Pembangkit Listrik Tenaga Mikrohidro (PLTMH) adalah suatu pembangkit listrik skala kecil yang menggunakan tenaga air. Komponen yang terpenting dalam pembangkit listrik mikrohidro adalah turbin. Turbin yang digunakan dalam pemodelan PLTMH ini adalah turbin Archimedes screw. Pada penelitian ini akan membahas mengenai pengaruh tekanan air terhadap putaran yang dihasilkan oleh turbin Archimedes screw sehingga dapat dilihat tegangan, arus, daya yang dihasilkan oleh generator, torsi dan efisiensi pada pemodelan PLTMH. Perubahan tekanan air yang diberikan yaitu sebesar 4 psi, 8 psi, 12 psi, 16 psi, 20 psi, dan 24 psi. Diperoleh hasil pengukuran tertinggi pada tekanan air 24 psi, dimana tegangan, arus, dan daya output yang dihasilkan generator yaitu sebesar 85,8 Volt, 0,1963 Ampere dan 16,85 Watt. Untuk kecepatan putaran generator pada tekanan 24 psi ini yaitu sebesar 4582 rpm, sedangkan kecepatan putaran turbin yang dihasilkan pada tekanan 24 psi ini yaitu sebesar 383 rpm sebelum dikopel dengan generator dan 222 rpm setelah dikopel dengan generator. Torsi dan efisiensi yang dihasilkan pada tekanan 24 psi yaitu sebesar 0,73 Nm dan 18,1%.
Ketergantungan pembangkit listrik terhadap sumber energi seperti minyak solar, gas alam dan batubara yang hampir mencapai 75%, mendorong dikembangkannya energi terbarukan sebagai upaya untuk memenuhi pasokan listrik. Pada penelitian ini telah dirancang pemodelan PLTMH menggunakan kincir overshot wheel dengan bentuk sudu setengah lingkaran, diameter kincir 50cm, dan 16 jumlah sudu. Pada pemodelan ini debit air 0,1 lt/s dan head 0,6 meter. Pengukuran yang dilakukan berdasarkan posisi jatuhnya air terhadap kincir, dari posisi sudut nozzle 00, 50, 100, 150, 200, 250, 300, 350 dan 400. Diperoleh hasil pengukuran tertinggi pada sudut nozzle 300, dimana daya output 0,153 W, torsi kincir 0,012 Nm, dan efisiensi 0,255. Debit air yang kecil membuat kinerja pemodelan PLTMH ini masih kurang maksimal, dimana torsi yang dihasilkan generator 0,032 Nm sedangkan torsi tertinggi pada kincir 0,012 Nm. Persentase error torsi pada pemodelan PLTMH ini adalah 40%, untuk persentase efisiensi dari pemodelan PLTMH ini adalah 25,5%. Perbandingan torsi berpengaruh terhadap kecepatan putaran kincir yang kurang mampu untuk memutar generator secara maksimal.
The increasing demand for electrical energy in Bali requires additional electrical energy supply, while conventional energy such as petroleum, coal and natural gas continue to be used. Therefore, the utilization of non-conventional energy like solar energy should be increased. One of provision of non-conventional electric energy which is ready to be widely used is using PLTS Photovoltaic technology. The data analysis in this study uses manual calculation method to calculate electric power requirement, setting the result for electrical power, calculating the amount and capacity for solar module and inverter, calculating slope angle and location of solar module. PLTS uses a hybrid system with PLN, which works automatically to be controlled by the inverter control system. PLTS capacity of 148,274 kW supply 30% of the electrical energy consumption in the building of 2,310 MWh.
The dependence of power plants on energy sources such as diesel, natural gas and coal is almost 75%, encouraging the development of renewable energy in an effort to meet the electricity supply. One of them is the micro hydro power plant by utilizing the potential of existing water. The working principle of PLTMH is to change the potential energy of water into electrical energy. In this final project has been designed modeling of micro hydro power plant by using screw turbine (Archimedes Screw). The turbine used resembles a drill bit, with a diameter of a turbine of 26 cm, a screw width of 10 cm, and an amount of 10 pieces of blade. Measurements made on the modeling of micro hydro power plants include: water discharge, turbine rotation, generator rotation, voltage, current, torque and generator output power and efficiency. The parameters are measured by changing the water fall on the turbine from the position of the turbine head angle 00, 100, 150, 200, 250, 300, 350, 400, 450, 500, 550, 600, 700, 800 and 900 . The result of measurement that has been done on the parameters of micro hydro power plant modeling, obtained the highest measurement result at the corner of turbine head 400. The output power generated is 10.92 watts, torque is 0.60 Nm and efficiency of 14%. The results obtained are still low because the turbine rotation is less able to rotate the generator, where the generator torque is greater than the torque in the turbine. This is influenced by the small water discharges in the modeling of this micro hydro power plant.
Indnonesia memiliki banyak potensi energi baik energi konvesional (Non Renewable) maupun energi terbarukan (Renewable Energy). Potensi energi yang kebanyakan digunakan di daerah Indonesia masih menggunakan energi konvesional (Non Renewable) berupa bahan bakar fosil (batu bara, gas alam dan minyak Bumi). Pada saat ini penggunaan energi fosil mencapai 75 % dan akan terus meningkat. Untuk mengurangi penggunaan energi fosil maka dilakukan penelitian-penelitian mengenai energy terbarukan (Non Renewable) seperti. Mikro Hidro. Prinsip kerja Pembangkit Listrik Tenaga Mikro Hidro memanfaatkan energi potensial air yang diubah menjadi energi listrik. Pada penelitian skripsi ini telah dibuat pemodelan pembangkit listik tenaga mikro hidro menggunakan turbin ulir (Archimedean Screw) dengan variasi sudut blade tubrin mulai dari sudut 240, 260,280,300 dan 320. Penelitin ini bertujuan untuk mengetahui pengaruh variasi sudut blade pada turbin Archimedean Screw terhadap output yang dihasilkan. Pengukuran yang dilakukan pada penelitian ini meliputi pengukuran putaran turbin, putaran generator, tegangan, arus dan torsi yang dihasilkan pada pemodelan yang telah dibuat. Dari pengukuran yang telah dilakukan dengan menggunakan beban lampu sebesar 25 Watt didapatkan hasil pengukuran tertinggi pada sudut 280. Pada sudut 280 menghasilkan daya sebesar 10,8 Watt, toris sebesar 0,33 Nm dan effesiensi sebesar 11,6%.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.