We observed and characterized two distinct signals originating from different pools of water protons in solid-state NMR protein samples, namely from crystal water which exchanges polarization with the protein (on the NMR timescale) and is located in the protein-rich fraction at the periphery of the magic-angle spinning (MAS) sample container, and supernatant water located close to the axis of the sample container. The polarization transfer between the water and the protein can be probed by two-dimensional exchange spectroscopy, and we show that the supernatant water does not interact with protein on the timescale of the experiments. The two water pools have different spectroscopic properties, including resonance frequency, longitudinal, transverse and rotating frame relaxation times. The supernatant water can be removed almost completely physically or can be frozen selectively. Both measures lead to an enhancement of the quality factor of the probe circuit, accompanied by an improvement of the experimental signal/noise, and greatly simplify solvent-suppression by substantially reducing the water signal. We also present a tool, which allows filling solid-state NMR sample containers in a more efficient manner, greatly reducing the amount of supernatant water and maximizing signal/noise.

We discuss the optimum experimental conditions to obtain assignment spectra for solid proteins at magic-angle spinning (MAS) frequencies around 100 kHz. We present a systematic examination of the MAS dependence of the amide proton T 2' times and a site-specific comparison of T 2' at 93 kHz versus 60 kHz MAS frequency. A quantitative analysis of transfer efficiencies of building blocks, as they are used for typical 3D experiments, was performed. To do this, we compared dipolar-coupling and J-coupling based transfer steps. The building blocks were then combined into 3D experiments for sequential resonance assignment, where we evaluated signal-to-noise ratio and information content of the different 3D spectra in order to identify the best assignment strategy. Based on this comparison, six experiments were selected to optimally assign the model protein ubiquitin, solely using spectra acquired at 93 kHz MAS. Within 3 days of instrument time, the required spectra were recorded from which the backbone resonances have been assigned to over 96%.

Crystal clear: Preparing solid-state NMR samples that yield high-resolution spectra displaying high sensitivity is time-consuming and complicated. A sample of the 59 kDa protein DnaB, prepared simply by preparative centrifugation, provides spectra that are as good as the ones from carefully grown microcrystals.

No abstract

Dynamic nuclear polarization (DNP) in combination with subsequent dissolution of the sample allows the detection of low-γ nuclei in the solution state with a signal gain of up to tens of thousand times compared to experiments starting from Boltzmann conditions. The long polarization build-up times of typically more than one hour are a drawback of this technique. The combination of dissolution DNP with cross-polarization (CP) in the solid state was shown to have the potential to overcome this disadvantage. In this article we discuss the cross-polarization step under dissolution DNP conditions in more detail. We show that adiabatic half-passage pulses allow us to enhance the CP efficiency in power-limited DNP probes. As a low-power alternative to Hartmann-Hahn CP we also demonstrate the applicability of frequency-swept de- and re-magnetization pulses for polarization transfer via dipolar order. We investigate the implications and restrictions of the common solid-state DNP mechanisms to the DNP-CP technique and apply a spin-thermodynamic model based on the thermal-mixing mechanism. The model allows us to investigate the dynamics of the polarization levels in a system with two nuclear Zeeman reservoirs and explains the enhanced DNP efficiency upon solvent deuteration within a spin-thermodynamic picture.

No abstract

Progress in NMR in general and in biomolecular applications in particular is driven by increasing magnetic-field strengths leading to improved resolution and sensitivity of the NMR spectra. Recently, persistent superconducting magnets at a magnetic field strength (magnetic induction) of 28.2 T corresponding to 1200 MHz proton resonance frequency became commercially available. We present here a collection of high-field NMR spectra of a variety of proteins, including molecular machines, membrane proteins, viral capsids, fibrils and large molecular assemblies. We show this large panel in order to provide an overview over a range of representative systems under study, rather than a single best performing model system. We discuss both carbon-13 and proton-detected experiments, and show that in 13C spectra substantially higher numbers of peaks can be resolved compared to 850 MHz while for 1H spectra the most impressive increase in resolution is observed for aliphatic side-chain resonances.

Magnetic resonance force microscopy is combined with spin-echo spectroscopy to obtain spatially and spectrally resolved NMR signals of micrometer-scale objects. The experimental spatial resolution for the demonstration experiment on a sample consisting of Ba(ClO3)2.H2O and (NH4)2SO4 single crystals is 3.4 microm. The spectral resolution of 3.4 kHz is sample limited. Improvements in resolution and extensions of the method to more than one spatial dimension and to multidimensional spectroscopy are possible.