We measured the density and surface tension of 9 bis[(trifluoromethyl)sulfonyl]imide ([Tf(2)N](-))-based and 12 1-methyl-3-octylimidazolium ([C(8)C(1)Im](+))-based ionic liquids (ILs) with the vibrating tube and the pendant drop method, respectively. This comprehensive set of ILs was chosen to probe the influence of the cations and anions on density and surface tension. When the alkyl chain length in the [C(n)C(1)Im][Tf(2)N] series (n = 1, 2, 4, 6, 8, 10, 12) is increased, a decrease in density is observed. The surface tension initially also decreases but reaches a plateau for alkyl chain lengths greater than n = 8. Functionalizing the alkyl chains with ethylene glycol groups results in a higher density as well as a higher surface tension. For the dependence of density and surface tension on the chemical nature of the anion, relations are only found for subgroups of the studied ILs. Density and surface tension values are discussed with respect to intermolecular interactions and surface composition as determined by angle-resolved X-ray photoelectron spectroscopy (ARXPS). The absence of nonvolatile surface-active contaminants was proven by ARXPS.

The density, refractive index, interfacial tension, and viscosity of ionic liquids (ILs) [EMIM][EtSO 4] (1-ethyl-3-methylimidazolium ethylsulfate), [EMIM][NTf 2] (1-ethyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide), [EMIM][N(CN) 2] (1-ethyl-3-methylimidazolium dicyanimide), and [OMA][NTf 2] (trioctylmethylammonium bis(trifluoromethylsulfonyl)imide) were studied in dependence on temperature at atmospheric pressure both by conventional techniques and by surface light scattering (SLS). A vibrating tube densimeter was used for the measurement of density at temperatures from (273.15 to 363.15) K and the results have an expanded uncertainty ( k = 2) of +/-0.02%. Using an Abbe refractometer, the refractive index was measured for temperatures between (283.15 and 313.15) K with an expanded uncertainty ( k = 2) of about +/-0.0005. The interfacial tension was obtained from the pendant drop technique at a temperature of 293.15 K with an expanded uncertainty ( k = 2) of +/-1%. For higher and lower temperatures, the interfacial tension was estimated by an adequate prediction scheme based on the datum at 293.15 K and the temperature dependence of density. For the ILs studied within this work, at a first order approximation, the quantity directly accessible by the SLS technique was the ratio of surface tension to dynamic viscosity. By combining the experimental results of the SLS technique with density and interfacial tension from conventional techniques, the dynamic viscosity could be obtained for temperatures between (273.15 and 333.15) K with an estimated expanded uncertainty ( k = 2) of less than +/-3%. The measured density, refractive index, and viscosity are represented by interpolating expressions with differences between the experimental and calculated values that are comparable with but always smaller than the expanded uncertainties ( k = 2). Besides a comparison with the literature, the influence of structural variations on the thermophysical properties of the ILs is discussed in detail. The viscosities mostly agree with values reported in the literature within the combined estimated expanded uncertainties ( k = 2) of the measurements while our density and interfacial tension data differ by more than +/-1% and +/-5%.

This study reports thermal-conductivity data for a series of [EMIM] (1-ethyl-3-methylimidazolium)-based ionic liquids (ILs) having the anions [NTf 2 ] (bis(trifluoromethylsulfonyl)imide), [OAc] (acetate), [N(CN) 2 ] (dicyanimide), [C(CN) 3 ] (tricyanomethide), [MeOHPO 2 ] (methylphosphonate), [EtSO 4 ] (ethylsulfate), or [OcSO 4 ] (octylsulfate), and in addition for ILs with the [NTf 2 ]-anion having the cations [HMIM] (1-hexyl-3-methylimidazolium), [OMA] (methyltrioctylammonium), or [BBIM] (1,3-dibutylimidazolium). Measurements were performed in the temperature range between (273.15 and 333.15) K by a stationary guarded parallelplate instrument with a total measurement uncertainty of 3 % (k = 2). For all ILs, the temperature dependence of the thermal conductivity can well be represented by a linear equation. While for the [NTf 2 ]-based ILs, a slight increase of the thermal conductivity with increasing molar mass of the cation is found at a given temperature, the [EMIM]-based ILs show a pronounced, approximately linear decrease with increasing molar mass of the different probed anions. Based on the experimental data obtained in this Electronic supplementary material The online version of this article (study, a simple relationship between the thermal conductivity, molar mass, and density is proposed for the prediction of the thermal-conductivity data of ILs. For this, also densities were measured for [EMIM][OAc], [EMIM][C(CN) 3 ], and [HMIM][NTf 2 ].The mean absolute percentage deviation of all thermal-conductivity data for ILs found in the literature from the proposed prediction is about 7 %. This result represents a convenient simplification in the acquisition of thermal conductivity information for the enormous amount of structurally different IL cation/anion combinations available.

