No abstract

IntroductionPrevious studies have demonstrated the superior efficacy of a novel aerosol foam formulation of fixed combination calcipotriene 0.005% (Cal) and betamethasone dipropionate 0.064% (BD), compared with the ointment formulation. The aim of this study is to ascertain whether enhanced bioavailability of the active ingredients due to supersaturation and/or occlusive properties can explain the observed greater clinical efficacy.MethodsSolubility and evaporation experiments were conducted to examine the abilities of Cal/BD aerosol foam ingredients to create a supersaturated environment. Optical microscopy, Raman imaging and X-ray powder diffraction were used to examine the physical state of Cal and BD in the formulations after application, and determine whether a supersaturated state remained stable for clinically relevant time periods. In vitro skin penetration and ex vivo biomarker assays were conducted to compare the skin penetration and bioavailability of Cal and BD from the aerosol foam and ointment formulations, respectively. Occlusive properties were examined via transepidermal water loss.ResultsSolubility studies showed that Cal and BD solubility increased with increasing dimethyl ether (DME) content. Both active ingredients are completely dissolved in the final aerosol foam formulation. DME rapidly evaporates after spraying, and the amount was reduced to 0.5% of the initial amount after 2 min. This led to the formation of a supersaturated environment, where Cal and BD crystals were absent for at least 26 h after application. Cal/BD aerosol foam had significantly greater in vitro skin penetration and had increased bioavailability compared with Cal/BD ointment. Both formulations effectively occluded the skin.ConclusionA stable supersaturated solution of Cal/BD in the aerosol foam leads to increased bioavailability and explains the improved clinical effect when compared to the Cal/BD ointment.FundingThe studies included in the paper are all conducted by LEO Pharma A/S or CROs on behalf of LEO Pharma A/S.

Generation of skin distribution profiles and reliable determination of drug molecule concentration in the target region are crucial during the development process of topical products for treatment of skin diseases like psoriasis and atopic dermatitis. Imaging techniques like mass spectrometric imaging (MSI) offer sufficient spatial resolution to generate meaningful distribution profiles of a drug molecule across a skin section. In this study, we use matrix-assisted laser desorption/ionization mass spectrometry imaging (MALDI-MSI) to generate quantitative skin distribution profiles based on tissue extinction coefficient (TEC) determinations of four different molecules in cross sections of human skin explants after topical administration. The four drug molecules: roflumilast, tofacitinib, ruxolitinib, and LEO 29102 have different physicochemical properties. In addition, tofacitinib was administrated in two different formulations. The study reveals that with MALDI-MSI, we were able to observe differences in penetration profiles for both the four drug molecules and the two formulations and thereby demonstrate its applicability as a screening tool when developing a topical drug product. Furthermore, the study reveals that the sensitivity of the MALDI-MSI techniques appears to be inversely correlated to the drug molecules' ability to bind to the surrounding tissues, which can be estimated by their Log D values. Graphical abstract.

Abstract. Camptothecin (CPT), a potent antitumor drug, exhibits poor aqueous solubility and rapid conversion from the pharmacologically active lactone form to inactive carboxylate form at physiological pH. Solid dispersion of CPT in Soluplus®, an amphiphilic polymeric solubilizer, was prepared to increase the aqueous solubility of CPT and the resultant solid dispersion along with citric acid was formulated as hard gelatin capsules that were subsequently coated with Eudragit S100 polymer for colonic delivery. FTIR spectrum of the solid dispersion confirmed the presence of CPT. PXRD and DSC revealed the semicrystalline nature of solid dispersion. The solubility of the drug was found to increase~40 times in the presence of Soluplus and~75 times in solid dispersion. The capsules showed no drug release in 0.01 N HCl but released 86.4% drug in lactone form in phosphate buffer (pH 7.4) and the result appears to be due to citric acid-induced lowering of pH of buffer from 7.4 to 6.0. Thus the presence of citric acid in the formulation led to stabilization of the drug in its pharmacologically active lactone form. Cytotoxicity studies conducted with the formulation of solid dispersion with citric acid, utilizing cell cytotoxicity test (MTT test) on Caco-2 cells, confirmed cytotoxic nature of the formulation.

