Laser spectroscopic studies of elements in the heavy actinide and transactinide region help understand the nuclear ground state properties of these heavy systems. Pioneering experiments at GSI, Darmstadt identified the first atomic transitions in the element nobelium. For the purpose of determining nuclear properties in nobelium isotopes with higher precision, a new apparatus for high-resolution laser spectroscopy in a gas-jet called JetRIS is under development. To determine the spectral resolution and the homogeneity of the gas-jet, the laser-induced fluorescence of 164Dy atoms seeded in the jet was studied. Different hypersonic nozzles were investigated for their performance in spectral resolution and efficiency. Under optimal conditions, a spectral linewidth of about 200–250 MHz full width at half maximum and a Mach number of about 7 was achieved, which was evaluated in context of the density profile of the atoms in the gas-jet.

No abstract

No abstract

The In-Gas-jet Laser Ionization and Spectroscopy (IGLIS) technique relies on narrow-bandwidth, high-peakpower, short-pulse-length (≈ 10 ns) and high-repetition-rate laser pulses to probe, precisely and efficiently, the hyperfine structure of medium-heavy and heavy isotopes, embedded in a supersonic jet. The power and repetition rate requirements of the laser system are met by combining ≈ 100 W, 8 ns pulse width, 10 kHz commercial Nd:YAG pump lasers with a single-mode continuous wave (cw) seeded Pulsed Dye Amplifier (PDA). The common multi-longitudinal-mode operation of these Nd:YAG pump lasers causes, however, undesirable frequency sidebands in the output spectrum of the PDA system, hindering the attainable spectral resolution, a correct interpretation and an accurate analysis of the hyperfine spectra. In this article, a new prototype Nd:YAG laser is presented, which combined with the PDA system, is capable of providing quasi transform-limited laser pulses at 10 kHz, with only limited losses in laser power. This system reduces any spectral sideband amplitude below a proven upper limit of 0.2% with one order of magnitude extra reduction expected based on simulations. A full characterization of both the Nd:YAG and PDA laser systems is done by studying the temporal and frequency behavior in detail. The study is finalized by a performance benchmark of this combined laser system in the hyperfine spectroscopy of copper isotopes, showcasing its applicability for future IGLIS studies.

We present the first results obtained from the S3 Low-Energy Branch , the gas cell setup at SPIRAL2-GANIL, which will be installed behind the S3 spectrometer for atomic and nuclear spectroscopy studies of exotic nuclei. The installation is currently being commissioned offline, with the aim to establish optimum conditions for the operation of the radio frequency quadrupole ion guides, mass separation and ion bunching, providing high-efficiency and low-energy spatial spread for the isotopes of interest. Transmission and mass-resolving power measurements are presented for the different components of the S3-LEB setup. In addition, a single-longitudinal-mode, injection-locked, pumped pulsed-titanium–sapphire laser system has been recently implemented and is used for the first proof-of-principle measurements in an offline laser laboratory. Laser spectroscopy measurements of erbium, which is the commissioning case of the S3 spectrometer, are presented using the 4f126s23H6→4f12(3H)6s6p optical transition.