In the past few years, several protocols have been reported on the synthesis of CdSe nanoplatelets with narrow photoluminescence (PL) spectrum, high PL quantum efficiency, and short exciton lifetime. The corresponding core/shell nanoplatelets are however still mostly based on CdSe/CdS, which possess an extended lifetime and a strong red shift of the band-edge absorption and emission, in accordance with a quasi-type-II band alignment. Here we report on a robust synthesis procedure to grow a ZnS shell around CdSe nanoplatelets at moderate temperatures of 100–150 °C, to improve the optical properties of CdSe nanoplatelets via a type-I core/shell heterostructure. The shell growth is performed under ambient atmosphere, in either toluene or 1,2-dichlorobenzene. The variation of the shell thickness induces a continuous red shift of the PL peak, eventually reaching 611 nm. The PL quantum efficiency is increased compared to the original CdSe cores, with values up to 60% depending on the shell thickness. High-resolution transmission electron microscopy reveals a bending of the nanoplatelets caused by strain due to 12% lattice mismatch between CdSe and ZnS. The present procedure can easily be translated to other core/shell nanocrystals, such as CdSe/CdS and CdSe/CdZnS nanoplatelets.

The lateral dimensions of CdSe nanoplatelets have a strong and unique influence on their opto-electronic properties, with sizes that can be tuned from the weak to the strong exciton confinement regime. There are state-of-the-art reports on several nanoplatelet syntheses; however, at present only the thickness is well-controlled. We demonstrate here that we can achieve a control over the aspect ratio and overall nanoplate area by carefully adjusting the reagents that induce the in-plane growth. A variation of the fraction of hydrated Cd(OAc) in a Cd(OAc)/Cd(OAc)·2HO mixture tailors the nanoplatelet aspect ratio. This occurs independently of the reaction time, which can be used to fine-tune the overall length and width. An interpretation is given by the in situ formation of a small amount of hydroxide anions that alter the surface energy of specific planes.

Two dimensional (2D) colloidal PbS nanoplatelets (NPLs) with a thickness of 1.8–2.8 nm have been synthesized using a single-molecule precursor approach with lead octadecylxanthate. The lateral dimensions were tuned by varying the reaction temperature, growth time, and capping ligands. Transmission electron microscopy and X-ray diffraction reveal that the NPLs have an orthorhombic crystal structure rather than the rocksalt phase usually reported for bulk and nanostructured PbS. The 1.8 nm thickness, in combination with the tunable lateral dimensions, results in a blue-shifted absorption peak at 715–730 nm and a 48–68 nm narrow emission spectrum with a surprisingly small, 18 nm Stokes shift at room temperature. The fluorescence lifetime of these PbS NPLs is 2 orders of magnitude shorter than the typical lifetime in 0D colloidal PbS quantum dots, highlighting the advantageous properties of colloidal 2D nanostructures that combine strong transversal with weak lateral confinement.

Colloidal two-dimensional (2D) nanoplatelet heterostructures are particularly interesting as they combine strong confinement of excitons in 2D materials with a wide range of possible semiconductor junctions due to a template-free, solution-based growth. Here, we present the synthesis of a ternary 2D architecture consisting of a core of CdSe, laterally encapsulated by a type-I barrier of CdS, and finally a type-II outer layer of CdTe as so-called crown. The CdS acts as a tunneling barrier between CdSe- and CdTe-localized hole states, and through strain at the CdS/CdTe interface, it can induce a shallow electron barrier for CdTe-localized electrons as well. Consequently, next to an extended fluorescence lifetime, the barrier also yields emission from CdSe and CdTe direct transitions. The core/barrier/crown configuration further enables two-photon fluorescence upconversion and, due to a high nonlinear absorption cross section, even allows to upconvert three near-infrared photons into a single green photon. These results demonstrate the capability of 2D heterostructured nanoplatelets to combine weak and strong confinement regimes to engineer their optoelectronic properties.

The surface of nominally diamagnetic colloidal CdSe nanoplatelets can demonstrate paramagnetism owing to the uncompensated spins of dangling bonds (DBSs). We reveal that by optical spectroscopy in high magnetic fields up to 15 Tesla using the exciton spin as probe of the surface magnetism. The strongly nonlinear magnetic field dependence of the circular polarization of the exciton emission is determined by the DBS and exciton spin polarization as well as by the spin-dependent recombination of dark excitons. The sign of the exciton-DBS exchange interaction can be adjusted by the nanoplatelet growth conditions.

