No abstract

Poly(N-ethyl-4-vinylpyridinium bromide) (a polycation with a degree of polymerization of 1100) was adsorbed onto liposomes composed of egg lecithin with a 0.05-0.20 molar fraction (nu) of anionic headgroups provided by cardiolipin (a doubly anionic lipid). According to electrophoretic mobility data, this led to total charge neutralization of the liposomes, whereupon the liposomes adopted a positive charge as additional polymer continued to adsorb. Although the liposomes aggregated at the charge-neutralization point, they disassembled into individual liposomes after becoming positively charged. The degree of polymer adsorption was shown to reach a limit. Thus, by measuring the free polymer content in a liposome suspension, it was possible to determine the polymer concentration at which the liposome surface became saturated with polymer. Beyond this point, an electrostatic/steric barrier at the surface suppressed further adsorption. Dynamic light scattering studies of liposomes with and without adsorbed polymer allowed calculation of the polymer film thickness which ranged from 22 to 35 nm as the molar fraction of cardiolipin (nu) increased from 0.05 to 0.20. The greater the content on the anionic lipid in the bilayer, the thicker the polymer film. The maximum number of polymer molecules adsorbed onto the liposomes was estimated: 1-2 molecules for nu = 0.05; 3 molecules for nu = 0.1; 4- molecules for nu = 0.15; and 6 molecules for nu = 0.2. The polymer appears to lie on the liposome surface, rather than embedding into the bilayer, because addition of NaCl easily dislodges the polymer from the liposome into the bulk water.

Cryo-TEM and NaCl-leakage experiments demonstrated that the cationic polymer polylysine induces fusion of anionic liposomes but that the cationic polymer poly(N-ethyl-4-vinylpyridinium bromide) (PEVP) does not, although both polymers bind strongly to the liposomes. The difference was traced to the thickness of the coatings at constant charge coverage. Polylysine is believed to form planar β-sheets that are sufficiently thin to allow membrane fusion. In contrast, looping and disorganization among adsorbed PEVP molecules physically prevent fusion. A similar effect is likely to be applicable to important polycation-induced fusion of cell membranes.

Spherical polycationic brushes (SPBs) were synthesized by grafting polycationic chains onto 100 nm polystyrene particles. These particles were exposed to unilamellar egg-lecithin (EL) liposomes with a mean diameter of 40 nm that had been rendered anionic via the presence of 10 molar% of phosphatidylserine (PS(1-)). The liposomes also contained 30 mole% of a morpholinocyclohexanol-based lipid (MOCH) that undergoes a conformational flip when the pH is decreased from 7.0 to 5.0. Mixtures of SPBs and liposomes at pH 7 gave an electrostatically-driven complex possessing, on average, about 40 liposomes for each SPB particle. It was found that the bound liposomes rapidly release much of their contents when the pH is reduced from 7.0 to 5.0 owing mostly to a MOCH conformational change that creates defects in the bilayer membrane. The drop in pH does not, however, induce a separation of the liposomes from the SPBs. Around 50-60% of the liposome contents escape before, it is reasoned, lateral and transmembrane motion of the membrane components heals the defects and prevents further release. Remarkably, the liposomes complexed with SPB release their cargo much faster than the identical but non-complexed liposomes.

No abstract

No abstract

A spherical polycationic brush (SPB) is made by graft-polymerizing a cationic monomer onto the surface of a 100 nm polystyrene bead. It is possible to adsorb anionic liposomes (40-60 nm diameter) onto the SPBs while maintaining the liposome integrity. The liposomes were constructed with phosphatidyl choline (PC) admixed with 0.05-0.4 mol fraction of an dianionic lipid, cardiolipin (CL(2-)). As shown by electrophoretic mobility measurements, SPB-to-liposome complexation leads to a conversion from the initial positive charge of the copolymer to a negative charge. The higher the CL(2-) content of the liposomes, the lower the concentration needed for charge neutralization. Dynamic light scattering (DLS) revealed that multicomplex aggregates are formed with a maximum size at the SPB/liposome charge-equivalence point. Experiments with fluorescent-labeled liposomes show that at low CL(2-) content about 80 liposomes are adsorbed per SPB. As the mole fraction of CL(2-) increases from 0.05 to 0.4, fewer liposomes adsorb owing to electrostatic repulsion among neighboring liposomes. The effect of added NaCl also depends upon the CL(2-) content. With 0.05 mol fraction CL(2-), the SPB/liposome complex dissociates into its components at 0.15 M NaCl. With a mole fraction of >0.1, complexes fail to dissociate even at 1.2 M NaCl. Additional information about the SPB/liposome morphology was obtained from cryo-TEM. For example, cryo-TEM data confirm liposome integrity upon complexation, a behavior that contrasts with the liposome destruction as found with adsorption to many other types of surfaces.

No abstract