This article deals with the creation of a power supply system of wireless sensors which take measurements and transmit data at time intervals, the duration of which is considerably less than the activation period of sensors. The specific feature of the power supply system is the combined use of devices based on various physical phenomena. Electrical energy is generated by thermoelectrochemical cells. The temperature gradient on the sides of these cells is created by a vortex tube. A special boost DC/DC converter provides an increase in the output voltage of thermoelectrochemical cells up to the voltage that is necessary to power electronic devices. A supercapacitor is used to store energy in the time intervals between sensor activation. A study of an experimental sample of the power supply system for wireless sensors was conducted. Using the model in MATLAB + Simulink program, the possibility and conditions for creating the considered system for a particular type of wireless sensor were shown.
The technological installations’ characteristics are possible to improve by equipping fans with a frequency-controlled electric drive. However, it can lead to an electromagnetic compatibility problem in the electrical supply system. This problem becomes worse if a large number of fans are included in the technological installation and the electric drives are powered from a substation connected to a limited power source. As an example, in this article we investigate the power supply system of a gas cooling unit with variable-frequency electric drives for fans. The electric drives’ operating mode dependences characterizing the non-sinusoidal voltages and currents of the power source are obtained with the help of simulation modeling in the MATLAB environment with the Simulink expansion package. The typical substation circuit usage for the power supply of a group of fans with a frequency-controlled drive does not meet the requirements of IEEE Standard 519-2014. We can solve the problem of electromagnetic compatibility by changing the substation topology and organizing DC busbars and replacing frequency converters with inverters. We proposed forming DC busbars using 12-pulse rectifiers powered by transformers with two secondary windings with different connection schemes. The simulation results confirmed that the proposed substation topology provides the voltage and current harmonics level on the substation power busbars in accordance with the IEEE Standard 519-2014 requirements over the entire frequency range of the fans’ motor control.
The current level of power electronics development allows creating and implementing new technologies for generation, transmission and distribution of electricity. Electric machines with variable shaft speed can be used as an energy source now. The functions of providing the parameters of the generated electric power are transferred to the converter devices. The combination of controlled energy sources and electrical receivers in microgrids allows reducing energy losses, increasing the reliability of electricity supply. The article is devoted to the constructions of a microgrid based on several autonomously operating synchronous generators. As an example, microgrid for power supply of compressor station based on own use generators of gas compressor units is considered.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.