[1] The eastern margin of the Tibetan Plateau combines very high relief with almost no Tertiary foreland sedimentation and little evidence of Cenozoic tectonic shortening. While river incision and landscape development at the plateau margin have received significant attention over the last decade, little is known about the Cenozoic development of the adjacent Sichuan Basin. Here we assess the Cenozoic thermal history of this basin using detrital apatite fission track (AFT) and (U-Th)/He techniques and establish the presence of an exhumed AFT paleopartial annealing zone across much of the basin. This observation, combined with stratigraphic and borehole sections and inverse modeling of confined apatite fission tracks, indicates that the strata within the basin have undergone accelerated cooling after $40 Ma, consistent with the widespread erosion of $1 to 4 km of overlying sedimentary material. This regional-scale erosion is most likely a response to changes in the Yangtze River system draining and removing sediment from the basin. The base-level fall associated with this erosion contributed to a relative increase in relief across the Longmen Shan and may have helped drive Miocene-Recent incision and unloading of the plateau margin.

East Tibet preserves broad areas of low relief that occur at elevations >3000 m and are dissected by major strike-slip faults that have been repeatedly reactivated since the late Mesozoic. Apatite fission-track samples from these low-relief, high-elevation surfaces indicate Cretaceous cooling (ca. 90 Ma). Fast rock uplift of the 110 °C isotherm and a fossilized partial annealing zone began in the plateau interior of east Tibet in the Miocene. Low denudation rates in the plateau interior during the Cenozoic, which are constrained by thermal history modeling and a consistency in ages from apatite fission tracks, suggest that dip-slip displacement on faults has been minor. Some localized areas have experienced the effects of structurally enhanced rock uplift and denudation or fault-related hydrothermal reheating. Cooling ages in Eocene sediments deposited on the older plateau surface suggest that rapid denudation occurred from the Miocene to Holocene. Other evidence of significant Ceno zoic denudation comes from river valleys, in particular, the Yalong River valley, where incision was initiated in the Oligocene to Miocene (28-12 Ma). Estimated mean denudation in east Tibet during the Cenozoic was ~1-2 km in the low-relief, high-elevation plateau interior and at least 5 km at the highrelief plateau margin in the Longmen Shan. The region south of the Longmen Shan and the Sichuan Basin was not uplifted with the main Tibetan Plateau in the Miocene, but it has undergone enhanced denudation since the Eocene. Due to an orographic effect, most of the denudation in the east Tibetan Plateau interior has occurred in major river valleys. Incision in the major rivers of the Longman Shan occurred simultaneously and has kept pace with surface uplift that began in the middle-late Miocene (12 Ma), with acceleration of denudation rates in the late Miocene (>5 Ma). on June 1, 2015 gsabulletin.gsapubs.org Downloaded from B Figure 1. (A) Digital elevation model of east Tibet and the Chuan Dian fragment, between the Red River and Garzê-Xianshuihe fault systems. The digital elevation model is overlain with major faults, antiforms, and towns. F-fault; A-antiform. The faults were compiled from Ratschbacher et al.

Abstract. The Iceland Deep Drilling Project research well RN-15/IDDP-2 at Reykjanes, Iceland, reached its target of supercritical conditions at a depth of 4.5 km in January 2017. After only 6 days of heating, the measured bottom hole temperature was 426 °C, and the fluid pressure was 34 MPa. The southern tip of the Reykjanes peninsula is the landward extension of the Mid-Atlantic Ridge in Iceland. Reykjanes is unique among Icelandic geothermal systems in that it is recharged by seawater, which has a critical point of 406 °C at 29.8 MPa. The geologic setting and fluid characteristics at Reykjanes provide a geochemical analog that allows us to investigate the roots of a mid-ocean ridge submarine black smoker hydrothermal system. Drilling began with deepening an existing 2.5 km deep vertical production well (RN-15) to 3 km depth, followed by inclined drilling directed towards the main upflow zone of the system, for a total slant depth of 4659 m ( ∼  4.5 km vertical depth). Total circulation losses of drilling fluid were encountered below 2.5 km, which could not be cured using lost circulation blocking materials or multiple cement jobs. Accordingly, drilling continued to the total depth without return of drill cuttings. Thirteen spot coring attempts were made below 3 km depth. Rocks in the cores are basalts and dolerites with alteration ranging from upper greenschist facies to amphibolite facies, suggesting that formation temperatures at depth exceed 450 °C. High-permeability circulation-fluid loss zones (feed points or feed zones) were detected at multiple depth levels below 3 km depth to bottom. The largest circulation losses (most permeable zones) occurred between the bottom of the casing and 3.4 km depth. Permeable zones encountered below 3.4 km accepted less than 5 % of the injected water. Currently, the project is attempting soft stimulation to increase deep permeability. While it is too early to speculate on the energy potential of this well and its economics, the IDDP-2 is a milestone in the development of geothermal resources and the study of hydrothermal systems. It is the first well that successfully encountered supercritical hydrothermal conditions, with potential high-power output, and in which on-going hydrothermal metamorphism at amphibolite facies conditions can be observed. The next step will be to carry out flow testing and fluid sampling to determine the chemical and thermodynamic properties of the formation fluids.

We describe the lithology and present spatially resolved geochemical analyses of samples from the hydrothermally altered Iceland Deep Drilling Project (IDDP) drill core RN-17B. The 9.3 m long RN-17B core was collected from the seawater-dominated Reykjanes geothermal system, located on the Reykjanes Peninsula, Iceland. The nature of fluids and the location of the Reykjanes geothermal system make it a useful analog for seafloor hydrothermal processes, although there are important differences. The recovery of drill core from the Reykjanes geothermal system, as opposed to drill cuttings, has provided the opportunity to investigate evolving geothermal conditions by utilizing in-situ geochemical techniques in the context of observed paragenetic and spatial relationships of alteration minerals. The RN-17B core was returned from a vertical depth of~2560 m and an in-situ temperature of~345°C. The primary lithologies are basaltic in composition and include hyaloclastite breccia, fine-grained volcanic sandstone, lithic breccia, and crystalline basalt. Primary igneous phases have been entirely pseudomorphed by calcic plagioclase + magnesium hornblende + chlorite + titanite + albitized plagioclase + vein epidote and sulfides. Despite the extensive hydrothermal metasomatism, original textures including hyaloclastite glass shards, lithic clasts, chilled margins, and shell-fragment molds are superbly preserved. Multi-collector LA-ICP-MS strontium isotope ratio ( 87 Sr/ 86 Sr) measurements of vein epidote from the core are consistent with seawater as the dominant recharge fluid. Epidote-hosted fluid inclusion homogenization temperature and freezing point depression measurements suggest that the RN-17B core records cooling through the two-phase boundary for seawater over time to current in-situ measured temperatures. Electron microprobe analyses of hydrothermal hornblende and hydrothermal plagioclase confirm that while alteration is of amphibolite-grade, it is in disequilibrium and the extent of alteration is dependent upon protolith type and water/rock ratio. Alteration in the RN-17B core bares many similarities to that of Type II basalts observed in Mid-Atlantic Ridge samples.