Numerical simulations by means of the Monte Carlo method have been performed to study the electrical properties of a two-dimensional composite filled with rodlike particles. The main goal was to study the effect of the alignment of such rods on the anisotropy of its electrical conductivity. A continuous model was used. In this model, the rods have zero-width (i.e., infinite aspect ratio) and they may intersect each other. To involve both the low conductive host matrix and highly conductive fillers (rods) in the consideration, a discretization algorithm based on the use of a supporting mesh was applied. The discretization is equivalent to the substitution of rods with the polyominoes. Once discretized, the Frank-Lobb algorithm was applied to evaluate the electrical conductivity. Our main findings are (i) the alignment of the rods essentially affects the electrical conductivity and its anisotropy, (ii) the discrete nature of computer simulations is crucial. For slightly disordered system, high electrical anisotropy was observed at small filler content, suggesting a method to enable the production of optically transparent and highly anisotropic conducting films.

Four samples of transparent conductive films with different numbers of silver nanorings per unit area were produced. The sheet resistance, transparency, and haze were measured for each sample. Using Monte Carlo simulation, we studied the electrical conductivity of random resistor networks produced by the random deposition of the conducting rings onto the substrate. Both systems of equal-sized rings, and systems with rings of different sizes were simulated. Our simulations demonstrated the linear dependence of the electrical conductivity on the number of rings per unit area. Size dispersity decreased the percolation threshold, but without having any other significant effect on the behavior of the electrical conductance. Analytical estimations obtained for dense systems of equal-sized conductive rings were consistent with the simulations.

The electrical conductivity of two-dimensional films filled with rodlike particles (rods) was simulated by the Monte Carlo method. The main attention has been paid to the investigation of the effect of the rod alignment on the electrical properties of the films. Both continuous and lattice approaches were used. Intersections of particles were forbidden. Our main findings are (i) both models demonstrate similar behaviors, (ii) at low concentration of rods, both approaches lead to the same dependencies of the electrical conductivity on the concentration of the rods, (iii) the alignment of the rods essentially affects the electrical conductivity, (iv) at some concentrations of partially aligned rods, the films may be conducting only in one direction, and (v) the films may simultaneously be both highly transparent and electrically anisotropic.

Using Monte Carlo simulation, we studied the percolation of sticks, i.e. zero-width rods, on a plane paying special attention to the effects of stick alignment and their length dispersity. The stick lengths were distributed in accordance with log-normal distributions, providing a constant mean length with different widths of distribution. Scaling analysis was performed to obtain the percolation thresholds in the thermodynamic limits for all values of the parameters. Greater alignment of the sticks led to increases in the percolation threshold while an increase in length dispersity decreased the percolation threshold. A fitting formula has been proposed for the dependency of the percolation threshold both on stick alignment and on length dispersity.

Using Monte Carlo simulation, we studied the electrical conductance of two-dimensional films. The films consisted of a poorly conductive host matrix and highly conductive rodlike fillers (rods). The rods were of various lengths, obeying a log-normal distribution. They were allowed to be aligned along a given direction. The impacts of the length dispersity and the extent of the rod alignment on the insulator-to-conductor phase transition were studied. Two alternative computational approaches were compared. Within Model I, the films were transformed into resistor networks with regular structures and randomly distributed conductances. Within Model II, the films were transformed into resistor networks with irregular structures but with equal conductivities of the conductors. A comparison of the models evidenced similar behavior in both models when the concentration of fillers exceeded the percolation threshold. However, a fairly fine mesh should be used in Model I to obtain a reasonable estimation of the electrical conductance. The electrical conductance is slightly overestimated in Model I. In anisotropic systems, the length dispersity of fillers has a more pronounced effect on the electrical conductance along the direction of the rod alignment. Some analytical results were obtained: (i) the relationship between the number of fillers per unit area and the transmittance of the films within Model I and (ii) the electrical conductance of the films for dense networks within Model II.

No abstract

We have studied the electrical conductivity of nanoring-based, transparent conductive films, these being promising elements for flexible electronic devices. Both the wire resistance and the junction resistance were taken into account. We have calculated the dependency of the electrical conductivity on the number density of the rings. We have proposed a mean-field approach to estimate the dependency of the electrical conductivity on the main parameters. Comparison of direct computations of the electrical conductivity and the estimates provided by the mean-field approach evidenced the applicability of this approach for those cases where the wire resistance dominates over the junction resistance and where both resistances are of the same order. For these two cases, both the direct computations and the mean-field approach evidenced a linear dependence of the electrical conductivity of the films on the number density of the conductive rings. By contrast, the dependence of the electrical conductivity on the number density of the conductive rings is quadratic when the junction resistance dominates over the wire resistance. In this case, the mean-field approach significantly overestimates the electrical conductivity since the main assumptions underlying this approach are no longer fulfilled.

Using Monte Carlo simulation, we have studied the percolation of discorectangles. Also known as stadiums or two-dimensional spherocylinders, a discorectangle is a rectangle with semicircles at a pair of opposite sides. Scaling analysis was performed to obtain the percolation thresholds in the thermodynamic limits. We found: (i) for the two marginal aspect ratios ε = 1 (disc) and ε → ∞ (stick) the percolation thresholds coincide with known values within the statistical error; (ii) for intermediate values of ε the percolation threshold lies between the percolation thresholds for ellipses and rectangles and approaches the latter as the aspect ratio increases.