We use a high resolution nested ocean modelling system forced by synthetic atmospheric gravity waves to investigate Balearic meteotsunami generation, amplification and propagation properties. We determine how meteotsunami amplitude outside and inside of the Balearic port of Ciutadella depends on forcing gravity wave direction, speed and trajectory. We quantify the contributions of We show that faster meteotsunamis propagate over deeper ocean regions, as required by Proudman resonance. We estimate meteotsunami speed under suband supercritical forcing and derive a first order estimate of its magnitude. We show that meteotsunamis, generated by supercritical gravity waves, propagate with a velocity which is equal to an arithmetic mean of the forcing velocity and local barotropic ocean wave speed.
The recent release of consumer-grade dual-frequency receivers sparked scientific interest into use of these cost-efficient devices for high precision positioning and tropospheric delay estimations. Previous analyses with low-cost single-frequency receivers showed promising results for the estimation of Zenith Tropospheric Delays (ZTDs). However, their application is limited by the need to account for the ionospheric delay. In this paper we investigate the potential of a low-cost dual-frequency receiver (U-blox ZED-F9P) in combination with a range of different quality antennas. We show that the receiver itself is very well capable of achieving high-quality ZTD estimations. The limiting factor is the quality of the receiving antenna. To improve the applicability of mass-market antennas, a relative antenna calibration is performed, and new absolute Antenna Exchange Format (ANTEX) entries are created using a geodetic antenna as base. The performance of ZTD estimation with the tested antennas is evaluated, with and without antenna Phase Center Variation (PCV) corrections, using Precise Point Positioning (PPP). Without applying PCVs for the low-cost antennas, the Root Mean Square Errors (RMSE) of the estimated ZTDs are between 15 mm and 24 mm. Using the newly generated PCVs, the RMSE is reduced significantly to about 4 mm, a level that is excellent for meteorological applications. The standard U-blox ANN-MB-00 patch antenna, with a circular ground plane, after correcting the phase pattern yields comparable results (0.47 mm bias and 4.02 mm RMSE) to those from geodetic quality antennas, providing an all-round low-cost solution. The relative antenna calibration method presented in this paper opens the way for wide-spread application of low-cost receiver and antennas.
Dual-frequency Global Navigation Satellite Systems (GNSSs) enable the estimation of Zenith Tropospheric Delay (ZTD) which can be converted to Precipitable Water Vapor (PWV). The density of existing GNSS monitoring networks is insufficient to capture small-scale water vapor variations that are especially important for extreme weather forecasting. A densification with geodetic-grade dual-frequency receivers is not economically feasible. Cost-efficient single-frequency receivers offer a possible alternative. This paper studies the feasibility of using low-cost receivers to increase the density of GNSS networks for retrieval of PWV. We processed one year of GNSS data from an IGS station and two co-located single-frequency stations. Additionally, in another experiment, the Radio Frequency (RF) signal from a geodetic-grade dual-frequency antenna was split to a geodetic receiver and two low-cost receivers. To process the single-frequency observations in Precise Point Positioning (PPP) mode, we apply the Satellite-specific Epoch-differenced Ionospheric Delay (SEID) model using two different reference network configurations of 50–80 km and 200–300 km mean station distances, respectively. Our research setup can distinguish between the antenna, ionospheric interpolation, and software-related impacts on the quality of PWV retrievals. The study shows that single-frequency GNSS receivers can achieve a quality similar to that of geodetic receivers in terms of RMSE for ZTD estimations. We demonstrate that modeling of the ionosphere and the antenna type are the main sources influencing the ZTD precision.
Low-cost dual-frequency receivers and antennas have created opportunities for a wide range of new applications, in regions and disciplines where traditional GNSS equipment is unaffordable. However, the major drawback of using low-cost antenna equipment is that antenna phase patterns are typically poorly defined. Therefore, the noise in tropospheric zenith delay and coordinate time series is increased and systematic errors may occur. Here, we present a field calibration method that fully relies on low-cost solutions. It does not require costly software, uses low-cost equipment (~500 Euros), requires limited specialist expertise, and takes complex processing steps into the cloud. The application is more than just a relative antenna calibration: it is also a means to assess the quality and performance of the antenna, whether this is at a calibration site or directly in the field. We cover PCV calibrations, important for deformation monitoring, GNSS meteorology and positioning, and the computation of PCOs when the absolute position is of interest. The method is made available as an online web service. The performance of the calibration method is presented for a range of antennas of different quality and price in combination with a low-cost dual-frequency receiver. Carrier phase residuals of the low-cost antennas are reduced by 11–34% on L1 and 19–39% on L2, depending on the antenna type and ground plane used. For the cheapest antenna, when using a circular ground plane, the L1 residual is reduced from 3.85 mm before to 3.41 mm after calibration, and for L2 from 5.34 mm to 4.3 mm. The calibration reduces the Median Absolute Deviations (MADs) of the low-cost antennas in the vertical direction using Post Processed Kinematic (PPK) by 20–24%. For the cheapest antenna, the MAD is reduced from 5.6 to 3.8 mm, comparable to a geodetic-grade antenna (3.5 mm MAD). The calibration also has a positive impact on the Precise Point Positioning (PPP) results, delivering more precise results and reducing height biases.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.