The present study investigates the structural and pharmaceutical properties of different multicomponent crystalline forms of lamotrigine (LTG) with some pharmaceutically acceptable coformers viz. nicotinamide (1), acetamide (2), acetic acid (3), 4-hydroxy-benzoic acid (4) and saccharin (5). The structurally homogeneous phases were characterized in the solid state by DSC/TGA, FT-IR and XRD (powder and single crystal structure analysis) as well as in the solution phase. Forms 1 and 2 were found to be cocrystal hydrate and cocrystal, respectively, while in forms 3, 4 and 5, proton transfer was observed from coformer to drug. The enthalpy of formation of multicomponent crystals from their components was determined from the enthalpy of solution of the cocrystals and the components separately. Higher exothermic values of the enthalpy of formation for molecular complexes 3, 4 and 5 suggest these to be more stable than 1 and 2. The solubility was measured in water as well as in phosphate buffers of varying pH. The salt solvate 3 exhibited the highest solubility of the drug in water as well as in buffers over the pH range 7-3 while the cocrystal hydrate 1 showed the maximum solubility in a buffer of pH 2. A significant lowering of the dosage profile of LTG was observed for 1, 3 and 5 in the animal activity studies on mice.

No abstract

Solid dosage forms are by far the preferred drug delivery systems. However, these often face the problem of poor and erratic bioavailability during the drug development process. Numerous formulation strategies for drug delivery are currently under development, among which the solid forms such as polymorphs, solvates, salts, and cocrystals have been considered to be the most important for improving dissolution rate and bioavailability. Cocrystallization is a fairly new approach in pharmaceutical industry that can improve the solubility and, consequently, the bioactivity of the active pharmaceutical ingredient (API) without compromising its structural integrity. Pharmaceutical cocrystals have found their place in drug delivery, primarily due to their ability to produce alternative, viable solid forms when a more standard approach of salt and polymorph formation fails to deliver the desired objectives. Over the past few years, a number of papers have been published focusing on a broad range of subjects, from traditional crystal engineering to structure-property relationships of cocrystals. The present review, however, illustrates how the cocrystalline forms of APIs have improved their in vitro dissolution rate and in vivo bioavailability, often correlating well with their improved solubility as well.

No abstract

-Purpose:The aim of the work is to study the crystallization of efavirenz to understand the preferential formation of various polymorphic forms, to establish their identity, to study the transformation between the polymorphic forms on heating and to determine their free energy. Methods: Slow crystallization from different solvents under controlled conditions was employed to prepare various crystalline forms. The TGA and DSC were used to study their thermal behavior and inter-conversion of these forms. The calorimetrically determined enthalpies of solution and solubility data are utilized to determine the transition temperatures. Results: Six polymorphic forms of efavirenz are identified and characterized completely. The TGA scans of all the forms did not show any mass loss indicating absence of hydrate or solvate. The thermally induced transformations are observed in the DSC scans of five forms II-VI indicating them to be metastable which are converted to stable higher melting forms. The melting temperature and enthalpy of fusion of lower melting (Form L ) and higher melting forms (Form H ) reveal that four of these polymorphic pairs are monotropically related. The enthalpies of solution of Form L are found to be more exothermic as compared to corresponding Form H . The transition temperature (T t ) determined using enthalpy of solution and solubility data was found to be higher than the melting of both the forms except for polymorphic pair VI L /VI H . The effect of ΔC p on transition temperature is also reported. Conclusions: The form I is found to be thermodymanically most stable but least soluble. The forms II-V are metastable and are converted irreversibly to stable forms. The enthalpy of fusion rule and virtual transition temperature provided complementary evidence for the existence of monotropy in these polymorphic pairs. However, enantiotropy is demonstrated in VI L /VL H pair and is well established in our study. Novelty: The present study reveals the thermodynamic aspects of various isolated polymorphic forms of efavirenz. Solution calorimetry along with other techniques is used to study the transformation of one form to another. The emphasis is laid on determination of transition temperature of various polymorphic pairs which has not been reported earlier.