The influence of the strength of intermolecular interactions on mass diffusive processes remains poorly understood for mixtures of associative liquids with dissolved gases. For contributing to a fundamental understanding of the interplay between liquid structures and mass diffusivities in such systems, dynamic light scattering, Raman spectroscopy, and molecular dynamics simulations were used in this work. As model systems, binary mixtures consisting of the gases hydrogen, helium, nitrogen, carbon monoxide, or carbon dioxide dissolved in ethanol, 1-hexanol, or 1-decanol were selected. Experiments and simulations were performed at macroscopic thermodynamic equilibrium close to infinite dilution of solute for temperatures between 303 and 423 K. The Fick diffusion coefficients and self-diffusivities of the gas solutes increase with increasing temperature, decreasing alkyl chain length of the 1-alcohols, and decreasing molar mass of the solutes except for helium and hydrogen showing the opposite behavior. The analysis of the liquid structure of the mixtures showed that the fraction of hydrogen-bonded alcohol molecules decreases with increasing alkyl chain length and temperature. From the obtained structure–property relationships, a new correlation was developed to predict mass diffusivities in binary mixtures consisting of n-alkanes or 1-alcohols with dissolved gases close to infinite dilution within 10% on average.

In the present study, dynamic light scattering (DLS) experiments and molecular dynamics (MD) simulations were used for the investigation of the molecular diffusion in binary mixtures of liquids with dissolved gases at macroscopic thermodynamic equilibrium. Model systems based on the n-alkane n-hexane or n-decane with dissolved hydrogen, helium, nitrogen, or carbon monoxide were studied at temperatures between 303 and 423 K and at gas mole fractions below 0.06. With DLS, the relaxation behavior of microscopic equilibrium fluctuations in concentration and temperature is analyzed to determine simultaneously mutual and thermal diffusivity in an absolute way. The present measurements document that even for mole gas fractions of 0.007 and Lewis numbers close to 1, reliable mutual diffusivities with an average expanded uncertainty ( k = 2) of 13% can be obtained. By use of suitable molecular models for the mixture components, the self-diffusion coefficient of the gases was determined by MD simulations with an averaged expanded uncertainty ( k = 2) of 7%. The DLS experiments showed that the thermal diffusivity of the studied systems is not affected by the dissolved gas and agrees with the reference data for the pure n-alkanes. In agreement with theory, mutual diffusivities and self-diffusivities were found to be equal mostly within combined uncertainties at conditions approaching infinite dilution of the gas. Our DLS and MD results, representing the first available data for the present systems, reveal distinctly larger mass diffusivities for mixtures containing hydrogen or helium compared to mixtures containing nitrogen or carbon monoxide. On the basis of the broad range of mass diffusivities of the studied gas-liquid systems covering about 2 orders of magnitude from about 10 to 10 m·s, effects of the solvent and solute properties on the temperature-dependent mass diffusivities are discussed. This contributed to the development of a simple semiempirical correlation for the mass diffusivity of the studied gases dissolved in n-alkanes of varying chain length at infinite dilution as a function of temperature. The generalized expression requiring only information on the kinematic viscosity and molar mass of the pure solvent as well as the molar mass and acentric factor of the solute represents the database from this work and further literature with an absolute average deviation of about 11%.