manuscript for publication in Soil Dynamics and Earthquake Engineering: "Newmark sliding block model for pile-reinforced slopes under earthquake loading" (Revision 2) My co-author and I hereby submit the above named revised manuscript for publication in Soil Dynamics and Earthquake Engineering as a full technical paper. We have included a full response to the reviewers' additional minor comments.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.