Topically applied ingenol mebutate (IngMeb) is approved for field-treatment of actinic keratosis and is currently being investigated for treatment of non-melanoma skin cancer (NMSC). Ablative fractional lasers (AFXLs) generate microscopic ablation zones (MAZs) in the skin, which may help induce a deep penetration needed for effective treatment of NMSC. Using Franz diffusion cells, uptake and bio-distribution were investigated over 21 h in intact (n = 9) and AFXL-exposed porcine skin (n = 58). A 2940-nm fractional Er:YAG laser generated intraepidermal (11.2 mJ/MAZ; 66 μm deep, 177 μm wide) and intradermal (128 mJ/MAZ; 570 μm deep, 262 wide) MAZ's with 16, 97, and 195 MAZs/cm(2). Surface ablation densities corresponded to 0.5, 2.5, and 5 % for intraepidermal MAZs, and corresponded to 1, 5, and 10.5 % for intradermal MAZs. Liquid-chromatography-mass-spectrometry quantified deposition of IngMeb in stratum corneum, epidermis, dermis, and receiver chamber. In intact skin, IngMeb readily penetrated to the epidermal layer (1,314 ng, 41 % of the applied IngMeb), while dermal deposition was limited (508 ng, 16 %). In AFXL-exposed skin, a profound dermal deposition of IngMeb was achieved, while less accumulated in SC and epidermis. Uptake depended entirely on laser density; increasing coverage from 0 % to 0.5 %, 1 %, 2.5 %, 5 %, and 10.5 % enhanced dermal uptake 1.6-, 2.1-, 3.1-, 3.4-, and 3.9-fold, respectively (p < 0.0001). Channel depth did not influence drug uptake; at 5 % density, dermal deposition with intraepidermal and intradermal MAZs was analogous (1801 vs. 1744; p = 0.447). In conclusion, IngMeb readily distributes to superficial layers of intact skin, whereas dermal uptake is limited. Independent of channel depth, AFXL enhances dermal drug deposition, providing for customized topical delivery and potential use of IngMeb for treatment of NMSC.

No abstract

Study of skin penetration and distribution of the drug compounds in the skin is a major challenge in the development of topical drug products for treatment of skin diseases. It is crucial to have fast and efficacious screening methods which can provide information concerning the skin penetration and the distribution of the drug molecules in the region of the target. Mass spectrometry imaging (MSI) such as matrix-assisted laser desorption/ionization (MALDI)-MSI offers the opportunity to analyze the drug distribution at micrometer scale, but is a low throughput technique. Cassette dosing of drug molecules has been widely used for two decades as a high throughput screening tool for plasma pharmacokinetic analysis. The purpose of this study is to evaluate the utility of combining MALDI-MSI with cassette dosing to obtain a medium throughput screening technique for drug distribution in the skin directly from thin tissue sections. Excised fresh human skin was treated with two different formulation types containing both single drugs and a cassette with four drugs. Biopsies were taken and analyzed with traditional UHPLC-MS/MS and MALDI-MSI. The results reveal that skin penetration data of the four drugs administered together were in agreement with skin penetration data obtained when the molecules were administered individually. Furthermore, the MALDI-MSI data reveal different distribution profiles of the four drugs which were not possible to deduce from the UHPLC-MS/MS bioanalysis. These findings suggest that combination of MALDI-MSI and cassette dosing can be used as a medium throughput screening tool at an early stage in the drug discovery/development process. Graphical abstract Investigation of drug distribution in human skin explant by MALDI-MSI after cassette dosing.

The aim of the present study was to prepare valdecoxib, a cyclo-oxygenase-2 enzyme inhibitor, as a loaded multiparticulate system to achieve site-specific drug delivery to colorectal tumors. Film coating was done with the pH-sensitive polymer Eudragit S100 and sodium alginate was used as mucoadhesive polymer in the core. The microspheres were characterized by X-ray diffraction, differential scanning calorimetry, and Fourier transform infrared spectroscopy and were evaluated for particle size, drug load, in vitro drug release, release kinetics, accelerated stability, and extent of mucoadhesion. The coated microspheres released the drug at pH 7.4, the putative parameter for colonic delivery. When applied to the mucosal surface of freshly excised goat colon, microspheres pretreated with phosphate buffer pH 7.4 for 30 minutes showed mucoadhesion. To ascertain the effect of valdecoxib on the viability of Caco-2 cells, the 3-(4,5-dimethylthiazol-2yl) 2,5-diphenyltetrazolium bromide) test was conducted using both valdecoxib and coated microspheres. In both cases, the percentage of dehydrogenase activity indicated a lack of toxicity against Caco-2 cells in the tested concentration range. Drug transport studies of the drug as well as the coated microspheres in buffers of pH 6 and 7.4 across Caco-2 cell monolayers were conducted. The microspheres were found to exhibit slower and delayed drug release and lower intracellular concentration of valdecoxib.