No abstract

There are a wide variety of silica nanoformulations being investigated for biomedical applications. Silica nanoparticles can be produced using a wide variety of synthetic techniques with precise control over their physical and chemical characteristics. Inorganic nanoformulations are often criticized or neglected for their poor tolerance; however, extensive studies into silica nanoparticle biodistributions and toxicology have shown that silica nanoparticles may be well tolerated, and in some case are excreted or are biodegradable. Robust synthetic techniques have allowed silica nanoparticles to be developed for applications such as biomedical imaging contrast agents, ablative therapy sensitizers, and drug delivery vehicles. This review explores the synthetic techniques used to create and modify an assortment of silica nanoformulations, as well as several of the diagnostic and therapeutic applications.

The sensitivities of metallophthalocyanine (MPcs: M = Co, Ni, Cu, Zn, and H(2)) chemiresistors to vapor phase electron donors were examined using 50 nm MPc films deposited on interdigitated electrodes. Sensor responses were measured as changes in current at constant voltage. Analytes were chosen to span a broad range of Lewis base and hydrogen bond base strengths. The MPc sensor responses were correlated exponentially with binding enthalpy. These exponential fits were consistent with the van't Hoff equation and standard free energy relationships. Sensor recovery times were found to depend exponentially on binding enthalpy, in agreement with the Arrhenius equation. Relative sensitivities of all MPcs were compared via two-way ANOVA analysis. Array response patterns were differentiated via linear discriminant analysis, and analyte identification was achieved over a range of concentrations with 95.1% classification accuracy for the strong binding analytes. The ability to distinguish among different analytes, regardless of their concentration, through normalization of the responses to a reference sensor is particularly noteworthy.

The effort to develop earth‐abundant kesterite solar cells has led to an approximate doubling of the power conversion efficiency over the past five years to 12.6%, primarily due to increases in short‐circuit current and fill factor; open‐circuit voltage has resisted similar change, limiting further efficiency improvement. In the present investigation, Auger nanoprobe spectroscopy, X‐ray/ultraviolet photoelectron spectroscopy, and device characterization are used to provide a comprehensive understanding of the role of grain boundaries and interfaces in limiting performance in kesterite‐based devices. High photovoltaic performance is found to correlate with grain boundaries that are Cu‐depleted and enriched with SnOx. The formation of this bulk‐like oxide at grain boundaries with type I band offset provides a unique effective passivation that limits electron‐hole recombination. Building on these new insights, photovoltaic device simulations are performed that show optimized electrostatic designs can compensate for bulk defects, allowing efficiencies closer to the theoretical limit.

The gas sensing behaviors of cobalt phthalocyanine (CoPc) and metal-free phthalocyanine (H2Pc) thin films were investigated with respect to analyte basicity. Chemiresistive sensors were fabricated by deposition of 50 nm thick films on interdigitated gold electrodes via organic molecular beam epitaxy (OMBE). Time-dependent current responses of the films were measured at constant voltage during exposure to analyte vapor doses. The analytes spanned a range of electron donor and hydrogen-bonding strengths. It was found that, when the analyte exceeded a critical base strength, the device responses for CoPc correlated with Lewis basicity, and device responses for H2Pc correlated with hydrogen-bond basicity. This suggests that the analyte-phthalocyanine interaction is dominated by binding to the central cavity of the phthalocyanine with analyte coordination strength governing CoPc sensor responses and analyte hydrogen-bonding ability governing H2Pc sensor responses. The interactions between the phthalocyanine films and analytes were found to follow first-order kinetics. The influence of O2 on the film response was found to significantly affect sensor response and recovery. The increase of resistance generally observed for analyte binding can be attributed to hole destruction in the semiconductor film by oxygen displacement, as well as hole trapping by electron donor ligands.

Adsorption of organic molecules passivates defect states on single-layer MoS2 via charge transfer.

Diagnosing tumors at an early stage when they are easily curable and may not require systemic chemotherapy remains a challenge to clinicians. In order to improve early cancer detection, gas filled hollow boron-doped silica particles have been developed, which can be used for ultrasound-guided breast conservation therapy. The particles are synthesized using a polystyrene template and subsequently calcinated to create hollow, rigid nanoporous microspheres. The microshells are filled with perfluoropentane vapor. Studies were performed in phantoms to optimize particle concentration, injection dose, and the ultrasound settings such as pulse frequency and mechanical index. In vitro studies have shown that these particles can be continuously imaged by US up to 48 min and their signal lifetime persisted for 5 days. These particles could potentially be given by intravenous injection and, in conjunction with contrast-enhanced ultrasound, be utilized as a screening tool to detect smaller breast cancers before they are detectible by traditional mammography.

Hollow hard shell particles of 200 nm and 2 micron diameter with a 10 nm thick porous silica shell have been synthesized using polystyrene templates and a sol–gel process. The template ensures than the hollow particles are monodispersed, while the charged silica surface ensures that they remain suspended in solution for weeks. When filled with perfluorocarbon gas, the particles behave as an efficient contrast agent for colour Doppler ultrasound imaging in human breast tissue. The silica shell provides unique properties compared to conventional soft shell particles employed as ultrasound contrast agents: uniform size control, strong adsorption to tissue and cells immobilizing particles at the tissue injection site, a long imaging lifetime, and a silica surface that can be easily modified with biotargeting ligands or small molecules to adjust the surface charge and polarity.