Recent models support the view that the Pyrenees were formed after the inversion of a previously highly extended continental crust that included exhumed upper mantle rocks. Mantle rocks remain near to the surface after compression and mountain building, covered by the latest Cretaceous to Paleogene sequences. 3‐D lithospheric‐scale gravity inversion demands the presence of a high‐density mantle body placed within the crust in order to justify the observed anomalies. Exhumed mantle, having ~50 km of maximum width, continuously extends beneath the Basque‐Cantabrian Basin and along the northern side of the Pyrenees. The association of this body with rift, postrift, and inversion structural geometries is tested in a balanced cross section across the Basque‐Cantabrian Basin that incorporates a major south‐dipping ramp‐flat‐ramp extensional detachment active between Valanginian and early Cenomanian times. Results indicate that horizontal extension progressed ~48 km at variable strain rates that increased from 1 to ~4 mm/yr in middle Albian times. Low‐strength Triassic Keuper evaporites and mudstones above the basement favor the decoupling of the cover with formation of minibasins, expulsion rollovers, and diapirs. The inversion of the extensional system is accommodated by doubly verging basement thrusts due to the reactivation of the former basin bounding faults in Eocene‐Oligocene times. Total shortening is estimated in ~34 km and produced the partial subduction of the continental lithosphere beneath the two sides of the exhumed mantle. Obtained results help to pinpoint the original architecture of the North Iberian Margin and the evolution of the hyperextended aborted intracontinental basins.

No abstract

No abstract

[1] The Atlas Mountains are characterized by high elevations and Quaternary volcanism. Long period magnetotelluric data acquired along a NNW-SSE transect reveal the presence of a conductive anomalous mantle below the High Atlas. Data dimensionality analyses show a preferent N80°E strike of the deep resistivity structure in agreement with the induction vector alignment at long periods. Accordingly, a 2D inversion of the data set was carried out. Large resistive bodies at the crustal basement most likely correspond to batholiths emplaced in more conductive metapelites. They are covered by outcropping conductive sedimentary detritic and carbonate rocks. Lithospheric thinning producing anomalous mantle and basin development in the Atlas probably started during Triassic-Jurassic rifting. Inversion tectonics since the Oligocene produced low shortening on previous lithospheric weak zones, with thrusting of the Atlas above the stable African plate. Melting at the top of the anomalous mantle is connected with Quaternary basaltic volcanism in the Middle Atlas.

Critical gravity and magnetic data suggest the presence of a continuous zigzag exhumed mantle body inside the attenuated crust of the north Iberia continental margin. We propose that this body greatly conditioned the structural domains of the Cantabrian–Pyrenean fold-and-thrust belt during their evolution from hyperextension in Early Cretaceous times to shortening and inversion during the Cenozoic. This may be seen as a new line for cross-section construction and balancing, because previous cross-sections do not incorporate comparable volumes of exhumed mantle. Five structural cross-sections, constrained by the results of 3D gravity inversion, feed our discussion of the complexities of the doubly vergent Pyrenean orogen in view of the inversion of a precursor hyperextended rifted margin. In all sections, crustal rocks underthrust the lithospheric mantle in the hyperextended region, supporting that the near-surface exhumed mantle lithosphere acts as a more rigid buttress, allowing weaker continental material to be expelled outwards and upwards by thrusting during the Alpine collision; thus giving rise to two uplifted crustal triangular zones at the boundaries with the exhumed mantle. Contractional slip is localized in lithospheric-scale thrusts, which in turn reactivate parts of the extensional system. The NE–SW transfer zones that offset the rift therefore behave as compartmental faults during the orogenic phase. The amount of shortening increases from 34 km in the Cantabrian Cordillera, where the Basque–Cantabrian Basin partially preserves its original extensional geometry, to 135 km in the nappe stack of the central Pyrenees.

[1] We analyze focal mechanisms of shallow-intermediate earthquakes in a NW-SE transect along the western Betic Cordillera and Alboran Sea, and deep earthquakes located in the central Betics to constrain the state of stress at the Gibraltar Arc slow convergence area. Shallow earthquakes (<40 km) are preferably clustered at the mountain front. A general NW-SE horizontal compression is compatible with the convergence, and NW plunging compression axes are in agreement with frontal thrust activity. Toward the Alboran Sea the earthquakes are progressively deeper, reaching intermediate depths (40-120 km) near the coast and supporting the present-day activity of subduction only in this area. The Iberian continental crust concentrates most of the intermediate seismicity and is forced to partially sink into the mantle, probably through the pull of the oceanic slab. This downdip pull together with the buoyancy of the Iberian continental crust produces the slab curvature, downdip extension in the external arc of the continental slab, and downdip compression in the inner arc. T axes highly dipping to the southeast at 90-120 km depth occur at the oceanic/ continental transition. Deep earthquakes (>620 km) show very similar focal mechanisms, fitting the general slab behavior of resistance to further descent at the 660 km discontinuity. Seismicity features evidence the present-day stress distribution in a context of transition from subduction to continental collision.

No abstract

No abstract