Abstract. Aerosolized black carbon is monitored worldwide to quantify its impact on air quality and climate. Given its importance, measurements of black carbon mass concentrations must be conducted with instruments operating in quality-checked and ensured conditions to generate data which are reliable and comparable temporally and geographically. In this study, we report the results from the largest characterization and intercomparison of filter-based absorption photometers, the Aethalometer model AE33, belonging to several European monitoring networks. Under controlled laboratory conditions, a total of 23 instruments measured mass concentrations of black carbon from three well-characterized aerosol sources: synthetic soot, nigrosin particles, and ambient air from the urban background of Leipzig, Germany. The objective was to investigate the individual performance of the instruments and their comparability; we analyzed the response of the instruments to the different aerosol sources and the impact caused by the use of obsolete filter materials and the application of maintenance activities. Differences in the instrument-to-instrument variabilities from equivalent black carbon (eBC) concentrations reported at 880 nm were determined before maintenance activities (for soot measurements, average deviation from total least square regression was −2.0 % and the range −16 % to 7 %; for nigrosin measurements, average deviation was 0.4 % and the range −15 % to 17 %), and after they were carried out (for soot measurements, average deviation was −1.0 % and the range −14 % to 8 %; for nigrosin measurements, the average deviation was 0.5 % and the range −12 % to 15 %). The deviations are in most of the cases explained by the type of filter material employed by the instruments, the total particle load on the filter, and the flow calibration. The results of this intercomparison activity show that relatively small unit-to-unit variability of AE33-based particle light absorbing measurements is possible with well-maintained instruments. It is crucial to follow the guidelines for maintenance activities and the use of the proper filter tape in the AE33 to ensure high quality and comparable black carbon (BC) measurements among international observational networks.
Abstract. Residential wood combustion is a widespread practice in Europe with a serious impact on air quality, especially in mountainous areas. While there is a significant number of studies conducted in deep urbanized valleys and basins, little is known about the air pollution processes in rural shallow hollows where around 30 % of the people in mountainous areas across Europe live. We aim to determine the influence of ground temperature inversions on wood combustion aerosol pollution in hilly, rural areas. The study uses Retje karst hollow (Loški Potok, Slovenia) as representative site for mountainous and hilly rural areas in central and southeastern Europe with residential wood combustion. Sampling with a mobile monitoring platform along the hollow was performed in December 2017 and January 2018. The backpack mobile monitoring platform was used for the determination of equivalent black carbon (eBC) and particulate matter (PM) mass concentrations along the hollow. To assure high quality of mobile measurement data, intercomparisons of mobile instruments with reference instruments were performed at two air quality stations during every run. Our study showed that aerosol pollution events in the relief depression were associated with high local emission intensities originating almost entirely from residential wood burning and shallow temperature inversions (58 m on average). The eBC and PM mass concentrations showed stronger associations with the potential temperature gradient (R2 = 0.8) than with any other meteorological parameters taken into account (ambient temperature, relative humidity, wind speed, wind direction and precipitation). The strong association between the potential temperature gradient and pollutant concentrations suggests that even a small number of emission sources (total 243 households in the studied hollow) in similar hilly and mountainous rural areas with frequent temperature inversions can significantly increase the levels of eBC and PM, and deteriorate local air quality. During temperature inversions the measured mean eBC and PM2.5 mass concentrations in the whole hollow were as high as 4.5 ± 2.6 µg m–3 and 48.0 ± 27.7 µg m–3, respectively, which is comparable to larger European urban centres.
Abstract. Residential wood combustion is a widespread practice in Europe with a serious impact on air quality, especially in mountainous areas. While there is a significant number of studies conducted in deep urbanized valleys and basins, little is known about the air pollution processes in rural shallow hollows, where around 30 % of the people in mountainous areas across Europe live. We aim to determine the influence of ground temperature inversions on wood combustion aerosol pollution in hilly, rural areas. The study uses Retje karst hollow (Loški Potok, Slovenia) as a representative site for mountainous and hilly rural areas in central and south-eastern Europe with residential wood combustion. Sampling with a mobile monitoring platform along the hollow was performed in December 2017 and January 2018. The backpack mobile monitoring platform was used for the determination of equivalent black carbon (eBC) and particulate matter (PM) mass concentrations along the hollow. To ensure high quality of mobile measurement data, intercomparisons of mobile instruments with reference instruments were performed at two air quality stations during every run. Our study showed that aerosol pollution events in the relief depression were associated with high local emission intensities originating almost entirely from residential wood burning and shallow temperature inversions (58 m on average). The eBC and PM mass concentrations showed stronger associations with the potential temperature gradient (R2=0.8) than with any other meteorological parameters taken into account (ambient temperature, relative humidity, wind speed, wind direction, and precipitation). The strong association between the potential temperature gradient and pollutant concentrations suggests that even a small number of emission sources (total 243 households in the studied hollow) in similar hilly and mountainous rural areas with frequent temperature inversions can significantly increase the levels of eBC and PM and deteriorate local air quality. During temperature inversions the measured mean eBC and PM2.5 mass concentrations in the whole hollow were as high as 4.5±2.6 and 48.0 ± 27.7 µg m−3, respectively, which is comparable to larger European urban centres.
Abstract. Airborne black carbon particles are monitored in many networks to quantify its impact on air quality and climate. Given its importance, measurements of black carbon mass concentrations must be conducted with instruments operating in a quality checked and assured conditions to generate reliable and comparable data. According to WMO (World Meteorological Organization) and GAW (Global Atmosphere Watch), intercomparisons against a reference instrument are a crucial part of quality controls in measurement activities (WMO, 2016). The WMO-GAW World Calibration Centre for Aerosol Physics (WCCAP) carried out several instrumental comparison and calibration workshops of absorption photometers in the frame of ACTRIS (European Research Infrastructure for the observation of Aerosol, Clouds and Trace Gases) and the COST Action COLOSSAL (Chemical On-Line cOmpoSition and Source Apportionment of fine aerosoL) in January and June 2019. The experiments were conducted to intercompare filter-based particle light absorption photometers, specifically aethalometers AE33 (Magee Scientific), which are operated by research institutions, universities or governmental entities across Europe. The objective was to investigate the individual performance of 23 instruments and their comparability, using synthetic aerosols in a controlled environment and ambient air from the Leipzig urban background. The methodology and results of the intercomparison are presented in this work. The observed instrument-to-instrument variabilities showed differences that were evaluated, before maintenance activities (average deviation from total least square regression: 1.1 %, range: −6 % to 16 %, for soot measurements; average deviation: 0.3 %, range: −14 % to 19 %, for nigrosin measurements), and after they were carried out (average deviation: 0.4 %, range: −8 % to 14 %, for soot measurements; average deviation: 1.1 %, range: −15 % to 11 %, for nigrosin measurements). The deviations are in most of the cases explained by the filter material, the total particles load on the filter, the performance of the flow systems and previous flow check and calibrations carried out with non-calibrated devices. The results of this intensive intercomparison activity show that relatively small unit-to-unit uncertainties of AE33-based particle light absorbing measurements are possible with functioning instruments. It is crucial to follow the guidelines for maintenance activities and the use of the proper filter tape in the AE33 to assure high quality and comparable BC measurements among international observational networks.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.