Investigation of polymorphism and solvatomorphism in drug molecules is an important step in any pre-formulation program from both biopharmaceutical and technological point of view (1, 2). It is well known that polymorphs are different crystalline forms of the same compound whereas the inclusion of a solvent in a crystal lattice gives rise to pseudopolymorphs or solvatomorphs (2). One of the most relevant features among polymorphic modifications is the difference in their solubility and dissolution rate that affect their bioavailability (3-5).In crystal hydrates/solvates, the combination of intermolecular forces (hydrogen bonding) and crystal packing can produce very strong solvent-solid interactions leading to completely new properties in the solid state (6, 7). Some stable solvatomorphs require vigorous conditions for desolvation before melting, while others lose the solvent of crys- Identification and characterization of different forms of methotrexate were carried out by crystallization from different solvents. Five different forms of the drug were obtained. Appearance of a desolvation endotherm in the DSC accompanied by mass loss in TGA for forms I, II, IV and V showed these forms to be acetonitrile solvate hydrate (form I), trihydrate (forms II and IV) and dimethylformamide solvate (form V), respectively. However, the desolvation peak was absent in form III (obtained from methanol) indicating the absence of any solvent of crystallization. This form was found to be partially crystalline by its XRPD pattern. Solution calorimetry was further used to differentiate between the forms as they differ in lattice energy, resulting in different enthalpies of solution. The dissolution and solubility profiles were correlated with the enthalpy of solution and subsequently with crystallinity of all the forms; the least endothermic form (form III) had the highest dissolution rate.

In the present study, four new multicomponent forms of lamotrigine (LTG) with selected carboxylic acids, viz. acetic acid, propionic acid, sorbic acid, and glutaric acid, have been identified. Preliminary solid-state characterization was done by differential scanning calorimetry/thermogravimetric, infrared, and powder X-ray diffraction techniques. X-ray single-crystal structure analysis confirmed the proton transfer, stoichiometry, and the molecular composition, revealing all of these to be a new salt/salt-cocrystal/salt monosolvate monohydrate of LTG. All four compounds exhibited both the aminopyridine dimer of LTG (motif 4) and cation–anion dimers between protonated LTG and the carboxylate anion in their crystal structures. Further, these new crystal forms were subjected to solubility studies in water, powder dissolution studies in 0.1 N HCl, and stability studies under humid conditions in comparison with pure LTG base. The solubility of these compounds in water is significantly enhanced compared with that of pure base, which is attributed to the type of packing motifs present in their crystal structures as well as to the lowering of the pH by the acidic coformers. Solid residues of all forms remaining after solubility and dissolution experiments were also assessed for any transformation in water and acidic medium.

Abstract. The study is aimed at exploring the utility of thermoanalytical methods in the solid-state characterization of various crystalline forms of nevirapine. The different forms obtained by recrystallization of nevirapine from various solvents were identified using differential scanning calorimetry and thermogravimetric analysis (TGA). The appearance of desolvation peak accompanied by weight loss in TGA indicated the formation of solvates: hemi-ethanolate (Form I), hemi-acetonitrilate (Form II), hemichloroformate (Form III), hemi-THF solvate (Form IV), mixed hemi-ethanolate hemi-hydrate (Form V), and hemi-toluenate (Form VI). The higher desolvation temperatures of all the solvates except toluenate than their respective boiling point indicate tighter binding of solvent. Emphasis has been laid on the determination of heat capacity and heat of solution utilizing microreaction calorimeter to further distinguish the various forms. The enthalpy of solution (ΔH sol ), an indirect measure of the lattice energy of a solid, was well correlated with the crystallinity of all the solid forms obtained. The magnitude of ΔH sol was found to be −14.14 kJ/mol for Form I and −2.83 kJ/mol for Form V in phosphate buffer of pH 2, exhibiting maximum ease of molecular release from the lattice in Form I. The heat capacity for solvation (ΔC p ) was found to be positive, providing information about the state of solvent molecules in the host lattice. The solubility and dissolution rate of the forms were also found to be in agreement with their enthalpy of solution. Form (I), being the most exothermic, was found to be the most soluble of all the forms.