This review presents the concepts involved in determining the density of foodstuffs, and summarizes the volumetric determination techniques used to calculate true density and apparent density in foodstuffs exposed to the drying process. The behavior of density with respect to moisture content (X) and drying temperature (T) is presented and explained with a basis in changes in structure, conformation, chemical composition, and second-order phase changes that occur in the processes of mass and heat transport, as reported to date in the literature. A review of the empirical and theoretical equations that represent density is presented, and their application in foodstuffs is discussed. This review also addresses cases with nonideal density behavior, including variations in ρ s and ρ w as a function of the inside temperature of the material, depending on drying conditions (X, T). A compilation of studies regarding the density of dehydrated foodstuffs is also presented.

No abstract

The distribution of turbulent kinetic energy (TKE), temperature, and velocity of humid air inside the greenhouse solar dryer (GHSD) was numerically investigated using 3D CFD ANSYS FLUENT code. The effect of solar radiation was coupled with the energy equations using the discrete ordinate model. Numerical simulations were based on two geometric models: Real model and model with reduced height, the solution was in good agreement with experimental data of temperature. The results of the real model showed that the TKE is ranged between 1.27 m2/s2 and 6 m2/s2 with an average of about 1.6 m2/s2 for the entire greenhouse dryer (GHD) volume. The greatest TKE magnitude is in the paths of the diffusers, which caused a temperature drop of about 2 K in the areas near the walls. Consequently, almost homogeneous temperature distribution was obtained in the entire volume of the GHD, although the average temperature was 315 K, and a gradient with respect to ambient temperature was of 14 K, that is, suitable for drying. Also, the average air velocity at 1 m height was 0.71 m/s, which is a value near the lowest limit (0.6 m/s) of forced convection drying. The improvement in the GHD by 36.5% volume reduction allowed an increase in the average TKE of 3.8 m2/s2 (2.4 times more than the previous one) located in the middle of the greenhouse; the average temperature reached 316.5 K with a gradient of 15.5 K, which represents an increase of 1.5 K (11%) compared to the real geometric model. The air velocity at 1 m height increased to 0.9 m/s in the improved geometric model (a growth of 35.7% compared with the previous geometry). More than 95% of the improved GHD volume has a uniform temperature, which is very suitable for a good quality drying process with higher speed.

No abstract

No abstract

No abstract

No abstract

No abstract