Salmorejo is a viscous homogenate based on tomato, olive oil and breadcrumbs commercialised as a “fresh-like” pasteurised–chilled purée. Due to its penetration, dielectric heating by radiofrequency (RF) might improve pasteurisation results of conventional heating (CH). The objective was to validate the pasteurisation temperature (70–100 °C, at 5 °C intervals) for salmorejo processed by RF (operating at 27.12 MHz for 9.08 s) or conventional (for 10.9 s) continuous heating. The main heat-induced changes include: orangeness, flavour homogenisation, loss of freshness, thickening, loss of vitamin C and lipid oxidation. Both CH and RF equivalent treatments allowed a strong reduction of total and sporulated mesophilic microorganisms and an adequate inhibition of the pectin methylesterase, peroxidase and, to a lesser extent, polyphenol oxidase but did not inhibit the polygalacturonase enzyme. Pasteurisation at 80 °C provided a good equilibrium in levels of microbiological and enzymatic inhibition and thermal damage to the product. Increasing this temperature does not improve enzyme inactivation levels and salmorejo may become overheated. A “fresh-like” good-quality salmorejo can be obtained using either conventional or radiofrequency pasteurisers.

Tomato-based processed foods are a key component of modern diets, usually combined with salt and olive oil in different ratios. For the design of radiofrequency (RF) and microwave (MW) heating processes of tomato-based products, it is of importance to know how the content of both ingredients will affect their dielectric properties. Three concentrations of olive oil and salt were studied in a tomato homogenate in triplicate. The dielectric properties were measured from 10 to 3000 MHz and from 10 to 90 °C. Interaction effects were studied using a general linear model. At RF frequencies, the dielectric constant decreased with increasing temperature in samples without added salt, but this tendency was reversed in samples with added salt. The addition of salt and oil increased the frequency at which this reversion occurred. At MW frequencies, the dielectric constant decreased with increasing temperature, salt, and oil content. The loss factor increased with increasing salt content and temperature, except in samples without added salt at 2450 MHz. Penetration depth decreased with increasing frequency and loss factor. Salt and oil contents have a significant effect on the dielectric properties of tomato homogenates and must be considered for the design of dielectric heating processes.

The hydrolysis of levan using compressed hot water for the production of functional fructooligosaccharides (FOSs) was investigated. Levans from Erwinia herbicola (EH) and Halomonas smyrnensis (HS) were characterized using scanning electron microscopy and light scattering techniques, and hydrolyzed using compressed hot water at four temperatures (120, 140, 160, and 180°C). The hydrolysates were analyzed using high‐performance liquid chromatography and electrospray ionization‐mass spectrometry. Levan HS showed a crystalline morphology, whereas levan EH showed an aggregated structure. Both levans had molar masses on the order of 106 g/mol, but levan EH had a smaller radius of gyration, hydrodynamic radius, and intrinsic viscosity. Levan EH hydrolyzed into FOSs at approximately 120°C, whereas levan HS required a temperature of at least 160°C, possibly because of differences in the degree of branching of the two levans. Both samples were degraded to fructose when treated at 180°C.

Dielectric heating is one of the most promising alternatives to conventional thermal treatment of fluid foods. The higher thermal efficiency and better heating uniformity of radio frequency and microwave processes have been proven successful in providing a similar or better bacterial and enzymatic inactivation in liquid and semi-solid foods while improving the sensory and nutritional quality of the fresh product when compared to conventional pasteurization. However, further investigations are necessary to advance scaling up of applications at different frequencies and to better understand heat distribution and energy consumption of industrial dielectric heating operations.

No abstract