The combination of RuCl2(PPh3)3 and TEMPO affords an efficient catalytic system for the aerobic oxidation of a variety of primary and secondary alcohols, giving the corresponding aldehydes and ketones, in >99% selectivity in all cases. The Ru/TEMPO system displayed a preference for primary vs secondary alcohols. Results from Hammett correlation studies (rho = -0.58) and the primary kinetic isotope effect (kH/kD = 5.1) for the catalytic aerobic benzyl alcohol oxidations are inconsistent with either an oxoruthenium (O=Ru) or an oxoammonium based mechanism. We postulate a hydridometal mechanism, involving a "RuH2(PPh3)3" species as the active catalyst. TEMPO acts as a hydrogen transfer mediator and is either regenerated by oxygen, under catalytic aerobic conditions, or converted to TEMPH under stoichiometric anaerobic conditions.

A series of complexes with [Fe(II)(2)(mu-OH)(2)] cores has been synthesized with N3 and N4 ligands and structurally characterized to serve as models for nonheme diiron(II) sites in enzymes that bind and activate O(2). These complexes react with O(2) in solution via bimolecular rate-limiting steps that differ in rate by 10(3)-fold, depending on ligand denticity and steric hindrance near the diiron center. Low-temperature trapping of a (mu-oxo)(mu-1,2-peroxo)diiron(III) intermediate after O(2) binding requires sufficient steric hindrance around the diiron center and the loss of a proton (presumably that of a hydroxo bridge or a yet unobserved hydroperoxo intermediate). The relative stability of these and other (mu-1,2-peroxo)diiron(III) intermediates suggests that these species may not be on the direct pathway for dioxygen activation.

The reaction of [Fe(II)(beta-BPMCN)(OTf)2] (1, BPMCN = N,N'-bis(2-pyridylmethyl)-N,N'-dimethyl-trans-1,2-diaminocyclohexane) with tBuOOH at low-temperature yields alkylperoxoiron(III) intermediates 2 in CH2Cl2 and 2-NCMe in CH3CN. At -45 degrees C and above, 2-NCMe converts to a pale green species 3 (lambda(max) = 753 nm, epsilon = 280 M(-1) cm(-1)) in 90% yield, identified as [Fe(IV)(O)(BPMCN)(NCCH3)]2+ by comparison to other nonheme [Fe(IV)(O)(L)]2+ complexes. Below -55 degrees C in CH2Cl2, 2 decays instead to form deep turquoise 4 (lambda(max) = 656, 845 nm; epsilon = 4000, 3600 M(-1) cm(-1)), formulated to be an unprecedented alkylperoxoiron(IV) complex [Fe(IV)(BPMCN)(OH)(OOtBu)]2+ on the basis of Mössbauer, EXAFS, resonance Raman, NMR, and mass spectral evidence. The reactivity of 1 with tBuOOH in the two solvents reveals an unexpectedly rich iron(IV) chemistry that can be supported by the BPMCN ligand.

The reaction of [FeII(tpa)(OTf)2] (tpa=tris(2-pyridylmethyl)amine) and its related 5-Me3-tpa complex with hydrogen peroxide affords spectroscopically distinct iron(III)-peroxo intermediates in CH3CN and acetone. The reaction in acetonitrile at -40 degrees C results in the formation of the previously reported Fe(III)-OOH intermediate, the end-on hydroperoxo coordination mode of which is established in this paper by detailed resonance Raman isotope-labeling experiments. On the other hand, the reaction in acetone below -40 degrees C leads to the observation of a different peroxo intermediate identified by resonance Raman spectroscopy to be an FeIII-OOC (CH3)2OH species; this represents the first example of an intermediate derived from the adduct of H2O2 and acetone. The peroxoacetone intermediate decays more rapidly than the corresponding FeIII-OOH species and converts to an FeIV=O species by O-O bond homolysis. This decay process is analogous to that observed for [FeIII(tpa)(OOtBu)]2+ and in fact exhibits a comparable enthalpy of activation of 54(3) kJ mol(-1). Thus, with respect to their physical properties at low temperature, the peroxoacetone intermediate resembles [FeIII(tpa)(OOtBu)]2+ more than the corresponding FeIII-OOH species. At room temperature, however, the behavior of the Fe(tpa)/H2O2 combination in acetone in catalytic hydrocarbon oxidations differs significantly from that of the Fe(tpa)/tBuOOH combination and more closely matches that of the Fe(tpa)/H2O2 combination in CH3CN. Like the latter, the Fe(tpa)/H2O2 combination in acetone catalyzes the hydroxylation of cis-1,2-dimethylcyclohexane to its tertiary alcohol with high stereoselectivity and carries out the epoxidation and cis-dihydroxylation of olefins. These results demonstrate the subtle complexity of the Fe(tpa)/H2O2 reaction surface.