Using multiband k·p calculations, we show that strain-engineered piezoelectricity is a powerful tool to modulate the electron-hole spatial separation in a wide class of wurtzite CdSe/CdS nanocrystals. The inherent anisotropy of the hexagonal crystal structure leads to anisotropic strain and, consequently, to a pronounced piezoelectric field along the c axis, which can be amplified or quenched through a proper design of the core-shell structure. The use of large cores and thick shells promotes a gradual departure from quantum confined nanocrystals to a regime dominated by piezoelectric confinement. This allows excitons to evolve from the usual type-I and quasi-type-II behavior to a type-II behavior in dot-in-dots, dot-in-rods, rod-in-rods, and dot-in-plates. Piezoelectric fields explain experimental observations for giant-shell nanocrystals, whose time-resolved photoluminescence reveals long exciton lifetimes for large cores, contrary to the expectations of standard quantum confinement models. They also explain the large differences in exciton lifetimes reported for different classes of CdSe/CdS nanocrystals.

Colloidal nanocrystals (NCs) are attractive materials for light-emitting applications thanks to their flexible synthesis, size-dependent properties, and bright emission. Yet, colloidal NCs still present a narrow gain band (full-width halfmaximum around 10 nm), which limits their application to single-color lasers. Widening of the gain band by specifically engineered NCs can further improve the prospect of this class of materials toward the fabrication of solution-processed white-emitting or color-tunable lasers. Here, we report broadband amplified spontaneous emission (ASE) from wurtzite CdSe/CdS "giant-shell" nanocrystals (g-NCs) with an unprecedented large core up to 7.5 nm in diameter that were synthesized through a continuous injection route. The combination of large core and shell enables ASE from different CdSe optical transitions as well as from the CdS. Importantly, thin films of g-NCs with a large CdSe core (7.5 and 5.1 nm in diameter) show ASE at different colors with a similar threshold, indicating that light emission amplification can be achieved from different optical transitions simultaneously. Tuning of the core diameter allows obtaining ASE in a wide spectral range, and blending of g-NCs with different core sizes gives rise to a continuous amplified spontaneous emission band from green to red (510 to 650 nm). Drop-cast films of CdSe/CdS g-NCs demonstrate simultaneous dual-color random lasing under nanosecond-pulsed excitation.

† Electronic Supplementary Information (ESI) available: XPS analysis of GO and rGO; Functionalization of the (r)GO; XPS analysis of ATP and ABA functionalized (r)GO and TEM images of the QD coupling results; Estimation of the density of PbS QDs on the (r)GO sheets; Complementary control experiments: Fluorescence spectroscopy characterization of MUA-capped PbS QDs and effect of EtOH washing; Raman characterization; and PL dynamics in core-shell PbS/CdS QDs and silane-f-(r)GO hybrid materials. SeeQuantum dot -graphene hybrid materials have raised significant interest due to the unique synergy of the optical properties of colloidal quantum dots (QDs) and the transport properties of graphene. This stimulated the development of low-cost and up-scalable solution-processed strategies for hybrid materials with potential application in light harvesting and opto-electronic devices. Here we report a versatile covalent-linking based approach for the functionalization of reduced graphene oxide (rGO), to prepare a variety of QD-rGO hybrid dispersions with QDs of different size and composition (PbS, PbS/CdS and CdSe QDs), and shape (CdSe/CdS dot-in-rods). We achieved a well-controlled QD coverage of the rGO sheets by functionalizing the rGO surface with mercapto-silane linkers. A further spectroscopic investigation of near-infrared PbS QD-rGO materials demonstrates efficient electronic coupling between both materials. The QD photoluminescence emission quenching and exciton lifetime shortening up to 95%, together with subtle graphene Raman G-band shifts upon QD linking, supports electron transfer as the dominant relaxation pathway from the QD to the rGO. The use of core/shell PbS/CdS QDs allows tuning of the transfer efficiency from 94% for a 0.2 nm thin CdS shell, down to 30% for a 1.1 nm thick shell.