Because of the increasing importance of heavy and unconventional crude oil as an energy source, there is a growing need for petroleomics: the pursuit of more complete and detailed knowledge of the chemical compositions of crude oil. Crude oil has an extremely complex nature; hence, techniques with ultra-high resolving capabilities, such as Fourier transform ion cyclotron resonance mass spectrometry (FT-ICR MS), are necessary. FT-ICR MS has been successfully applied to the study of heavy and unconventional crude oils such as bitumen and shale oil. However, the analysis of crude oil with FT-ICR MS is not trivial, and it has pushed analysis to the limits of instrumental and methodological capabilities. For example, high-resolution mass spectra of crude oils may contain over 100,000 peaks that require interpretation. To visualize large data sets more effectively, data processing methods such as Kendrick mass defect analysis and statistical analyses have been developed. The successful application of FT-ICR MS to the study of crude oil has been critically dependent on key developments in FT-ICR MS instrumentation and data processing methods. This review offers an introduction to the basic principles, FT-ICR MS instrumentation development, ionization techniques, and data interpretation methods for petroleomics and is intended for readers having no prior experience in this field of study.

The various components of crude oil were structurally resolved using an atmospheric-pressure solids analysis probe (ASAP) coupled with ion mobility mass spectrometry (IM-MS). An ASAP source was used to broadly fractionate compounds according to their boiling points, thereby simplifying the resulting mass spectra for easier data interpretation. The m/z-mobility plots obtained by IM-MS analysis of crude oil could be used to find the structural relationship between crude oil molecules. That was demonstrated using ion mobility mass spectra from a homologous series of compounds, differing only by the number of alkyl units, found in crude oil. The peaks from this series were linearly aligned in the plot, suggesting a continuous increase of the collisional cross section with an increase of mass values and hence the absence of significant structural differences within the series. In contrast, peaks in a homologous series differing only in the number of pendant hydrogen atoms were not linearly aligned, suggesting a discontinuous increase of the collisional cross section with an increase of mass values and hence significant structural differences due to the addition or removal of hydrogen. Cases in which a slope change was observed at three- or four-peak intervals may be related to the addition of an aromatic ring to existing structures. Overall, ion mobility mass spectrometry demonstrates a useful tool that can be used to elucidate structural relationships between molecules comprising crude oil.

The isotopic exchange approach is in use since the first observation of such reactions in 1933 by Lewis. This approach allows the investigation of the pathways of chemical and biochemical reactions, determination of structure, composition, and conformation of molecules. Mass spectrometry has now become one of the most important analytical tools for the monitoring of the isotopic exchange reactions. Investigation of conformational dynamics of proteins, quantitative measurements, obtaining chemical, and structural information about individual compounds of the complex natural mixtures are mainly based on the use of isotope exchange in combination with high resolution mass spectrometry. The most important reaction is the Hydrogen/Deuterium exchange, which is mainly performed in the solution. Recently we have developed the approach allowing performing of the Hydrogen/Deuterium reaction on-line directly in the ionization source under atmospheric pressure. Such approach simplifies the sample preparation and can accelerate the exchange reaction so that certain hydrogens that are considered as non-labile will also participate in the exchange. The use of in-ionization source H/D exchange in modern mass spectrometry for structural elucidation of molecules serves as the basic theme in this review. We will focus on the mechanisms of the isotopic exchange reactions and on the application of in-ESI, in-APCI, and in-APPI source Hydrogen/Deuterium exchange for the investigation of petroleum, natural organic matter, oligosaccharides, and proteins including protein-protein complexes. The simple scenario for adaptation of H/D exchange reactions into mass spectrometric method is also highlighted along with a couple of examples collected from previous studies.

Ultrahigh-resolution mass spectrometry has allowed the determination of elemental formulas of the compounds comprising crude oils. However, elucidating molecular structures remains an analytical challenge. Herein, we propose and demonstrate an approach combining ion mobility mass spectrometry (IM-MS), ultrahigh-resolution mass spectrometry, and theoretical collisional cross-section (CCS) calculations to determine the molecular structures of aromatic compounds found in crude oils. The approach is composed of three steps. First, chemical structures are suggested based on the elemental formulas determined from ultrahigh-resolution mass spectra. Second, theoretical CCS values are calculated based on these proposed structures. Third, the calculated CCS values of the proposed structures are compared with experimentally determined CCS values from IM-MS data to provide proposed structures. For proof of concept, 31 nonalkylated and short-chain alkyl (n < 5, (CH2)n) aromatic compounds commonly observed in crude oils were analyzed. Theoretical and experimental CCS values matched within a 5% RMS error. This approach was then used to propose structures of compounds in selected m/z regions of crude oil samples. Overall, the combination of ion mobility mass spectrometry, ultrahigh-resolution mass spectrometry, and theoretical calculations was shown to be a useful tool for elucidating chemical structures of compounds in complex mixtures.

