This study investigated that the effect of aging treatments on wear behavior of functionally graded material (FGM) that was reinforced via being integrated with aluminum 2014 alloy (AlCu4SiMg) and 15 vol% SiC. The specimens were obtained via centrifugal casting technique, and then two different aging treatments were applied. Wear experiments were applied at 1.256 m/s constant sliding velocity, under two different loads and two different sliding distances for each condition via a pin-on-disc wear apparatus. The variations that occurred on wear behavior of cast and aged materials were analyzed. The results show that the minimum wear loss values were obtained under dry sliding conditions due to the aging processes. On the other hand, with increasing sliding distances under wet sliding conditions, the aging processes' effect was decreased on wear resistance.
This study presents a low-cost and environmentally friendly medium for the pack boriding (boronizing) of a Ti6Al4V alloy. Titanium and its alloys are known to be highly reactive and to have extreme oxygen affinity. Therefore, boriding is performed under vacuum or in protective atmospheric conditions. This work evaluated the pack boriding heat treatments of a Ti6Al4V alloy under atmospheric conditions via the various boriding media used by previous researchers. In addition, a new pack boriding medium was developed by adding aluminum. Consequently, this study demonstrated that it is possible to obtain an undamaged titanium surface by applying solid-state boriding under atmospheric conditions.
This study investigated the mechanical properties of aluminum matrix functionally graded material (FGM) reinforced by integration of aluminum 2014 alloy (AlCu4SiMg) and 15 vol% SiC. The specimens were obtained by centrifugal casting technique, followed by aging treatment. The variations that occurred in microstructure, hardness, Young’s modulus, tensile strength, yield strength, elongation, fatigue, and fretting fatigue behaviors were analyzed. In both cast and aged conditions, it was observed that hardness values and mechanical properties changed between SiC-rich and aluminum-rich regions. Fatigue and fretting fatigue data were similar. It was determined that greater wear was occurring on the pad surfaces compared to that occurring on the sample surfaces.
This study aims to demonstrate the effects of pulsed current on the welding pool and fusion zone microstructures of the aluminum 2014 alloy matrix composite material reinforced with 14 and 20 vol% SiC particles. A programmable synergic controlled MIG welding machine with pulsed power supply was used. One hundred Ampere and 120 Ampere pulsed current values were used to determine the effect of heat input on microstructures. A 1 mm diameter SG‐AlSi5 wire was used as filler material. The microstructures were studied using a scanning electron microscope (SEM) with energy dispersive X‐ray (EDX) spectroscopy, and the phase analyses were performed via X‐ray diffraction analyzer (XRD). The study showed that increasing the SiC rate has a greater effect on the formation of Al4C3 phase than increasing the heat input values. Al4C3 formation was not formed as a needle‐like structure.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.