Phenol is an important chemical compound since it is a precursor of the industrial production of many materials and useful compounds. Nowadays, phenol is industrially produced from benzene by the multi-step “cumene process”, which is energy consuming due to high temperature and high pressure. Moreover, in the “cumene process”, the highly explosive cumene hydroperoxide is produced as an intermediate. To overcome these disadvantages, it would be useful to develop green alternatives for the synthesis of phenol that are more efficient and environmentally benign. In this regard, great interest is devoted to processes in which the one-step oxidation of benzene to phenol is achieved, thanks to the use of suitable catalysts and oxidant species. This review article discusses the direct oxidation of benzene to phenol in the liquid phase using different catalyst formulations, including homogeneous and heterogeneous catalysts and photocatalysts, and focuses on the reaction mechanisms involved in the selective conversion of benzene to phenol in the liquid phase.

No abstract

No abstract

No abstract

Fe-doped titania photocatalysts (with 1, 2.5, and 3.5 wt. % Fe nominal content), showing photocatalytic activity under visible light, were prepared by a soft-template assisted sol–gel approach in the presence of the triblock copolymer Pluronic P123. An undoped TiO2 photocatalyst was also prepared for comparison. The photocatalysts were characterized by means of X-ray powder Diffraction (XRPD), Quantitative Phase Analysis as obtained by Rietveld refinement, Diffuse Reflectance (DR) UV−Vis spectroscopy, N2 adsorption/desorption at −196 °C, electrophoretic mobility in water (ζ-potential), and X-ray photoelectron spectroscopy (XPS). The physico-chemical characterization showed that all the samples were 100% anatase phase and that iron was present both in the bulk and at the surface of the Fe-doped TiO2. Indeed, the band gap energy (Eg) decreases with the Fe content, with Tauc’s plot determined values ranging from 3.35 (undoped TiO2) to 2.70 eV (3.5 wt. % Fe). Notwithstanding the obtained Eg values, the photocatalytic activity results under visible light highlighted that the optimal Fe content was equal to 2.5 wt. % (Tauc’s plot determined Eg = 2.74 eV). With the optimized photocatalyst and in selected operating conditions, under visible light it was possible to achieve 90% AO7 discoloration together with a TOC removal of 40% after 180 min. The kinetic behavior of the photocatalyst was also analyzed. Moreover, the tests in the presence of three different scavengers revealed that the main reactive species are (positive) holes and superoxide species. Finally, the optimized photocatalyst was also able to degrade phenol under visible light.

No abstract

Different tri-doped TiO2 photocatalysts (Fe-N-P/TiO2, Fe-N-S/TiO2, Fe-Pr-N/TiO2, Pr-N-S/TiO2, and P-N-S/TiO2) were successfully prepared and tested in the photocatalytic removal of thiacloprid (THI) under UV-A, visible, and direct solar light irradiation. The physical-chemical properties of the prepared catalysts were analyzed by different characterization techniques, revealing that dopants are effectively incorporated into the anatase TiO2 lattice, resulting in a decrease of the energy band gap. The reduction of photoluminescence intensity indicates a lower combination rate and longer lifespan of photogenerated carriers of all doped samples in comparison with the un-doped TiO2. The doped photocatalysts not only significantly promote the photodegradation under UV-A light irradiation but also extend the optical response of TiO2 to visible light region, and consequently improve the visible light degradation of THI. Fe-N-P tri-doped TiO2 sample exhibits the highest THI photodegradation degree (64% under UV-A light, 29% under visible light and 73% under solar light).

No abstract