The influence of feeding system and lactation period on the gross composition, macroelements (Ca, P, Mg, and Na), and trace elements (Zn, Fe, Cu, Mo, Mn, Se, and Co) of bovine milk was investigated. The feeding systems included outdoor grazing on perennial ryegrass pasture (GRO), outdoor grazing on perennial ryegrass and white clover pasture (GRC), and indoors offered total mixed ration (TMR). Sixty spring-calving Holstein Friesian dairy cows were assigned to 3 herds, each consisting of 20 cows, and balanced with respect to parity, calving date, and pre-experimental milk yield and milk solids yield. The herds were allocated to 1 of the 3 feeding systems from February to November. Milk samples were collected on 10 occasions over the period June 17 to November 26, at 2 or 3 weekly intervals, when cows were on average 119 to 281 d in lactation (DIL). The total lactation period was arbitrarily sub-divided into 2 lactation periods based on DIL, namely mid lactation, June 17 to September 9 when cows were 119 to 203 DIL; and late lactation, September 22 to November 26 when cows were 216 to 281 DIL. With the exception of Mg, Na, Fe, Mo, and Co, all other variables were affected by feeding system. The GRO milk had the highest mean concentrations of total solids, total protein, casein, Ca, and P. The TMR milk had the highest concentrations of lactose, Cu, and Se, and lowest level of total protein. The GRC milk had levels of lactose, Zn, and Cu similar to those of GRO milk, and concentrations of TS, Ca, and P similar to those of TMR milk. Lactation period affected all variables, apart from the concentrations of Fe, Cu, Mn, and Se. On average, the proportion (%) of total Ca, P, Zn, Mn, or Se that sedimented with the casein on high-speed ultracentrifugation at 100,000 × g was ≥60%, whereas that of Na, Mg, or Mo was ≤45% total. The results demonstrate how the gross composition and elemental composition of milk can be affected by different feeding systems.

This study investigated the effects of 3 dairy cow feeding systems on the composition, yield, and biochemical and physical properties of low-moisture part-skim Mozzarella cheese in mid (ML; May-June) and late (LL; October-November) lactation. Sixty spring-calving cows were assigned to 3 herds, each consisting of 20 cows, and balanced on parity, calving date, and pre-experimental milk yield and milk solids yield. Each herd was allocated to 1 of the following feeding systems: grazing on perennial ryegrass (Lolium perenne L.) pasture (GRO), grazing on perennial ryegrass and white clover (Trifolium repens L.) pasture (GRC), or housed indoors and offered total mixed ration (TMR). Mozzarella cheese was manufactured on 3 separate occasions in ML and 4 in LL in 2016. Feeding system had significant effects on milk composition, cheese yield, the elemental composition of cheese, cheese color (green to red and blue to yellow color coordinates), the extent of flow on heating, and the fluidity of the melted cheese. Compared with TMR milk, GRO and GRC milks had higher concentrations of protein and casein and lower concentrations of I, Cu, and Se, higher cheese-yielding capacity, and produced cheese with lower concentrations of the trace elements I, Cu, and Se and higher yellowness value. Cheese from GRO milk had higher heat-induced flow and fluidity than cheese from TMR milk. These effects were observed over the entire lactation period (ML + LL), but varied somewhat in ML and LL. Feeding system had little, or no, effect on gross composition of the cheese, the proportions of milk protein or fat lost to cheese whey, the texture of the unheated cheese, or the energy required to extend the molten cheese. The differences in color and melt characteristics of cheeses obtained from milks with the different feeding systems may provide a basis for creating points of differentiation suited to different markets.

Low-heat skim milk powder (LHSMP) was manufactured on 3 separate occasions in mid lactation (ML, and late lactation (LL, September 27 to October 7) from bulk milk of 3 spring-calving dairy herds on different feeding systems: grazing on perennial ryegrass (Lolium perenne L.) pasture (GRO), grazing on perennial ryegrass and white clover (Trifolium repens L.) pasture (GRC), and housed indoors and offered total mixed ration (TMR). The resultant powders (GRO-SMP, GRC-SMP, and TMR-SMP) were evaluated for composition and color and for the compositional, physicochemical, and processing characteristics of the reconstituted skim milk (RSM) prepared by dispersing the powders to 10% (wt/wt) in water. Feeding system significantly affected the contents of protein and lactose, the elemental composition, and the color of the LHSMP, as well as the rennet gelation properties of the RSM. The GRO and GRC powders had a higher protein content; lower levels of lactose, iodine, and selenium; and a more yellow-green color (lower a* and higher b* color coordinates) than TMR powder. On reconstitution, the GRO-RSM had higher concentrations of protein, casein, and ionic calcium, and lower concentrations of lactose and nonprotein nitrogen (% of total N). It also produced rennet gels with a higher storage modulus (G′) than the corresponding TMR-RSM. These effects were observed over the combined ML and LL period but varied somewhat during the separate ML and LL periods. Otherwise, feeding system had little or no effect on proportions of individual caseins, concentration of serum casein, casein micelle size, casein hydration, heat coagulation time, or ethanol stability of the RSM at pH 6.2 to 7.2, or on the water-holding capacity, viscosity, and flow behavior of stirred yogurt prepared by starter-induced acidification of RSM. The differences in the functionality of the LHSMP may be of greater or lesser importance depending on the application and the conditions applied during the processing of the RSM.