Drawing is a manufacturing process that consists of indirect deformation by pulling the material through a tool with a conical geometry. The process is usually performed at room temperature (cold forming), so the selection of effective lubricants is critical. If lubrication is inadequate, there is a high risk that both, tool and the manufactured wire, will fail. In this study, annealed AISI 1020 steel rods were drawn and the effectiveness of three different industrial lubricants was tested. During the process, the drawing force values were recorded and used to determine the friction coefficient that developed under each lubrication condition. Numerical simulations were performed to further understand the process. Based on the experimental and numerical results, qualitative and quantitative analysis were performed for each condition. Among the different lubricants used in this study, zinc stearate showed the lowest value for drawing force, 18.8 kN, followed by Lub A and B with values of 20 kN and 20.6 kN, respectively. The numerical models showed excellent approximation to the force values determined in the tests. The values for the coefficient of friction obtained by both the numerical analysis and the empirical model indicate that zinc stearate has the highest lubricating effect among the lubricants focused on this study.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.