We report here for the first time the application of atmospheric pressure photo ionization hydrogen/deuterium exchange (APPI HDX) coupled to high-resolution mass spectrometry for molecular level speciation of nitrogen containing compounds in crude oils. The speciation was done based on different combinations of ions produced from nitrogen containing compounds with various functional groups. To prove the concept, 20 nitrogen containing standard compounds were analyzed. As a result, it was shown that the nitrogen containing compound (M) with a primary amine functional group mainly produced a combination of [M - 2H + 2D](•+) and ([M - 2H + 2D] + D)(+) ions, one with a secondary amine including alkylated or phenylated pyrrole a combination of [M - H + D](•+) and ([M - H + D] + D)(+), one with a tertiary amine including N-alkylated or phenylated pyrrole a combination of [M](•+) and [M + D](+), and one with a pyridine functional group mostly [M + D](+) ions. The concept was successfully applied to do nitrogen speciation of resins fractions of two oil samples. Combined with the subsequent investigation of double bond equivalence distribution, it was shown that resins of Qinhuangdao crude oil sample contained mostly alkylated pyrrole and N-alkylated pyrrole type compounds but resins of shale oil extract contained mostly pyridine type nitrogen compounds. It was also shown that the speciation of individual elemental composition was also possible by use of this method. Overall, this study clearly shows that atmospheric pressure photo ionization hydrogen/deuterium exchange (APPI HDX) coupled to high-resolution mass spectrometry is a powerful analytical method to do nitrogen speciation of crude oil compounds at the molecular level.

No abstract

In this study, the mechanism behind the generation of protonated polyaromatic hydrocarbon (PAH) ions without heteroatoms by atmospheric pressure photoionization (APPI) is investigated. Comparing data obtained by APPI of anthracene dissolved either in toluene or perdeuterated toluene suggests that toluene acts as a source of protons and that breakage of C-H bonds in the toluene molecule is important for the overall protonation reaction. Our data describing an Arrhenius-type temperature-dependent relationship between the signal intensities of molecular and protonated ions suggest a mechanistic relation between the generated molecular and protonated ions. The APPI protonation mechanism that best explains the observed phenomena is composed of two reactions: electron transfer followed by hydrogen transfer. This two-step mechanism for APPI was originally suggested by Syage (Syage, J. A. J. Am. Soc. Mass Spectrom. 2004, 15 , 1521-1533). Further quantum mechanical study shows that an energetically favorable ion-molecular complex can be generated as a result of electron transfer from toluene to PAH, which subsequently facilitates hydrogen transfer. This suggests that both electron transfer and hydrogen transfer can occur as a "concerted" reaction through the ion-molecular complex precursor state, which is consistent with experimental results. To our best knowledge, this is the first time that the dynamic nature of the APPI process is clearly revealed by combined experimental and quantum mechanical studies.

A previous study (Ahmed, A. et al., Anal. Chem. 84, 1146-1151( 2012) reported that toluene used as a solvent was the proton source for polyaromatic hydrocarbon compounds (PAHs) that were subjected to (+)-mode atmospheric-pressure photoionization. In the current study, the exact position of the hydrogen atom in the toluene molecule (either a methyl hydrogen or an aromatic ring hydrogen) involved in the formation of protonated PAH ions was investigated. Experimental analyses of benzene and anisole demonstrated that although the aromatic hydrogen atom of toluene did not contribute to the formation of protonated anthracene, it did contribute to the formation of protonated acridine. Thermochemical data and quantum mechanical calculations showed that the protonation of anthracene by an aromatic ring hydrogen atom of toluene is endothermic, while protonation by a methyl hydrogen atom is exothermic. However, protonation of acridine by either an aromatic ring hydrogen or a methyl hydrogen atom of toluene is exothermic. The different behavior of acridine and anthracene was attributed to differences in gas-phase basicity. It was concluded that both types of hydrogen in toluene can be used for protonation of PAH compounds, but a methyl hydrogen atom is preferred, especially for non-basic compounds.