No abstract

[1] The denudational history of a $500 km long transect across the Drakensberg Escarpment on the high-elevation passive margin of SE Africa is quantified on the basis of thermal history modeling of apatite fission track data for 15 deep borehole samples, supplemented by an additional 10 outcrop samples. A minimum of 4.5 km of denudation since formation of the margin $130 Myr ago is estimated for the coastal zone, with a marked Early Cretaceous episode of accelerated denudation broadly coincident with continental breakup. Samples from the Swartberg borehole (SW 1/67) located $30 km seaward of the present position of the Drakensberg Escarpment indicate a total depth of denudation of 3.1 ± 1.2 km since $91 Myr, with a phase of accelerated denudation of 2.1 ± 0.9 km at a mean rate of 95 ± 43 m/Myr between $91 and 69 Myr. Samples from the Ladybrand borehole (LA 1/68) west of the Lesotho Highlands indicate 1.7 ± 0.5 km of denudation since $78 Myr, with a phase of accelerated denudation at 82 ± 43 m/Myr from $78 to 64 Myr. Average denudation rates declined to about 10 m/Myr during much of the Tertiary. Although the apatite fission track data do not provide any direct constraints on the denudational history of the Lesotho Highlands, interpolation between the two boreholes, constrained by geological evidence and extrapolated in situ-produced cosmogenic 36 Cl-derived denudation rate estimates, suggests a pattern of denudation compatible with numerical modeling studies of escarpment evolution involving rapid river incision seaward of a preexisting inland drainage divide. These patterns of denudation are incompatible with constant retreat of the Drakensberg Escarpment from an initial position near the present coast. We suggest that the Drakensberg Escarpment formed by rapid post-breakup river incision seaward of a preexisting drainage divide located just east of the present escarpment location and became pinned at this divide with subsequent retreat rates of only 100-200 m/Myr.

No abstract

No abstract

This study presents structural and 40Ar/39Ar geochronological data from the southern part of the Longmen Shan fold‐and‐thrust belt that forms the eastern margin of the Tibetan Plateau. Investigations focused on hinterland ductile top‐to‐the‐WNW shear deformation, which has been linked previously to late Cenozoic lower crustal flow. Consistent with previous studies, the sense of deformation is mapped as top‐to‐the‐WNW in the Longmen Shan hinterland. The timing of the deformation is constrained by 40Ar/39Ar geochronological data of recrystallized minerals aligned along the shear foliation as Late Cretaceous–earliest Paleogene, thus predating the inferred late Cenozoic crustal flow. This deformation is contemporaneous with SE verging thrusting and loading along the Longmen Shan front, which formed a coeval ~2–3 km thick foredeep sequence along the southwestern margin of the Sichuan Basin. In the context of the regional geology, this tectonic configuration could result from either extrusion of a crustal wedge or back thrust in a duplex. Compared to other orogens, where similar crustal configurations have been reported, it is speculated that the eastern Tibetan Plateau margin acquired thickened crust and highly elevated topography in Late Cretaceous–earliest Paleogene time.

Apatite fission track thermochronologic results from transects across the Basin and Range and Transition Zone provinces in west central Arizona provide constraints on the denudational history and structural framework of the region. Apatite fission track ages decrease from ∼21 to 14 Ma in the Harcuvar Mountains and from ∼16 to 13 Ma in the Buckskin‐Rawhide Mountains in the slip direction (SW ‐ NE) of detachment faults in the lower plates of the metamorphic core complexes. Mean lengths of confined fission tracks from the core complexes are all >14 μm, indicating that the apparent apatite ages record rapid cooling through the apatite partial annealing zone (<110°C) to near‐surface conditions. These data give the time at which progressively deeper parts of the lower plates were drawn up through the apatite annealing zone and suggest that the slip rate on detachment faults in the Whipple tilt domain was ∼7–8 mm/yr. The apatite fission track results also indicate that detachment faulting ended at ∼13–14 Ma in this area and, when they are combined with other thermochronologic data, yield cooling rates of >40°C/m.y. for lower plate rocks. Apparent apatite ages in the Transition Zone province generally increase from ∼25 Ma to ∼100 Ma away from the Basin and Range province. This trend of increasing apatite age is disrupted by faulting as many as seven times at the fronts of major mountain ranges and within valleys between the Weaver Mountains and the Colorado Plateau. Gradients of apatite fission track age and confined track length with elevation in the mountain ranges and in the Phillips‐Kirkland drill hole reveal parts of denuded Mesozoic and Cenozoic apatite partial annealing zones. These paleopartial annealing zone profiles provide a reference datum for preextension reconstructions of fault blocks. The reconstructions indicate that the major faults in the Transition Zone province have relative displacements of >1 km and that offset on them occurred mostly after 25 Ma. These data also indicate that most of the rocks now exposed in the Transition Zone of west central Arizona were not exposed until Miocene time.

