The effect of the use of TiO2 nanoparticles in the production of cementitious composites, worldwide already known, represents an area of interest for the development of materials with self-cleaning capacity; antimicrobial, antibacterial, antifungal properties; and to contribute to the reduction of environmental pollution. This paper aims to analyze the influence that TiO2 nanoparticles have on the cementitious matrix regarding hydrophilicity, this being one of the two main parameters of the self-cleaning mechanism. Experimental tests, conducted by using the indirect method of measuring the surface water absorption, indicated that an addition of 3%-6% (relative to the amount of cement) of TiO2 nanoparticles is effective in terms of increasing the surface hydrophilicity of the cementitious composites. An excess of TiO2 nanoparticles in the composite matrix (10% TiO2 nanoparticles relative to the amount of cement) not only does not improve surface performance in terms of hydrophilicity, but also reduces them. However, in practice on a case-by-case basis, an analysis is required regarding the optimal amount of nanoparticles used as an addition in the mix-design of the cementitious materials that are intended to induce the quality of self-cleaning process, depending on the intended use, climate, degree and duration of sunlight, and so on.
All industries produce wastes or byproducts, and if those are not properly managed, they will cause adverse effects on the environment. As the need for steel increases globally, waste from steel processing will also increase. Hazardous waste from steel processing is produced in the form of a coarse, dense aggregate, called steel slag. The aim of this paper is to present the possibility of using steel slag/blast furnace slag in the production of geopolymer concrete and to present the relevant results regarding the influence of this industrial byproduct on the mechanical properties of Geopolymer materials.
The aim of this paper is to propose ecological thermal insulation materials that meet the goals of sustainability but also fulfill the imposed thermal performance requirements. This paper studies new composite materials based on sheep wool from the perspective of thermal conductivity. The composites were prepared using two types of binder: acrylic-polyurethane resin and natural rubber latex, which were applied to the wool fibres through different methods and percentages. Based on the obtained results of thermal conductivity, two types of samples were selected for further analysis, which aimed to determine the microstructure, chemical composition, water absorption, attack of microorganisms, water vapour permeability, hygrothermal adsorption characteristics and sound absorption of the samples. In order to analyse the variation of thermal conductivity, the following parameters were taken into account: thickness, density, type of binder and percentage of binder. Following the obtained results, it was observed that the value of the thermal conductivity of the samples varies between 0.0324 and 0.0436 W/mK. It was found that all the samples prepared and analysed in this study fulfil the national criteria for the thermal performance of thermal insulation material. After conducting the in-depth analysis of the two selected sample types, it was concluded that both materials have good sound absorption characteristics over the considered frequency range. In addition, as it was expected from the natural fibres, the samples had low resistance against the attack of microorganisms and water-related tests.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.