The use of ceramic foam filters in ductile iron foundries to reduce the number of inclusions that reach the casting has been widely accepted. However, the exact mechanisms contributing to foam filter effectiveness are not yet known; this limits the ability to maximize filter performance and inclusion reduction. The objective of this work is to qualify and quantify the effects of the foam filter structure on inclusion retention. This has been accomplished through the development of a three-dimensional (3-D) mathematical model, based on physical water modeling and mathematical simulations. It was found that the casting rate and inclusion density play minor roles in the capture ratio, while inclusion size is the most influent variable. One mechanism for capturing inclusions involves the direct impact of an inclusion on the web wall and its adhesion after crossing over the liquid film. Two additional mechanisms involve the entrainment of inclusions by buoyancy-lift forces into low-velocity fields and the ulterior adhesion through buoyancy effects. The second mechanism is the entrainment of inclusions into microrecirculating flows; the inclusions remain in these flows for times that exceed the mold filling time. The latter mechanism has limited intensity for inclusions approximately 30 to 100 lm in size. In order to enhance the effects of this mechanism in this range of sizes, the vorticity magnitude in the microfree shear flows in the filter's pores must be increased, through changes in the structure geometry of this device.

No abstract

No abstract

No abstract