The Kenya Rift in central Kenya (between ∼1° and 2° north latitude) is flanked by vast areas of Proterozoic crystalline rock where traditional stratigraphic markers useful for constraining Mesozoic to Recent structures are absent. Apatite fission track age and length data from about 100 samples collected from (1) relief profiles in north‐south trending mountain ranges, and (2) east‐west transects between mountain ranges constrain the structural framework of Cretaceous through Tertiary faulting in these flanking areas. Data from the profiles reveal regionally consistent age/elevation trends characterized by three distinct intervals, of 600 to 1200 m altitude, within which the apatite apparent ages are nearly concordant. The three isochronous age/elevation intervals yield apparent ages of ∼180, ∼115, and ∼65 Ma and record times of cooling starting at ≥220, 140–120, and 70–60 Ma. We interpret the cooling to be related to episodes of relatively rapid denudation separated in time by periods of slower exhumation. The isochronous intervals of crust are regionally consistent and relative offsets between the intervals allow fault displacements and block tilts to be estimated, when used in conjunction with the variation of fission track age and length along the transects. The fault block geometry revealed by the displaced isochronous layers indicates that normal faults related to rifting, with relative displacements >1 km, extend at least 100 km east of the Kenya Rift Valley. The data indicate a consistent direction of block tilting for the segment of the rift studied, which is similar to the asymmetric extension observed for other sections of the East Africa Rift System and other narrow rifts. The regional block faulting in this area probably occurred during early to middle Tertiary time associated with the late stages of extension in the Anza Rift and/or the early stages of extension of the Kenya Rift, in a setting similar to the present morphology of northern Tanzania. Therefore focusing of faulting within a central rift valley in Kenya appears to have followed a phase of regional extension with minor total strain.

We report on new image-analysis techniques that, for the first time, provide a practical solution to the problem of fully automated counting of fission tracks in natural minerals, a long-desired goal in fission-track dating. Specific challenges to be overcome have been the discrimination of fission tracks from non-track defects, polishing scratches, etc.; resolving multiple track overlaps; and reliable identification of small tracks amongst a similarly sized background of surface defects, fluid inclusions, etc. Most previous attempts at automated image analysis have failed in one or more of these tasks. The central component of our system is called ‘coincidence mapping’ and utilizes two images of the same tracks obtained in transmitted and reflected light. The complementary nature of the information in these two images allows a powerful discrimination of true fission tracks from most non-track features. The much smaller average track size in the reflected light image allows the resolution of most track overlaps apparent in transmitted light. The discrimination is achieved by segmenting the two images using a custom-developed thresholding routine and extracting the coincidence of features in the two binary images. The analysis is computationally efficient and takes only a few seconds to complete the processing of images that may contain up to many hundreds of tracks. Preliminary indications are that error rates are about the same as, or better than, those achieved by a human operator using normal counting conditions in transmitted light. The performance is even better at high track densities (>107cm−2) giving the potential for measuring track densities up to an order of magnitude greater than a human operator can count. Automated counting should significantly increase the speed and consistency of analysis and improve data quality in fission-track dating through better counting statistics, increased objectivity and measurement of additional track description parameters that are not currently determined.