Dosímetros são detectores de radiação ionizante utilizados para mensurar a deposição de dose em um determinado local de interesse, sendo empregados para a monitoração de IOE ou investigações dosimétricas. TLD (LiF:Mg,Ti) é um dosímetro termoluminescente constituído de material dopado que possui propriedade luminescente. A dopagem cria barreiras de potencial na região proibida ou também chamado de gap de energia. A luminescência é o fenômeno que corresponde a reemissão na forma luz devido a exposição à radiação externa incidente. No processo de leitura dos TLDs o aquecimento promove o estímulo energético para que ocorra a transição entre os diferentes estados de energia das bandas do dosímetro. A luz emitida é captada através do leitor e a partir da curva de calibração é possível correlacionar a dose depositada durante uma exposição ou irradiação. O processo de calibração consiste em limpar os TLDs submetendo-os a um tratamento térmico adequado e posteriormente irradiá-los em um feixe de referência com dose específica, correlacionando o número de contagens registradas. O objetivo do trabalho é investigar se existe influência na linearidade e dependência energética na calibração realizada para os TLDs utilizando duas fontes distintas: 137 Cs do laboratório de calibração de Dosímetros do Centro de Desenvolvimento da Tecnologia Nuclear (LCD/CDTN) e com o feixe de 6 MV do Acelerador Linear ELEKTA (LINAC, do inglês Linear Particle Accelerator). Um conjunto de 10 TLDs foram posicionados a uma distância de 150 cm da fonte de 137 Cs sendo irradiados com doses de 10, 40, 200 e 500 mGy. No feixe de 6 MV do LINAC, foram irradiados um conjunto de 3 TLDs para cada uma das seguintes doses 600, 800, 1000, 1200 e 1400 mGy. Os TLDs foram posicionados entre duas placas de água sólida a uma distância de 100 cm da fonte. Uma curva de calibração foi obtida para os resultados de doses de radiação dos dois diferentes arranjos experimentais. A linearidade e dependência energética foram observadas na curva de calibração, garantindo a precisão e qualidade para as investigações dosimétricas.
Total body irradiation (TBI) is a treatment modality of radiotherapy. It can be used for immunosuppression of transplanted patients or for metastatic protocols. In this study, TBI was performed using the anthropomorphic Alderson-Rando phantom filled with thermoluminescent dosimeters (TLDs) and irradiated with a 6 MV photon beam from the Elekta linear accelerator in two different setups, one at the hospital São Francisco, BH, MG and second at the hospital Santa Casa in Lavras, MG. The dose distribution in the left and right lungs was estimated, analyzed, and compared with results from the literature. Our results showed that dose homogeneity is more adequate with dual-field irradiation.
Positioning and immobilization tools are considered essential components of radiotherapy treatments to guarantee that the planned dose distribution can be efficiently reached. However, the benefits brought by their use are met by an apparent increase in the patient skin entrance dose. In the current study, we evaluated the dose surface effects provoked by the use of immobilization thermoplastic masks in head and neck radiotherapy treatments, carried out using a 6‐MV linear accelerator beam. The study was carried out using an anthropomorphic head–neck phantom and three dosimetric techniques: (i) thermoluminescent dosimetry (TL); (ii) radiochromic film dosimetry; and (iii) computational simulation using the pencil beam convolution (PBC) method. For calibration purposes, TLD chips and radiochromic (EBT3) small 2.0‐cm2 strip dosimeters were positioned between two virtual solid water plates, and exposed to absorbed doses ranging from 25 to 200 cGy. The use of an anthropomorphic head–neck phantom allows the dose variation in non‐flat surfaces to be taken into account. TLD chips, positioned on the surface of the supraclavicular fossa anatomical region, covered with a thermoplastic mask, detected an entrance skin dose that was approximately 38.4% higher than that measured without a mask. The EBT3 dosimeters, averaged among all strips used, also detected a medium increase of 58.6%. Both TLD and EBT3 detected increased doses for all measured points, and measured similar averaged surface doses without the use of immobilization masks; that is, 50.5% for EBT3 and 53.7% for TLD‐100. The pencil beam convolution simulation results suggested an increase for most of the measured points; however, no increased, and in some cases even decreased, doses were observed. The surface dose data of three other commercial thermoplastic masks irradiated in a solid water phantom are also provided.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
334 Leonard St
Brooklyn, NY 11211
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.